Effect of driving cycle on the performance of PEM fuel cell and microstructure of membrane electrode assembly

International Journal of Hydrogen Energy

Volumn 35, Issue 7, 2010, Pages 2814-2819

  Li, Bing ^a   Lin, Rui ^a   Yang, Daijun ^a   Ma, Jianxin ^a  

^a TONGJI UNIVERSITY   (China)

Author keywords

CV; Driving cycle; EIS; MEA; SEM

Indexed keywords

ACTIVE SURFACE AREA; CATALYST LAYERS; CHARGE TRANSFER RESISTANCE; CHEMICAL SURFACES; CYCLE TESTS; DRIVING CYCLE; ELECTROCHEMICAL REACTIONS; I - V CURVE; IMPEDANCE ANALYSIS; MEMBRANE ELECTRODE ASSEMBLIES; PEM FUEL CELL; SEM; SINGLE CELL PERFORMANCE;

CHARGE TRANSFER; CHEMICAL PROPERTIES; CYCLIC VOLTAMMETRY; ELECTROCHEMICAL CORROSION; ION EXCHANGE; MICROSTRUCTURE; SCANNING ELECTRON MICROSCOPY;

PROTON EXCHANGE MEMBRANE FUEL CELLS (PEMFC);

EID: 77950985285     PISSN: 03603199     EISSN: None     Source Type: Journal    
DOI: 10.1016/j.ijhydene.2009.05.021     Document Type: Article

References (12)

1. Ralph T.R., and Hards G.A. Powering the cars and homes of tomorrow. Chem Ind 9 (1998) 337-342
2. Ralph T.R., Hards G.A., Keating J.E., Campbell S.A., Wilkinson D.P., Davis M., et al. Low cost electrodes for PEM fuel cells. J Electrochem Soc 144 (1997) 38-45
3. Ferreira P.J., Lao G.J., Horn Y.S., Morgan D., Makharia R., Kocha S., et al. Effect of voltage on platinum dissolution. J Electrochem Soc 9 (2005) A225-A227
4. Xie J., Wood D.L., Wayne D.M., Zawodzinski T.A., Atanassov P., and Borup R.L. Microstructural changes of membrane electrode assemblies during PEFC durability testing at high humidity conditions. J Electrochem Soc 152 (2005) A1011-A1020
5. Wilson M.S., Garzon F.H., Sickafus K.E., and Gottesfeld S. Surface area loss of supported platinum in polymer electrolyte fuel cells. J Electrochem Soc 140 (1993) 2872-2877
6. Stevens D.A., Hicks M.T., Haugen G.M., and Dahn J.R. Ex situ and in situ stability studies of PEMFC catalysts. J Electrochem Soc 152 (2005) A2309-A2315
7. Jiang Q.Z., and Jiang Z.F. Mea preparation for polymer electrolyte membrane fuel cell by applying directly printing catalyst on membrane technique. J Chem Industry Eng 5 (2004) 488-492 [in Chinese]
8. Ralph T.R., Hards G.A., and Keating J.E. Analysis of dynamic models for structural insight and mode. J Electrochem Soc 144 (1997) 3845-3857
9. Yang D.J., Ma J.X., and Xu L. The effect of nitrogen oxides in air on the performance of proton exchange membrane fuel cell. Electrochim Acta 51 (2006) 4039-4044
10. Fischer A., Jindra J., and Wendt H. Porosity and catalyst utilization of thin layer cathodes in air operated PEM-fuel cells. J Appl Electrochem 28 (1998) 277-282
11. Yuan X.Z., Suna J.C., Blanco M., Wang H.J., and Zhang J.J. Effects of hydrophilic/hydrophobic properties on the water behavior in the micro-channels of a proton exchange membrane fuel cell. J Power Sources 161 (2006) 843-848
12. Lu J.Y., and Zhang X.J. Review on fabrication methods of membrane electrode assembly for proton exchange membrane fuel cells. Chinese Batt Ind 11 (2006) 410-413 [in Chinese)