Correlating low energy impact damage with changes in modal parameters: Diagnosis tools and FE validation

Structural Health Monitoring

Volumn 10, Issue 2, 2011, Pages 199-217

  Shahdin, Amir ^a   Morlier, Joseph ^a   Niemann, Hanno ^a   Gourinat, Yves ^a  

^a ECOLE DES MINES D ALBI CARMAUX   (France)

Author keywords

model updating; structural health monitoring; topology optimization; vibration

Indexed keywords

BARELY VISIBLE IMPACT DAMAGES; COMPOSITE BEAM; DAMAGE LOCATION; DAMAGE MODEL; DAMAGED ZONES; DEGRADATION FACTOR; DIAGNOSIS TOOLS; EQUIVALENT RIGIDITY; EXPERIMENTAL TECHNIQUES; FE MODEL; FINITE ELEMENTS; FREQUENCY RESPONSE FUNCTIONS; IMPACT DAMAGES; IMPACT IDENTIFICATION; LOW-ENERGY IMPACT; MODAL PARAMETERS; MODEL UPDATING; NUMERICAL CORRELATIONS; SENSITIVE MATERIALS; STRUCTURAL HEALTH;

FINITE ELEMENT METHOD; FREQUENCY RESPONSE; MODAL ANALYSIS; OPTIMIZATION; SAFETY FACTOR; STRUCTURAL HEALTH MONITORING; TOPOLOGY; VIBRATION ANALYSIS;

DAMAGE DETECTION;

EID: 79952929845     PISSN: 14759217     EISSN: 17413168     Source Type: Journal    
DOI: 10.1177/1475921710373297     Document Type: Article

References (55)

1. Farrar CR and Worden K. An introduction to structural health monitoring. Philos Trans R Soc A 2007; 365(1851): 303-315.
2. van der Auweraer H. International research projects on structural damage detection. Key Eng Mater 2001; 204(2): 97-112.
3. Farrar CR and Lieven AJ Damage prognosis: the future of structural health monitoring. Philos Trans R Soc A 2007; 365(1851): 623-632.
4. Schubel PM, Luo JJ and Daniel IM Impact and post impact behaviour of composite sandwich panels. Composites Part A 2007; 38(3): 1051-1057.
5. Abrate S. Impact on composite structures. New York: Cambridge University Press, 1988.
6. Gay D. and Hua SV Composite materials: designs and applications. 2nd ed. Boca Raton: CRC Press, 2007. 7. Petit S., Bouvet C., Bergerot A. and Barrau JJ Impact and compression after impact experimental study of a composite laminate with a cork thermal shield. Compos Sci Technol 2007; 67: 3286-3299.
7. Zou Y., Tong L. and Steven GB Vibration-based model-dependent damage (delamination) identification and health monitoring for composite structures. A review. J Sound Vibration 2000; 230(2): 357-378.
8. Yan YJ, Cheng L., Wu ZY and Yam LH Development in vibration-based structural damage detection technique. Mech Syst Signal Process 2007; 21(6): 2198-2211.
9. Doebling SW, Farrar CR, Prime MB and Shevitz DW Damage identification and health monitoring of structural and mechanical systems from changes in their vibration characteristics: a literature review. Research Report LA-13070-MS ESA-EA Los Alamos National Laboratory, 1996.
10. Sohn H., Farrar CR, Hemez FM, Shunk D., Stinemates DW and Nadler BR A review of structural health monitoring literature: 1996-2001. Los Alamos National Laboratory Report LA-13976-MS, 2004.
11. Carden EP and Fanning P. Vibration based condition monitoring: a review. SHM 2004; 3(4): 355-377.
12. Salawu OS Detection of structural damage through changes in frequency: a review. Eng Struct 1996; 19(9): 718-23.
13. Khoo LM, Mantena PR and Jadhav P. Structural damage assessment using vibration modal analysis. SHM 2004; 3(2): 177-194.
14. Gadelrab RM The effect of delamination on the natural frequencies of a laminated composite beam. J Sound Vibration 1996; 197(3): 283-292.
15. Yam LH and Cheng L. Damage detection of composite structures using dynamic analysis. Key Eng Mater 2005; 295-296: 33-39.
16. Kim HY and Hwang W. Effect of debonding on natural frequencies and frequency response functions of honeycomb sandwich beams. Compos Struct 2002; 55(1): 51-62.
17. Shahdin A., Morlier J. and Gourinat Y. Correlating low energy impact damage with changes in modal parameters: a preliminary study on composite beams. SHM 2009; 8(6): 523-536.
18. Shahdin A., Morlier J. and Gourinat Y. Damage monitoring in sandwich beams by modal parameter shifts: a comparative study of burst random and sine dwell vibration testing. J Sound Vibration 2010; 329(5): 566-584.
19. Shahdin A., Mezeix L., Bouvet C., Morlier J. and Gourinat Y. Monitoring the effects of impact damages on modal parameters in carbon fiber entangled sandwich beams. Eng Struct 2009; 31(12): 2833-2841.
20. Zhang Z. and Hartwig G. Relation of damping and fatigue damage of unidirectional fibre composites. Int J Fatigue 2004; 24: 713-738.
21. Gibson RF Modal vibration response measurements for characterization of composite materials and structures. Compos Sci Technol 2000; 60(15): 2769-2780.
22. Saravanos DA and Hopkins DA Effects of delaminations on the damped dynamic characteristics of composites. J Sound Vibration 1995; 192(5): 977-993.
23. Fugate ML, Sohn H. and Farrar CR Vibration-based damage detection using statistical process control. Mech Syst Signal Process 2001; 15(4): 707-721.
24. Waldron K., Ghoshal A., Schulz MJ, Sundaresan MJ, Ferguson F., Pai PF,et al.Damage detection using finite elements and laser operational deflection shapes. J Finite Elements Anal Design 2002; 38(3): 193-226.
25. Sundaresan MJ, Pai PF, Ghoshal A., Schulz MJ, Ferguson F. and Chung J. Methods of distributed sensing for health monitoring of composite material structures. Compos A J 2001; 32(9): 1357-1374.
26. LeClerc JR, Worden K., Staszewski WJ and Haywood J. Impact detection in an aircraft composite panel - a neural network approach. J Sound Vibration 2007; 299(3): 672-682.
27. Banks HT, Inman DJ, Leo DJ and Wang Y. An experimentally validated damage detection theory in smart structures. J Sound Vibration 1996; 191(5): 859-880.
28. Yan YJ and Yam LH Online detection of crack damage in composite plates using embedded piezoelectric actuators/sensors and wavelet analysis. Compos Struct 2002; 58(1): 29-38.
29. Kao CY and Hung SL Detection of structural damage via free vibration responses generated by approximating artificial neural networks. Comput Struct 2003; 81(28-29): 2631-2644.
30. Wojtowicki JL and Jaouen L. New approach for the measurements of damping properties of materials using oberst beam. Rev Scient Instru 2004; 75(8): 2569-2574.
31. Vanhoenacker K., Schoukens J., Guillaume P. and Vanlanduit S. The use of multisine excitations to characterise damage in structures. Mech Syst Signal Process 2004; 18(1): 43-57.
32. Mattson SG and Pandit SM Damage detection and localization based on outlying residuals. Smart Mater Strcut 2006; 15(6): 1801-1810.
33. Cook RD Concepts and applications of finite element analysis. 2nd ed. New York: John Wiley and Sons, 1981.
34. Bathe KL Finite element procedures in engineering analysis. Englewood Cliffs: Prentice-Hall, 1982.
35. Zienkiewicz OC and Taylor RL The finite element method. 4th ed. London: MacGraw-Hill, 1986.
36. Remouchamps A. and Radovcic Y. Theoretical aspects about optimization methods and algorithms. Boss Quattro V5, SAMTECH, 2003.
37. Montalvao D., Ribeiro AM and Duarte-Silva J. A method for the localization of damage in a CFRP plate using damping. Mech Syst Signal Process 2008; 23(6): 1846-1854.
38. Kessler SS, Spearing SM, Attala MJ, Cesnik CES and Soutis C. Damage detection in composite materials using frequency response. Composites Part B 2002; 33(1): 87-95.
39. Yam LH, Wei Z. and Cheng L. Non-destructive detection of internal delamination by vibration-based method for composite plates. J Compos Mater 2004; 38(24): 2183-2198.
40. Yang S., Gibson RF, Gu L. and Chen WH Modal parameter evaluation of degraded adhesively bonded composite beams. Compos Struct 1998; 43(1): 79-91.
41. Hou JP and Jeronimidis G. Vibration of delaminated thin plates. Composites Part A 1999; 30(8): 989-995.
42. Zhang XY and Yang CH Recent developments in finite element analysis for laminated composite plates. Compos Struct 2009; 88(1): 147-157.
43. Yan YJ and Lam LH FEM modeling method of damage structures for structural damage detection. Compos Struct 2004; 72(2): 193-199.
44. Friswell MI and Mottershead JE Finite element model updating in structural dynamics. New York: Springer, 1995.
45. Bendsoe MP and Kikuchi N. Generating optimal topologies in structural design using a homogenization method. Comput Meth Appl Mech Eng 1992; 35(7): 1487-1502.
46. Bendsoe MP Optimal shape design as a material distribution problem. Struct Optim 1989; 1(4): 193-202.
47. Bendsoe MP and Sigmund O. Topology optimization-theory, methods and applications. New York: Springer Verlag, 2003.
48. Ma ZD, Kikuchi N. and Hagiwara I. Structural topology and shape optimization for a frequency response problem. Comput Mech 1993; 13(3): 157-174.
49. MSC Software corporation. Users guide for topology optimization, 2007.
50. Lee JS, Kim JE and Kim YY Damage detection by the topology design formulation using modal parameters. Int J Numer Meth Eng 2007; 69(7): 1480-1498.
51. Niemann H., Morlier J., Shahdin A. and Gourinat Y. Damage localization using experimental modal parameters and topology optimization. Mech Syst Signal Process 2010; 24(3): 636-652.
52. HexPly 914. Data Sheet, Hexcel Composites, F.R.
53. Peeters B., Auweraer HV, Guillaume P. and Leuridan J. The PolyMAX frequency-domain method: a new standard for modal parameter estimation. Shock Vibration 2004; 11(3-4): 395-409.
54. Morlier J., Bos F. and Castera P. Diagnosis of a portal frame using advanced signal processing of laser vibrometer data. J Sound Vibration 2006; 297(1-2): 420-431.
55. Schwarz BJ and Richardson MH Experimental modal analysis. In: Proceedings of the CSI Reliability Week, Orlando, FL, 1999.