Power electronics and electrical insulation systems - Part 3: Diagnostic properties

IEEE Electrical Insulation Magazine

Volumn 26, Issue 5, 2010, Pages 30-40

  Cavallini, Andrea ^a   Fabiani, Davide ^a   Montanari, Gian Carlo ^a  

^a UNIVERSITY OF BOLOGNA   (Italy)

Author keywords

impulse waveform; induction motor; partial discharge; pulse width modulation; space charge

Indexed keywords

APPLIED VOLTAGES; ELECTRICAL COMPONENTS; ELECTRICAL EQUIPMENT; ELECTRICAL INSULATION SYSTEMS; ELECTRICAL STRESS; IMPULSE WAVEFORMS; INSULATION FAILURES; LOW-VOLTAGE; MAGNET WIRES; MEDIUM VOLTAGE; MOTOR DESIGN; MOTOR TERMINALS; MOTOR WINDINGS; NANO-FILLERS; NON-SINUSOIDAL; ORGANIC INSULATING MATERIALS; ORGANIC MATERIALS; ORGANIC/INORGANIC; OVER-VOLTAGES; PARTIAL DISCHARGE INCEPTION VOLTAGE; POWER ELECTRONIC CONVERTERS; ROTATING MACHINE; SINUSOIDAL CONDITIONS; SPACE CHARGES; SWITCHING TECHNIQUES; VOLTAGE WAVEFORMS; WAVE FORMS; WINDING INSULATION; WOUND MOTOR;

AC GENERATOR MOTORS; ASSET MANAGEMENT; BUILDING MATERIALS; ELECTRIC MACHINE INSULATION; ELECTRIC PROPERTIES; INDUCTION MOTORS; INSULATING MATERIALS; MACHINE DESIGN; MAGNETS; PARTIAL DISCHARGES; POWER ELECTRONICS; PULSE WIDTH MODULATION; ROTATING MACHINERY; ROTATION; WAVEFORM ANALYSIS; WINDING; WIRE;

INSULATION;

EID: 77957558598     PISSN: 08837554     EISSN: None     Source Type: Journal    
DOI: 10.1109/MEI.2010.5585006     Document Type: Article

References (31)

1. G. C. Montanari and D. Fabiani, "Searching for the factors which affect self-healing capacitor degradation under non-sinusoidal voltage," IEEE Trans. Dielectr. Electr. Insul., vol.6, pp. 319-325, 1999.
2. G. C. Montanari and D. Fabiani, "The effect of non-sinusoidal voltage on intrinsic aging of cable and capacitor insulating materials," IEEE Trans. Dielectr. Electr. Insul., vol.6, pp. 798-802, 1999.
3. D. Fabiani and G. C. Montanari, "The effect of voltage distortion on aging acceleration of insulation systems under partial discharge activity," IEEE Electr. Insul. Mag., vol.17, no.3, pp. 24-33, 2001.
4. E. Persson, "Transient effects in application of PWM inverters to induction motors," IEEE Trans. Ind. Appl., vol.28, pp. 1095-1101, 1992.
5. G. C. Stone, S. Campbell, and S. Tetreault, "Inverter-fed drives: Which motor stators are at risk?" IEEE Ind. Appl. Mag., vol.6, no.5, pp. 17-22, Oct. 2000.
6. F. P. Espino-Cortes, E. A. Cherney, and S. H. Jayaram, "Impact of inverter drives employing fast-switching devices on form-wound AC machine stator coil stress grading," IEEE Electr. Insul. Mag., vol.23, no.1, pp. 16-28, 2007.
7. A. Cavallini, D. Fabiani, and G. C. Montanari, "Power electronics and electrical insulation systems - Part 1: Phenomenology overview," IEEE Electr. Insul. Mag., vol.26, no.3, pp. 7-15, 2010.
8. A. Cavallini, D. Fabiani, and G. C. Montanari, "Power electronics and electrical insulation systems - Part 2: Life modeling for insulation design," IEEE Electr. Insul. Mag., vol.26, no.4, pp. 33-39, 2010.
9. R. J. Kerkman, D. Leggate, and G. L. Skibinski, "Interaction of drive modulation and cable parameters on AC motor transients," IEEE Trans. Ind. Appl., vol.33, pp. 722-731, 1997.
10. M. Kaufhold, G. Borner, M. Eberhardt, and J. Speck, "Failure mechanism of low voltage electric machines fed by pulse-controlled inverters," IEEE Electr. Insul. Mag., vol.12, no.5, pp. 9-15, 1996.
11. W. Yin, "Failure mechanism of winding insulation in inverter-fed motors," IEEE Electr. Insul. Mag., vol.13, no.6, pp.18-23, 1997.
12. D. Fabiani, Accelerated Degradation of AC-Motor Winding Insulation Due to Voltage Waveforms Generated by Adjustable Speed Drives. Bologna, Italy: Gedit Edizioni, 2003.
13. J. C. G. Wheeler, "Effects of converter pulses on the electrical insulation in low and medium voltage motors," IEEE Electr. Insul. Mag., vol.21, no.2, pp. 22-29, 2005.
14. H. Okubo, N. Hayakawa, and G. C. Montanari, "Technical development on partial discharge measurement and electrical insulation techniques for low voltage motors driven by voltage inverters," IEEE Trans. Dielectr. Electr. Insul., vol.14, pp. 1516-1530, 2007.
15. T. Tanaka, Y. Ohki, M. Ochi, N. Harada, and T. Imai, "Enhanced partial discharge resistance of epoxy/clay nanocomposite prepared by newly developed organic modification and solubilization methods," IEEE Trans. Dielectr. Electr. Insul., vol.15, pp. 81-89, 2008.
16. T. Ozaki, T. Imai, F. Sawa, T. Shimizu, and F. Kanemitsu, "Partial discharge resistant enameled wire," in Proceedings of 2005 International Symposium on Electrical Insulating Materials, 2005, pp. 184-187.
17. Qualification and Type Tests for Type I Electrical Insulation Systems Used in Rotating Electrical Machines When Fed From Voltage Converters, IEC 60034-18-41 TS Ed. 1.0, 2006.
18. Qualification and Acceptance Tests for Partial Discharge Resistant Electrical Insulation Systems (Type II) Used in Rotating Electrical Machines When Fed From Voltage Converters, IEC 60034-18-42 TS Ed 1.0, 2008.
19. Electrical Measurements of Partial Discharges During Short Risetime Repetitive Voltage Impulses, IEC 61934 TS Ed. 1.0, 2006.
20. C. Laurent, G. Teyssedre, and G. C. Montanari, "Time-resolved space charge and electroluminescence measurements in polyethylene under ac stress," IEEE Trans. Dielectr. Electr. Insul., vol.11, pp. 554-560, 2004.
21. D. Fabiani, G. C. Montanari, A. Cavallini, and G. Mazzanti, "Relation between space charge accumulation and partial discharge activity in enameled wires under PWM-like voltage waveforms," IEEE Trans. Dielectr. Electr. Insul., vol.11, pp. 393-405, 2004.
22. D. Casadei, A. Cavallini, D. Fabiani, C. Rossi, G. Serra, and G. C. Montanari, "The influence of power-electronic waveforms on partial discharge inception in low voltage rotating machines," in Proceedings of the International Conference on Coil Winding, Insulation and Electrical Manufacturing, 2003, pp. 39-44.
23. R. Busch, F. Pohlmann, and K. Muller, "The influence of several environmental conditions on the partial discharge characteristics and on the lifetime of magnet wires under inverter pulse operation," in Proceeding of the IEEE International Symposium on Electrical Insulating Materials, 2001, pp. 645-648.
24. D. Fabiani, A. Cavallini, and G. C. Montanari, "The effect of environmental conditions on PD activity of PWM-fed induction motors," in INSUCON 2006 Proceedings, 2006, pp. 115-118.
25. D. Fabiani, A. Cavallini, and G. C. Montanari, "A UHF technique for advanced PD measurements on inverter-fed motors," IEEE Trans. Power Electr., vol.23, pp. 2546-2556, 2008.
26. High-Voltage Test Techniques - Partial Discharge Measurement, IEC 60270 - Ed. 3.0, 2000.
27. Rotating Electrical Machines - Part 27: Off-line Partial Discharge Measurements on the Stator Winding Insulation of Rotating Electrical Machines, IEC 60034-60127 TS Ed. 1, 2006.
28. A. E. Fitzgerald, C. Kingsley, and S. Umans, Electrical Machinery. New York: McGraw-Hill, 2002.
29. A. Cavallini, D. Fabiani, and G. C. Montanari, "A novel method to diagnose PWM-fed induction motors," IEEE Trans. Dielectr. Electr. Insul. , vol.15, pp. 1313-1321, 2008.
30. M. Tozzi, G. C. Montanari, D. Fabiani, and A. Cavallini, "Off-line and on-line PD measurements on induction motors fed by power electronic impulses," in Proceedings of the IEEE Electrical Insulation Conference, 2009, pp. 420-424.
31. A. Cavallini, D. Fabiani, and G. C. Montanari, "Ageing investigation of motor winding insulation subjected to PWM-supply through PD measurements," in Proceedings of the IEEE Conference on Electrical Insulation and Dielectric Phenomena, 2005, pp. 434-437.