Experimental study of water liquid-vapor two-phase pressure drop across an array of staggered micropin-fins

Journal of Electronic Packaging

Volumn 131, Issue 2, 2009, Pages 0210101-0210108

  Konishi, Christopher A ^a   Qu, Weilin ^a   Pfefferkorn, Frank E ^b  

^a University of Hawaii at Manoa   (United States)

^b University of Wisconsin Madison   (United States)

Author keywords

[No Author keywords available]

Indexed keywords

DROPS; FINS (HEAT EXCHANGE); LIQUIDS; TWO PHASE FLOW;

LIQUID-VAPOR TWO-PHASE FLOW; LIQUID-VAPOUR; LONGITUDINAL PITCH; MASS VELOCITY; MICRO PIN FINS; MICRO-PIN-FIN ARRAY; PIN-FINS; TEST MODULES; TWO-PHASE PRESSURE DROPS; VAPOR QUALITY;

PRESSURE DROP;

EID: 77955226265     PISSN: 10437398     EISSN: 15289044     Source Type: Journal    
DOI: 10.1115/1.3104028     Document Type: Article

References (19)

1. Koşar, A., and Peles, Y., 2007, "Boiling Heat Transfer in a Hydrofoil-Based Micro Pin Fin Heat Sink," Int. J. Heat Mass Transfer, 50, pp. 1018-1034.
2. Krishnamurthy, S., and Peles, Y., 2008, "Flow Boiling of Water in a Circular Staggered Micro-Pin Fin Heat Sink," Int. J. Heat Mass Transfer, 51(5-6), pp. 1349-1364.
3. Krishnamurthy, S., and Peles, Y., 2007, "Gas-Liquid Two-Phase Flow Across a Bank of Micropillars," Phys. Fluids, 19(4), pp. 043302.
4. Kosar, A., 2008, "Two-Phase Pressure Drop Across a Hydrofoil-Based Micro Pin Device Using R-123," Exp. Therm. Fluid Sci., 32, pp. 1213-1221.
5. Ishihara, K., Palen, J. W., and Taborek, J., 1980, "Critical Review of Correlations for Predicting Two-Phase Flow Pressure Drop Across Tube Banks," HeatTransfer Eng., 1(3), pp. 23-32.
6. Schrage, D. S., Hsu, J.-T., and Jensen, M. K., 1988, "Two-Phase Pressure Drop in Vertical Crossflow Across a Horizontal Tube Bundle," AIChE J., 34(1), pp. 107-115.
7. Dowlati, R., Kawaji, M., and Chan, A. M. C., 1990, "Pitch-to- Diameter Effect on Two-Phase Flow Across an In-Line Tube Bundle," AIChE J., 36(5), pp. 765-772.
8. Dowlati, R., Chan, A. M. C., and Kawaji, M., 1992, "Hydrodynamics of Two- Phase Flow Across Horizontal In-Line and Staggered Rod Bundles," ASME J. Fluids Eng., 114, pp. 450-456.
9. Dowlati, R., Kawaji, M., and Chan, A. M. C., 1996, "Two-Phase Crossflow and Boiling Heat Transfer in Horizontal Tube Bundles," ASME J. Heat Transfer, 118(1), pp. 124-131.
10. Xu, G. P., Tou, K. W., and Tso, C. P., 1998, "Two-Phase Void Fraction and Pressure Drop in Horizontal Crossflow Across a Tube Bundle," ASME J. Fluids Eng., 120, pp. 140-145.
11. Blevins, R. D., 1984, Applied Fluid Dynamics Handbook, Van Nostrand, New York.
12. Dukler, A. E., Wicks, M., III, and Cleveland, R. G., 1964, "Frictional Pressure Drop in Two-Phase Flow: A. A Comparison of Existing Correlations for Pressure Loss and Holdup and B. An Approach Through Similarity Analysis," AIChE J., 10, pp. 38-51.
13. Beattie, D. R. H., and Whalley, P. B., 1982, "A Simple Two-Phase Flow Frictional Pressure Drop Calculation Method," Int. J. Multiphase Flow, 8, pp. 83-87.
14. McAdams, W. H., Woods, W. K., and Heroman, L. C., Jr., 1942, "Vaporization Inside Horizontal Tubes-II. Benzene-Oil Mixtures," Trans. ASME, 46, pp. 193-200.
15. Cicchitti, A., Lombardi, C., Silvestri, M., Soldaini, G., and Zavattarlli, R., 1960, "Two-Phase Cooling Experiments-Pressure Drop, Heat Transfer and Burnout Measurement," Energ. Nucl. (Milan), 7(6), pp. 407-425.
16. Lockhart, R. W., and Martinelli, R. C., 1949, "Proposed Correlation of Data for Isothermal Two-Phase, Two-Component Flow in Pipes," Chem. Eng. Prog., 45, pp. 39-48.
17. Chisholm, D., 1983, Two-Phase Flow in Pipelines and Heat Exchangers, Longman, New York.
18. Kawahara, A., Chung, P. M.-Y., and Kawaji, M., 2002, "Investigation of Two- Phase Flow Pattern, Void Fraction and Pressure Drop in a Microchannel," Int. J. Multiphase Flow, 28(9), pp. 1411-1435.
19. Mishima, K., and Hibiki, T., 1996, "Some Characteristics of Air-Water Two- Phase Flow in Small Diameter Vertical Tubes," Int. J. Multiphase Flow, 22, pp. 703-712.