Broadband metamaterial absorber based on coupling resistive frequency selective surface

Optics Express

Volumn 20, Issue 4, 2012, Pages 4675-4680

  Sun, Liang Kui ^a   Cheng, Hai Feng ^a   Zhou, Yong Jiang ^a   Wang, Jun ^a  

^a NATIONAL UNIVERSITY OF DEFENSE TECHNOLOGY   (China)

Author keywords

[No Author keywords available]

Indexed keywords

FRACTALS; METAMATERIALS;

DIELECTRIC LAYER; FREQUENCY RANGES; GROUND PLANES; QUALITATIVE ANALYSIS; RESISTIVE FREQUENCY; UNIT CELLS;

FREQUENCY SELECTIVE SURFACES;

EID: 84863181778     PISSN: None     EISSN: 10944087     Source Type: Journal    
DOI: 10.1364/OE.20.004675     Document Type: Article

References (16)

1. X. P. Shen, T. J. Cui, J. M. Zhao, H. F. Ma, W. X. Jiang, and H. Li, "Polarization-independent wide-angle tripleband metamaterial absorber," Opt. Express 19(10), 9401-9407 (2011).
2. N. I. Landy, S. Sajuyigbe, J. J. Mock, D. R. Smith, and W. J. Padilla, "Perfect metamaterial absorber," Phys. Rev. Lett. 100(20), 207402 (2008).
3. R. L. Chern and W. T. Hong, "Nearly perfect absorption in intrinsically low-loss grating structures," Opt. Express 19(9), 8962-8972 (2011).
4. Y. Z. Cheng, H. L. Yang, Z. Z. Cheng, and N. Wu, "Perfect metamaterial absorber based on a split-ring-cross resonator," Appl. Phys., A Mater. Sci. Process. 102(1), 99-103 (2011).
5. B. L. Huang and H. Chen, "Multi-band and polarization insensitive metamaterial absorber," Prog. Electromagn. Res. 113, 103-110 (2011).
6. B. A. Munk, P. Munk, and J. Pryor, "On designing jaumann and circuit analog absorber (CA absorber) for oblique angel of incidence," IEEE Trans. Antenn. Propag. 55(1), 186-193 (2007).
7. F. Costa, A. Monorchio, and G. Manara, "Ultra-thin absorbers by using high impedance surfaces with resistive frequency selective surfaces," International Symposium Antennas and Propagation Society 2007.
8. H. T. Liu, H. F. Cheng, Z. Y. Chu, and D. Y. Zhang, "Absorbing properties of frequency selective surface absorbers with cross-shaped resistive patches," Mater. Des. 28(7), 2166-2171 (2007).
9. F. Costa, A. Monorchio, and G. Manara, "Analysis and design of ultra-thin electromagnetic absorbers comprising resistively loaded high impedance surfaces," IEEE Trans. Antenn. Propag. 58(5), 1551-1558 (2010).
10. Y. N. Kazantsev, A. V. Lopatin, N. E. Kazantseva, A. D. Shatrov, V. P. Mal'tsev, J. Vilcakova, and P. Saha, "Broadening of operating frequency band of magnetic-type radio absorbers by FSS incorporation," IEEE Trans. Antenn. Propag. 58(4), 1227-1235 (2010).
11. D. Z. Piao, Y. F. Li, and G. Z. Lu, "Broadband electromagnetic absorber designs using genetic algorithm," Automation Congress 2008.
12. C. Suomin, D. S. Weile, and J. L. Volakis, "Novel planar absorber designs using genetic algorithms," International Symposium Antennas and Propagation Society 2009.
13. M. E. A. Safwat, "High impedance wire composite right/left-handed transmission lines," Microw. Opt. Technol. Lett. 52(6), 1390-1393 (2010).
14. M. E. Cos, Y. Alvarez, and F. Las-Heras, "A novel approach for RCS reduction using a combination of artificial magnetic conductors," Prog. Electromagn. Res. 107, 147-159 (2010).
15. J. D. Baena, R. Marqués, F. Medina, and J. Martel, "Artificial magnetic metamaterial design by using spiral resonators," Phys. Rev. B 69(1), 014402 (2004).
16. J. Yeo, J. F. Ma, and R. Mittra, "Ga-based design of artificial magnetic Fround planes(AMGS) utilizing frequency selective surface for bandwidth enhancement of microstrip antennas," Microw. Opt. Technol. Lett. 44(1), 6-13 (2005).