Indirect identification method of bilinear interface laws for FRP bonded on a concrete substrate

Journal of Composites for Construction

Volumn 16, Issue 2, 2012, Pages 171-184

  Bilotta, A ^a   Faella, C ^b   Martinelli, E ^b   Nigro, E ^a  

^a UNIVERSITY OF NAPLES FEDERICO II   (Italy)

^b UNIVERSITY OF SALERNO   (Italy)

Author keywords

Bond law; External strengthening; FRP; Interface; Plate; Sheet

Indexed keywords

BOND LAW; BOND-SLIP LAWS; BOND-SLIP MODELS; BOND-SLIP RELATIONSHIP; CONCRETE SUBSTRATES; DEBONDING STRENGTH; EXTERNALLY BONDED; FIBER REINFORCED POLYMERS; FRACTURE PROCESS; FRP; FRP PLATES; FRP SHEET; FUNDAMENTAL PARAMETERS; IDENTIFICATION PROCEDURE; INDIRECT IDENTIFICATION; MECHANICAL RESPONSE; MODE II; PLATE; PULL-OUT TEST; RC BEAMS; RC MEMBER; REINFORCED CONCRETE BEAMS; SHEET; THEORETICAL FORMULATION;

CONCRETE BEAMS AND GIRDERS; DEBONDING; FIBER REINFORCED PLASTICS; REINFORCED CONCRETE;

INTERFACES (MATERIALS);

EID: 84863510702     PISSN: 10900268     EISSN: None     Source Type: Journal    
DOI: 10.1061/(ASCE)CC.1943-5614.0000253     Document Type: Article

References (40)

1. Aiello, M. A., and Leone, M. (2005). Experimental bond analysis of concrete-FRP (fiber reinforced polymer) reinforced. Proc. FIB Symp. Keep Concrete Attractive, Balasz, and, Borosnyoi, eds., Budapest, Hungary
2. Bilotta, A., Di Ludovico, M., and Nigro, E. (2009 a). Influence of effective bond length on FRP-concrete debonding under monotonic and cyclic actions. Proc. 9th Int. Symp. on Fiber Reinforced Polymer Reinforcement for Concrete Structures, Oehlers, Griffith, and, Seracino, eds., Adelaide, Australia
3. Bilotta, A., Di Ludovico, M., and Nigro, E. (2009 b). FRP debonding on concrete members. Part I: experimental investigation. Proc. 9th Int. Symp. on Fiber Reinforced Polymer Reinforcement for Concrete Structures, Oehlers, Griffith, and, Seracino, eds., Adelaide, Australia
4. Bilotta, A., Di Ludovico, M., and Nigro, E. (2009 c). FRP debonding on concrete members. Part II: Capacity model calibration. Proc. 9th Int. Symp. on Fiber Reinforced Polymer Reinforcement for Concrete Structures, Oehlers, Griffith, and, Seracino, eds., Adelaide, Australia
5. Bilotta, A., Ceroni, F., Nigro, E., Di Ludovico, M., Pecce, M. R., and Manfredi, G. (2011). Bond efficiency of EBR and NSM FRP systems for strengthening of concrete members. J. Compos. Construc. 1090-0268, in press. 10.1061/(ASCE)CC.1943-5614.0000204
6. Brosens, K., and van Gemert, D (1997). Anchoring stresses between concrete and carbon fiber reinforced laminates. Proc. 3rd Int. Symp. on Non-metallic (FRP) Reinforcement for Concrete Structures, Vol. 1, Japan Concrete Institute, Tokyo, Japan, 271-278.
7. Brosens, K. (2001). Anchorage of externally bonded steel plates and CFRP laminates for the strengthening of concrete elements. Ph.D. thesis, K.U. Leuven.
8. Ceroni, F., and Pecce, M. (2010). Evaluation of bond strength and anchorage systems in concrete elements strengthened with CFRP sheets. J. Compos. Construc. 1090-0268, 14 (5), 521-530. 10.1061/(ASCE)CC.1943-5614.0000118
9. Chajes, M. J., Finch, W. W., Januszka, T. F., and Thomson, T. A. (1996). Bond and force transfer of composite-material plates adhered to concrete. ACI Struct. J. 0889-3241, 93 (2), 208-217
10. Chen, J. F., and Teng, J. G. (2001). Anchorage strength models for FRP and plates bonded to concrete. J. Struct. Div., Am. Soc. Civ. Eng., 9 (1), 52-62. 10.1061/(ASCE)1090-0268(2005)9:1(52)
11. De Lorenzis, L, Miller, B., and Nanni, A. (2001). Bond of fiber-reinforced polymer laminates to concrete. ACI Mater. J. 0889-325X, 98 (3), 256-264.
12. European Committee for Standardization. (2002). EN 1990-Eurocode-Basic of Structural Design, Brussels, Belgium
13. Faella, C., Martinelli, E., Nigro, E, Sabatino, M., Salerno, N., and Mantegazza, G. (2002 a). Aderenza tra calcestruzzo e Lamine di FRP utilizzate come placcaggio di elementi inflessi. Parte I: Risultati sperimentali. Proc. XIV C.T.E. Conf., C.T.E., Milan, Italy, 237-245 (in Italian).
14. Faella, C., Martinelli, E., and Nigro, E. (2002 b). Aderenza tra calcestruzzo e Lamine di FRP utilizzate come placcaggio di elementi inflessi Parte II: modelli teorici ed elaborazioni numeriche., Proc. XIV C.T.E. Conf., C.T.E., Milan, Italy, 237-245 (in Italian).
15. Faella, C., Martinelli, E., and Nigro, E. (2003). Interface behaviour in FRP plates bonded to concrete: Experimental tests and theoretical analyses. Proc. Int. Conf. on Advanced Materials for Construction of Bridges, Buildings and other Structures-III, Berkeley Electronic Press, Berkeley, CA, http://services.bepress.com/eci/advanced-materials/3/ (Dec. 15, 2010).
16. Faella, C., Martinelli, E., and Nigro, E. (2008). Formulation and validation of a theoretical model for intermediate debonding in FRP strengthened RC beams. Composites Part B, 39 (4), 645-655.
17. Faella, C., Martinelli E., and Nigro, E. (2009). Direct versus indirect method for identifying FRP-to-concrete interface relationships. J. Compos. Constr. 1090-0268, 13 (3), 226-233. 10.1061/(ASCE)1090-0268(2009)13:3(226)
18. Ferracuti, B., Martinelli, E., Nigro, E., and Savoia, M. (2007 a). Fracture energy and design rules against FRP-concrete debonding. Proc. the 8th FRPRCS Conf., Triantafillou, ed., Patras, Greece
19. Ferracuti, B., Savoia M., and Mazzotti, C. (2007 b). Interface law for FRP-concrete delamination composite structures. Compos. Struct., 80, 523-531.
20. fib Bulletin No. 14. (2001). Externally bonded FRP reinforcement for RC structures. Technical report prepared by the Working Party EBR of Task Group 9.3, International Federation for Structural Concrete, Lausanne, Switzerland.
21. Lu, X. Z., Teng, J. G., Ye, L. P., and Jiang, J. J. (2005). Bond-slip models for FRP sheets/plates bonded to concrete. Eng. Struct. 0141-0296, 27 (6), 920-937. 10.1016/j.engstruct.2005.01.014
22. Maeda, T., Asano, Y., Sato, Y., Ueda, T., and Kakuta, Y. (1997). A study on bond mechanism of carbon fiber sheet. Proc. 3rd Int. Symp. on Non-metallic (FRP) Reinforcement for Concrete Structures, Japan Concrete Institute, Tokyo, Japan, 279-285.
23. Mazzotti, C., Savoia, M., Ferracuti, B. (2009). A new single-shear set-up for stable debonding of FRP-concrete joints. Constr. Build. Mater. 0950-0618, 23 (4), 1529-1537. 10.1016/j.conbuildmat.2008.04.003
24. McSweeney, B. M., and Lopez, M. M. (2005). FRP-concrete bond behavior: A parametric study through pull-off testing. Proc. 7th Int. Symp. on FRP Reinforcement for Concrete Structures, ACI, Farmington Hills, MI, 441-460.
25. Monti, G., Alessandri, S., and Santini, S. (2009). Design by testing: A procedure for the statistical determination of capacity models. J. Constr. Build Mater. 0889-3241, 98 (3), 359-367.
26. Nigro, E., Martinelli, E., Di Ludovico, M., and Bilotta, A. (2008 a). Concrete interface relationships under monotonic and cyclic actions. Proc. 4th Int. Conf. on FRP Composites in Civil Engineering (CICE2008), Masoud Motavalli, Zurich, Switzerland.
27. Nigro, E., Di Ludovico, M., and Bilotta, A. (2008 b). FRP-concrete debonding: Experimental tests under cyclic actions. Proc., 14th World Conf. on Earthquake Engineering, IAEE Publisher, Tokyo, Japan.
28. Nigro, E., Di Ludovico, M., Bilotta, A. (2011). Experimental investigation on FRP-concrete debonding under cyclic actions. J. Mater. Civ. Eng. 0899-1561, 23 (4), 360-371. 10.1061/(ASCE)MT.1943-5533.0000173
29. Oehlers, D. J., and Moran, J. P. (1990). Premature failure of externally plated reinforced-concrete beams. J. Struct. Eng. 1090-0268, 11 (1), 62-70. 10.1061/(ASCE)1090-0268(2007)11:1(62)
30. Takeo, K., Matsushita, H., Makizumix, T., and Nagashima, G. (1997). Bond characteristics of CFRP sheets in the CFRP bonding technique. Proc. of Japan Concrete Institute, Japan Concrete Institute, Tokyo, Japan, 19 (2), 1599-1604.
31. Teng, J. G., Chen, J. F., Smith, S. T., and Lam, L. (2002). FRP: Strengthened RC structures. Wiley, Chichester, U.K.
32. Tounsi, A., Hassaine Daouadji, T., Benyoucef, S., and Addabedia, E. A. (2009). Interfacial stresses in FRP-plated RC beams: Effect of adherend shear deformations. Int. J. Adhes. Adhes. 0143-7496, 29 (4), 343-351. 10.1016/j.ijadhadh.2008.06.008
33. Travassos, N., Ripper, T., and Appleton, J. (2005). Bond stresses characterization on CFRP-RC interfaces. Proc. 3rd Int. Conf. Composites in Construction, P. Hamelin, D. Bigaud, E. Ferrier, and, E. Jacquelin, eds., Lyon, France
34. Ueda, T., Dai, J. G., and Sato, Y. (2003). A nonlinear bond stress-slip relationship for FRP sheet-concrete interface. Proc. Int. Symp. on Latest Achievement of Technology and Research on Retrofitting Concrete Structures, Japan Concrete Institute, Tokyo, Japan 113-120.
35. Ueda, T., and Dai, J. (2005). Mode II fracture energy of FRP-concrete interface: Its evaluation and roles in interface modeling and anchorage design. Proc. 11th Int. Conf. on Fracture, Turin, Italy, http://www.icf11.com/ proceeding/EXTENDED/4303.pdf.
36. Ueda, T., Sato, Y., and Asano, Y. (1999). Experimental study on bond strength of continuous carbon fiber sheet. Proc. 4th Int. Symp. on Fiber Reinforced Polymer Reinforcement for Reinforced Concrete Structure, ACI, Farmington Hills, MI, 407-416.
37. Wu, Z. S., Yuan, H., Yoshizawa, H., and Kanakubo, T. (2001). Experimental/analytical study on interfacial fracture energy and fracture propagation along FRP-concrete interface., ACI International SP-201-8, 133-152.
38. Yao, J., Teng, J. G., and Chen, J. F. (2005). Experimental study on FRP-to-concrete bonded joints. Comp., Part B 1359-8368, 36 (2), 99-113. 10.1016/j.compositesb.2004.06.001
39. Yuan, H., Teng, J. G., Seracino, R., Wu, Z. S., and Yao, J. (2004). Full-range behaviour of FRP-to-concrete bonded joints. Eng. Struct. 0141-0296, 26 (5), 553-565. 10.1016/j.engstruct.2003.11.006
40. Zhao, H. D., Zhang, Y., and Zhao, M. (2000). Research on the bond performance between CFRP plate and concrete. Proc. 1st Conf. on FRP Concrete Structures of China, 247-253.