On quasi-non-destructive strength and toughness testing of elastic-plastic materials

International Journal of Solids and Structures

Volumn 42, Issue 2, 2005, Pages 717-725

  Schindler, Hans Jakob ^a  

^a Mat Tec AG   (Switzerland)

Author keywords

Ambulant; Carving; Fracture toughness; In situ; Instrumented indentation; Miniature pin compression; Quasi non destructive testing; Scratching

Indexed keywords

FRACTURE TOUGHNESS; INDENTATION; NONDESTRUCTIVE EXAMINATION; PLASTICITY; STRAIN HARDENING; TENSILE STRENGTH; YIELD STRESS;

AMBULANT; CARVING; INSTRUMENTED INDENTATION; MINIATURE PIN COMPRESSION; SCRATCHING;

ELASTICITY;

EID: 7444247979     PISSN: 00207683     EISSN: None     Source Type: Journal    
DOI: 10.1016/j.ijsolstr.2004.06.029     Document Type: Conference Paper

References (9)

1. Boucaille, J.L., Stauss, S., Felder, E., Michler, J., 2003. Determination of plastic properties of metals by instrumented indentation using different sharp indenters, Acta Materialica 51, 1663-1678.
2. clough, R.B., Webb, S.C., Armstrong, R.W., 2003. Dynamic hardness measurements using dropped ball Materials Science and Engineering A 360, 396-407.
3. Fischer-Cripps, A., 2000. Introduction to Contact Mechanics. Springer, New York.
4. Haggag, F.M., 2001. In-situ non-destructive measurement of key mechanical properties of oil and gas pipelines. In: PVP, vol. 429, ASME, pp. 99-104.
5. He, M.Y., Odette, G.R., Lucas, G.E., Schroeter, B., 2002. A FEM study relating load-penetration curves to yield and post-yield behaviour. In: ASTM STP 1418, pp. 306-320.
6. Meyer, E., 1908. Untersnchungen über Härteprüfung und Härte. Zeitschrift des Vereines Deutscher Ingenieure 52, 17 645-17 654 (in German).
7. Schindler, H.J., 2003. Abschätzung der wahren Spannungs-Dehnungskurve mit instrumentierten Kugeleindrackversuchen. In: Werkstoffprüfung 2003, VDEh, Bad Neuenahr (in German).
8. Tabor, D., 1951. The Hardness of Metals. Oxford University Press, New York.
9. Tipping, Ph., Bertschinger, P., Schindler, H.J., 2003. Characterisation of local material behaviour of a welded pipe by instrumented indentation test using Meyer's approach. In: Proc. 9th Int. Conf. on Mechanical Behaviour of Materials (ICM9), Geneva. 25-29 May 2003.