Control design for multisource systems based on DC/DC converters duty cycle value

COMPEL - The International Journal for Computation and Mathematics in Electrical and Electronic Engineering

Volumn 30, Issue 1, 2011, Pages 310-335

  Mboup, Alioune Badara ^a,b   Guerin, François ^b   Lefebvre, Dimitri ^b   Ndiaye, Pape Alioune ^a  

^a UNIVERSITY OF LE HAVRE   (France)

^b UNIVERSITÉ CHEIKH ANTA DIOP   (Senegal)

Author keywords

Controllers; Electric converters; Energy supply systems; Energy transfer; Modelling

Indexed keywords

AUTONOMOUS CONTROL; COMPREHENSIVE MODEL; CONTROL DESIGN; DESIGN/METHODOLOGY/APPROACH; DUTY CYCLES; ELECTRICAL ENERGY; ENERGY SOURCE; ENERGY SUPPLY SYSTEM; EXTRA SENSORS; FULL-BRIDGE; HIERARCHICAL CONTROL; LOAD CHARACTERISTICS; LOAD DEMAND; MODELLING; MULTI-SOURCE SYSTEM; MULTISOURCES; OPERATING MODES; POWER RATIO; POWER VARIATIONS; REMOTE AREAS; RENEWABLE ENERGY SYSTEMS; RESEARCH GROUPS; RESEARCH LIMITATIONS; SHAFT SPEED; SOCIAL IMPLICATION; SYSTEM VARIABLES; TWO SOURCES; TWO STAGE; ZERO VOLTAGE SWITCH;

COMPUTER SIMULATION; CONTROLLERS; DC POWER TRANSMISSION; ENERGY TRANSFER; HIERARCHICAL SYSTEMS; HYBRID COMPUTERS; HYBRID SYSTEMS; SENSORS; SUN;

DC-DC CONVERTERS;

EID: 80052242029     PISSN: 03321649     EISSN: None     Source Type: Journal    
DOI: 10.1108/03321641111091584     Document Type: Article

References (22)

1. Ashari, M. and Nayar, C.V. (1999), "An optimum dispatch strategy using set points for a photovoltaic (PV)-diesel-battery hybrid power system", Solar Energy, Vol. 66 No. 1, pp. 1-9.
2. Aydemir, M.T., Bendre, A. and Venkataramannan, G. (2002), "A critical evaluation of high power hard andsoftswitched isolatedDC- DCconverters", IEEEInd.Appl.Conf.,Ankara, pp. 1338-45. (Pubitemid 35413589)
3. Chaurey, C. and Deambi, S. (1992), "Battery storage for PV power systems: an overview", Renewable Energy, Vol. 2 No. 3, pp. 227-35. (Pubitemid 23557842)
4. Chedid, R., Akiki, H. and Rahman, S. (1998), "A decision support technique for the design of hybrid solar-wind power systems", IEEETransactions onEnergyConversion,Vol. 13No. 1, pp. 76-83. (Pubitemid 128742325)
5. Cho, J.G., Sabate, J., Hua, A.G. and Lee, F.C. (1994), "Zero-voltage and zero-current switching full bridge PWM converter for high power applications", IEEE Appl. Power Electron. Conf. Expo, Durham, pp. 102-8.
6. Erickson, R.W. (1999), "DC-DC power converters", Article in Wiley Encyclopedia of Electrical and Electronics Engineering, Vol. 5, Department of Electrical and Computer Engineering University of Colorado, Boulder, CO, pp. 53-63, 80309-0425.
7. Gow, J.A. and Manning, C.D. (1999), "Development of a photovoltaic array model for use in power electronics simulation studies", IEE Proceedings on Electric Power Applications, Vol. 146 No. 2, pp. 193-200.
8. Hua,G., Lee, F.C. and Jovanovic, M.M. (1993), "An improved full-bridge zero-voltage-switchedPWM converter using a saturable inductor", IEEE Trans. Power Electron., Vol. 8 No. 4, pp. 530-4.
9. Jeon, S.J. and Cho, G. (2001), "A zero-voltage and zero-current switching full bridge DC-DC converter with transformer isolation", IEEE Trans. Power Electron., Vol. 16 No. 5, pp. 573-80. (Pubitemid 32949924)
10. Koutsoukos, X.D., Antsaklis, P.J., Stiver, J.A. and Lemmon, M.D. (2000), "Supervisory control of hybrid systems", IEEE Transactions on Energy Conversion, Vol. 88 No. 7, pp. 1026-49.
11. Lin, P.Z., Lin, C.M., Hsu, C.F. and Lee, T.T. (2005), "Type-2 fuzzy controller design using a sliding-mode approach for application to DC-DC converters", IEE Proc-Electr. Power Appl., Vol. 152 No. 6, pp. 1482-8.
12. Lygeros, J. (1996), "Hierarchical, hybrid control of large scale systems", UCB-ITS-PRR-96-23 California Path Research Report.
13. Mboup, A.B., Guerin, F., Ndiaye, P. and Lefebvre, D. (2008), "Multimodel for the coupling of several DC/DC power converters on a DC bus", IEEE International Symposium on Industrial Electronics (IEEE-ISIE08), Cambridge, pp. 1507-12.
14. Mokadem, M.El, Nichita, C., Barakat, G. and Dakyo, B. (2002), "Control strategy for stand alone wind-diesel hybrid system using a wind speed model", Proceedings of the International Conference on Modeling and Simulation of Electrical Machines, Converters and Systems (ELECTRIMACS'02), Montréal, (Proceedings CD-ROM).
15. Pepa, E. (2004), "Adaptive control of a step-up full-bridge DC-DC converter for variable low input voltage applications", PhD thesis in Electrical Engineering of the Faculty of the Virginia Polytechnic Institute and State University, Blacksburg, VA.
16. Pereira, A.L. (2000), Modular Supervisory Controller for Hybrid Power Systems, Risø National Laboratory, Roskilde.
17. Rodolfo, D.L. and Bernal-Agustin, J.L. (2005), "Design and control strategies of PV-diesel systems using genetic algorithms", Solar Energy, Vol. 79 No. 1, pp. 33-46.
18. Sabate, J.A., Vlatkovic, V., Ridley, R.B., Lee, F.C. and Cho, B.H. (1990), "Design considerations for high-voltage high-power full-bridge zero voltage-switched PWM converter", IEEE Appl. Power Electron. Conf. Expo., Blackburn, pp. 275-84.
19. Sun, J. and Grotstollen, H. (1997), "Symbolic analysis method for average modeling of switching powers converters", IEEE Trans. Power Electron., Vol. 12, pp. 543-9.
20. Uzunoglu, M., Onar, O.C. and Alam, M.S. (2009), "Modeling, control and simulation of a PV/FC/UC based hybrid power generation system for stand-alone applications", Renewable Energy, Vol. 34 No. 3, pp. 509-20.
21. Valenciaga, F. and Puleston, P.F. (2005), "Supervisor control for a stand-alone hybrid generation system using wind and photovoltaic energy", IEEE Transactions on Energy Conversion, Vol. 20 No. 2, pp. 398-405. (Pubitemid 40843741)
22. Walker, G. (2001), "Evaluating mppt converter topologies using a MATLAB pv model", Journal of Electrical & Electronics Engineering, Vol. 21 No. 1, pp. 49-55. (Pubitemid 33075288)