An investigation to the microstructural evolution of Fe-29Mn-5Al dual-phase twinning-induced plasticity steel through annealing

Materials and Design

Volumn 32, Issue 10, 2011, Pages 5015-5021

  Torabinejad, V ^a   Zarei Hanzaki, A ^a   Moemeni, S ^a   Imandoust, A ^a  

^a UNIVERSITY OF TEHRAN   (Iran)

Author keywords

[No Author keywords available]

Indexed keywords

ANNEALING CONDITION; ANNEALING TIME; COMPRESSION TESTS; DUAL PHASE MICROSTRUCTURE; LOW STRAIN RATES; MECHANICAL BEHAVIOR; MICROSTRUCTURAL EXAMINATION; POST ANNEALING TREATMENT; POTENTIAL EFFECTS; RESTORATION PROCESS; ROOM TEMPERATURE; SOFTENING EFFECT; STRESS VARIATIONS; TWIP STEEL;

AUSTENITE; COLD ROLLING; COMPRESSION TESTING; FERRITES; HIGH STRENGTH STEEL; MANGANESE; MECHANICAL ENGINEERING; MICROSTRUCTURAL EVOLUTION; PLASTICITY TESTING; RECRYSTALLIZATION (METALLURGY); STRAIN RATE; TWINNING; YIELD STRESS;

ANNEALING;

EID: 79960898221     PISSN: 02641275     EISSN: 18734197     Source Type: Journal    
DOI: 10.1016/j.matdes.2011.06.004     Document Type: Article

References (30)

1. Grassel O., Kruger L., Frommeyer G., Meyer L.W. High strength Fe-Mn-(Al, Si) TRIP/TWIP steels development - properties - application. Int J Plast 2000, 161:391-409.
2. Saeed-Akbari A., Imlau J., Prahl U., Bleck W. Derivation and variation in composition-dependent stacking fault energy maps based on subregular solution model in high-manganese steels. Metall Mater Trans A 2009, 40:3076-3090.
3. Shiekhelsouk M.N., Favier V., Inal K., Allain S., Bouaziz O., Cherkaoui M. Residual and internal stress states in duplex steel with TWIP effect. Mater Sci Forum 2006, 524-525:833-838.
4. Zhang Y.S., Zhu X.M. Electrochemical polarization and passive film analysis of austenitic Fe-Mn-Al steels in aqueous solutions. Corrosion Sci 1999, 41:1817-1833.
5. Sahraoui T., Hadji M., Yahi M. Design and deformation behavior of high strength Fe-Mn-Al-Cr-C duplex steel. Mater Sci Eng A 2009, 523:271-276.
6. Yoo J.D., Hwang S.W., Park K.T. Factors influencing the tensile behavior of a Fe-28Mn-9Al-08C steel. Mater Sci Eng A 2009, 508:234-240.
7. Sutou Y., Kamiya N., Umino R., Ohnuma I., Ishida K. High-strength Fe-20Mn-Al-C-based alloys with low density. ISIJ Int 2010, 50:893-899.
8. Cheng W.C., Lin H.Y. The precipitation of FCC phase from BCC matrix in an Fe-Mn-Al alloy. Mater Sci Eng A 2002, 323:462-466.
9. Cheng W.C., Lin H.Y., Liu C.F. Observing the massive transformation in an Fe-Mn-Al alloy. Mater Sci Eng A 2002, 335:82-88.
10. Cheng W.C., Liu C.F., Lai Y.F. Observing the D03 phase in Fe-Mn-Al alloys. Mater Sci Eng A 2002, 337:281-286.
11. Cheng W.C., Liu C.F., Lai Y.F. The role carbon plays in the martensitic phase transformation of an Fe-Mn-Al alloy. Scri Mater 2003, 48:295-300.
12. Hamada A.S., Karjalainen L.P., Somani M.C. The influence of aluminum on hot deformation behavior and tensile properties of high-Mn TWIP steels. Mater Sci Eng A 2007, 467:114-124.
13. Hamada A.S., Somani M.C., Karjalainen L.P. High temperature flow stress and recrystallization behavior of high-Mn TWIP steels. ISIJ Int 2007, 47:907-912.
14. Bracke L., Verbeken K., Kestens L., Penning J. Microstructure and texture evolution during cold rolling and annealing of a high Mn TWIP steel. Acta Mater 2009, 57:1512-1524.
15. Bouaziz O., Scott C.P., Petitgand G. Nanostructured steel with high work-hardening by the exploitation of the thermal stability of mechanically induced twins. Scri Mater 2009, 60:714-716.
16. Dini G., Najafizadeh A., Ueji R., Monir-Vaghefi S.M. Tensile deformation behavior of high manganese austenitic steel: the role of grain size. Mater Des 2010, 31:3395-3402.
17. Wang X., Zurob H.S., Embury J.D., Ren X., Yakubtsov I. Microstructural features controlling the deformation and recrystallization behaviour Fe-30% Mn and Fe-30% Mn-0.5% C. Mater Sci Eng A 2010, 527:3785-3791.
18. Chiou S.T., Cheng W.C., Lee W.S. Strain rate effects on the mechanical properties of a Fe-Mn-Al alloy under dynamic impact deformations. Mater Sci Eng A 2005, 392:156-162.
19. Kalashnikov I., Acselrad O., Shalkevich A., Pereira L.C. Chemical composition optimization for austenitic steels of the Fe-Mn-Al-C system. JMEPEG 2000, 9:597-602.
20. Liu C.M., Cheng H.C., Chao C.Y., Ou K.L. Phase transformation of high temperature on Fe-Al-Mn-Cr-C alloy. J Alloys Compd 2009, 488:52-56.
21. Brofman P.J., Ansel G.S. On the effect of carbon on the stacking fault energy of austenitic stainless steels. Metall Mater Trans A 1978, 9:879-880.
22. Yang W.S., Wan C.M. The influence of aluminum content to the stacking fault energy in Fe-Mn-Al-C alloy system. J Mater Sci 1990, 25:1821-1823.
23. Rémy L., Pineau A., Thomas B. Temperature dependence of stacking fault energy in close-packed metals and alloys. Mater Sci Eng A 1978, 36:47-63.
24. Hamada AS. Manufacturing, mechanical properties and corrosion behavior of high Mn TWIP steel. Doctoral thesis, University of Oulu, Linnanmaa, Finland; 2007.
25. Vercammen S. Processing and tensile behaviour of TWIP steels microstructural and texture analysis. Doctoral thesis, Katholieke Universiteit Leuven, Leuven, Belgium; 2004.
26. Torabinejad V., Zarei-Hanzaki A., Sabet M., Abedi H.R. The effect of low temperature annealing on the mechanical behavior of cold rolled dual-phase twinning-induced plasticity steel. Mater Des 2011, 32:2345-2349.
27. Gutierrez-Urrutia I., Zaefferer S., Raabe D. The effect of grain size and grain orientation on deformation twinning in a Fe-22 wt.% Mn-0.6 wt.% C TWIP steel. Mater Sci Eng A 2010, 527:3552-3560.
28. Kwon O., DeArdo A.J. Interactions between recrystallization and precipitation in hot-deformed microalloyed steels. Acta Metall Mater 1990, 39:529-538.
29. Humphreys F.J., Hatherly M. Recrystallization and related annealing phenomena 2004, Elsevier. 2nd ed.
30. Bouaziz O., Allain S., Scott C. Effect of grain and twin boundaries on the hardening mechanisms of twinning-induced plasticity steels. Scri Mater 2008, 58:484-487.