Investigation of the strain distribution with lubrication during the deep drawing process

Tribology International

Volumn 43, Issue 5-6, 2010, Pages 1104-1112

  Yang, T S ^a  

^a NATIONAL FORMOSA UNIVERSITY   (Taiwan)

Author keywords

Deep drawing process; Friction model; Lubrication analysis

Indexed keywords

ASPERITY CONTACTS; CONTACT AREA RATIO; DEEP-DRAWING PROCESS; FINITE ELEMENT CODES; FRICTION COEFFICIENTS; FRICTION MODELS; INTERFACE PRESSURE; LUBRICANT FILM THICKNESS; LUBRICANT VISCOSITY; LUBRICATION ANALYSIS; LUBRICATION FLOWS; MIXED LUBRICATION; NUMERICAL RESULTS; SLIDING SPEED; STRAIN DISTRIBUTIONS; SURFACE ROUGHNESS EFFECTS;

FRICTION; NUMERICAL ANALYSIS; REYNOLDS EQUATION; STRAIN RATE; SURFACE ROUGHNESS; TRIBOLOGY;

DEEP DRAWING;

EID: 77549084590     PISSN: 0301679X     EISSN: None     Source Type: Journal    
DOI: 10.1016/j.triboint.2009.12.050     Document Type: Article

References (12)

1. Wilson W.R.D. Friction and lubrication in bulk metal-forming processes. J Appl Metalwork 1 (1979) 7-19
2. Wilson W.R.D. Friction models for metal forming in the boundary lubrication regime. ASME J Eng Mater Technol 113 (1988) 60-68
3. Mastrovich J.D. Lubrication. A technical publication devoted to the selection and use of lubricants. CALTEX 30 (1972) 125-134
4. Mahdavian S.M., and Shao Z.M. Isoviscous hydrodynamic lubrication of deep drawing and its comparison with experiment. ASME J Tribol 115 (1993) 111-119
5. Yang T.S. Full film lubrication of deep drawing. Tribol Int 32 (1999) 89-96
6. Patir N., and Cheng H.S. An average flow model for determining effects of three-dimensional roughness on partial hydrodynamic lubrication. ASME J Lubr Technol 101 (1979) 220-230
7. Wilson W.R.D., and Marsault N. Partial hydrodynamic lubrication with large fractional contact areas. ASME J Tribol 120 (1998) 16-20
8. Wilson W.R.D., and Sheu S. Real area of contact and boundary friction in metal forming. Int J Mech Sci 130 (1988) 475-489
9. Wilson W.R.D., Hsu T.C., and Huang X.B. A realistic friction model for computer simulation of sheet metal forming process. ASME J Eng Ind 117 (1995) 202-207
10. Hsu T.C., and Yang T.S. The computer simulation of tribological influence on strain path and forming limit in punch stretching of sheet metal. Int J Adv Manuf Technol 34 (2001) 393-399
11. Lange K. Handbook of metal forming (1985), McGraw-Hill
12. Lo S.Y., and Yang T.S. A microwedge model of sliding contact in boundary/mixed lubrication. Wear 261 (2006) 1163-1173