Effect of fly ash cenospheres on the microstructure and properties of silica-based composites

Ceramics International

Volumn 38, Issue 5, 2012, Pages 4395-4400

  Wang, Caifen ^a   Liu, Jiachen ^a   Du, Haiyan ^a   Guo, Anran ^a  

^a TIANJIN UNIVERSITY   (China)

Author keywords

B. Composite; B. Porosity; C. Mechanical properties; Microstructure; Silica

Indexed keywords

CENOSPHERES; CRISTOBALITES; MICROSTRUCTURE AND PROPERTIES; MULLITE CRYSTALS; NEEDLE-LIKE; SILICA CERAMIC; SILICA MATRIX; SINTERING AID;

CRYSTAL MICROSTRUCTURE; FLY ASH; MECHANICAL PROPERTIES; MICROSTRUCTURE; SILICATE MINERALS; SINTERING;

SILICA;

EID: 84862806453     PISSN: 02728842     EISSN: None     Source Type: Journal    
DOI: 10.1016/j.ceramint.2012.01.044     Document Type: Article

References (14)

1. S.C. White, and E.D. Case Characterization of fly ash from coal-fired power plants J. Mater. Sci. 25 1990 5215 5219
2. P.K. Kolay, and D.N. Singh Physical, chemical, mineralogical and thermal properties of cenospheres from an ash lagoon Cem. Concr. Res. 31 2001 539 542
3. K.T. Varughese, and B.K. Chaturvedi Fly ash as fine aggregate in polyester based polymer concrete Cem. Concr. Compos. 18 1996 105 108
4. B. Yilmaz, and A. Olgun Studies on cement and mortar containing low-calcium fly ash, limestone, and dolomitic limestone Cem. Concr. Compos. 30 2008 194 201
5. D.P. Mondal, S. Das, N. Ramakrishnan, and K.U. Bhasker Cenosphere filled aluminum syntactic foam made through stir-casting technique Composites: Part A 40 2009 279 288
6. P.K. Rohatgi, J.K. Kim, and N. Gupta Compressive characteristics of A356/fly ash cenosphere composites synthesized by pressure infiltration technique Composites: Part A 37 2006 430 437
7. N. Chand, P. Sharma, and M. Fahim Correlation of mechanical and tribological properties of organosilane modified cenosphere filled high density polyethylene Mater. Sci. Eng. A 527 2010 5873 5878
8. S.M. Kulkarni, and Kishore Studies on fly ash-filled epoxy-cast slabs under compression J. Appl. Polym. Sci. 84 2002 2404 2410
9. S.M. Kishore, and D.S. Kulkarni On the use of an instrumented set-up to characterize the impact behavior of an epoxy system containing varying fly ash content Polym. Test. 21 2002 763 771
10. Y.E. Pivinshii, and F.T. Gorobets High density fused silica ceramic Refract. Ind. Ceram. 9 2010 509 516
11. P.K. Rohatgi, A. Daoud, B.F. Schultz, and T. Puri Microstructure and mechanical behavior of die casting AZ91D-Fly ash cenosphere composites Composites: Part A 40 2009 883 896
12. Y.F. Shao, D.C. Jia, and B.Y. Liu Characterization of porous silicon nitride ceramics by pressureless sintering using fly ash cenosphere as a pore-forming agent J. Eur. Ceram. Soc. 29 2009 1529 1534
13. 3 coating powders J. Alloys Compd. 460 2008 651 657
14. M. Ocaña, A. Caballero, C.T. González, and C.J. Serna Preparation by pyrolysis of aerosols and structural characterization of Fe-doped mullite powders Mater. Res. Bull. 35 2000 775 788