Independent air dehumidification with membrane-based total heat recovery: Modeling and experimental validation

International Journal of Refrigeration

Volumn 33, Issue 2, 2010, Pages 398-408

  Liang, C H ^a   Zhang, L Z ^a   Pei, L X ^a  

^a BEIJING UNIVERSITY OF POSTS AND TELECOMMUNICATIONS   (China)

Author keywords

Air conditioning Dehumidification Membrane; conditionnement d'air; d shumidification; exp rimentation; Experiment; Heat recovery; membrane; mod lisation; Modelling; r cup ration de chaleur

Indexed keywords

AIR DEHUMIDIFICATION; AIR FLOWRATES; CELL SIMULATION; CONDITIONNEMENT D'AIR; DETAILED MODELS; ELECTRIC POWER CONSUMPTION; ENERGY RECOVERY; EXPERIMENTAL VALIDATIONS; FRESH AIR; HEAT RECOVERY; KEY EQUIPMENT; MEMBRANE MODES; OPERATING CONDITION; RELATIVE HUMIDITIES; RESPIRATORY DISEASE; THERMAL COEFFICIENTS; TOTAL HEAT EXCHANGER; TOTAL HEAT RECOVERY; WEATHER CONDITIONS;

AIR CONDITIONING; ATMOSPHERIC HUMIDITY; DISEASE CONTROL; ELECTRIC UTILITIES; ENTHALPY; HUMIDITY CONTROL; METEOROLOGY; RECOVERY; WASTE HEAT; WASTE HEAT UTILIZATION;

MEMBRANES;

SUIDAE;

EID: 74149090148     PISSN: 01407007     EISSN: None     Source Type: Journal    
DOI: 10.1016/j.ijrefrig.2009.09.016     Document Type: Article

References (30)

1. Browne M.W., and Bansal P.K. Steady-state model of centrifugal liquid chillers. International Journal of Refrigeration 21 (1998) 343-358
2. Chwalowski M., Didion D.A., and Domanski P.A. Verification of evaporator computer models and analysis of performance of an evaporator coil. ASHRAE Transactions 95 (1989) 1229-1236
3. Ding G.L., and Zhang C.L. Simulation and Optimization of Refrigeration and Air Conditioning Appliances (2001), Science Press (in Chinese), Beijing
4. Duprez M.E., Dumont E., and Frére M. Modelling of reciprocating and scroll compressors. International Journal of Refrigeration 30 (2007) 873-886
5. Elhaj M., Gu F., Ball A.D., Albarbar A., Al-Qattan M., and Naid A. Numerical simulation and experimental study of a two-stage reciprocating compressor for condition monitoring. Mechanical Systems and Signal Processing 22 (2008) 374-389
6. García-Cascales J.R., Vera-García F., Corberán-Salvador J.M., and Gonzálvez-Maciá J. Assessment of boiling heat transfer correlations in the modelling of fin and tube heat exchangers. International Journal of Refrigeration 30 (2007) 1004-1017
7. Griffiths P.W., and Eames P.C. Performance of chilled ceiling panels using phase change material slurries as the heat transport medium. Applied Thermal Engineering 27 (2007) 1756-1760
8. Guttman I., Wilks S.S., and Stuart H.J. Introductory Engineering Statistics (1965), John Wiley and Sons, New York
9. Huzayyin A.S., Nada S.A., and Elattar H.F. Air-side performance of a wavy-finned-tube direct expansion cooling and dehumidifying air coil. International Journal of Refrigeration 30 (2007) 230-244
10. Kilmenko V.V. A generalized correlation for two-phase forced flow heat transfer. International Journal of Heat and Mass Transfer 31 (1988) 541-552
11. Lemmon E.W., McLinden M.O., and Huber M.L. NIST Reference Fluid Thermodynamic Transport Properties-REFPROP, Version 7.0 (2002), NIST, USA
12. Liu X.H., Li Z., Jiang Y., and Lin B.R. Annual performance of liquid desiccant based independent humidity control HVAC system. Applied Thermal Engineering 26 (2006) 1198-1207
13. Liu X.H., Zhang Y., Qu K.Y., and Jiang Y. Experimental study on mass transfer performances of cross flow dehumidifier using liquid desiccant. Energy Conversion and Management 47 (2006) 2682-2692
14. Mo J.H., Zhang Y.P., and Yang R. Novel insight into VOC removal performance of photocatalytic oxidation reactors. Indoor Air 15 (2005) 291-300
15. Shah M.M. A general correlation for heat transfer during film condensation inside pipes. International Journal Heat and Mass Transfer 22 (1979) 547-556
16. Theerakulpisut S., and Priprem S. Modeling cooling coils. International Communications in Heat and Mass Transfer 25 (1998) 127-137
17. Threlkeld J.L. Thermal Environmental Engineering (1972), Prentice-Hall, Inc
18. Wang C.C., Webb R.L., and Chi K.Y. Data reduction for air-side performance of fin-and-tube heat exchangers. Experimental Thermal and Fluid Science 21 (2000) 218-226
19. Wang C.C. Performance of plate finned tube heat exchangers under dehumidifying conditions. Journal of Heat Transfer Engineering 119 (1997) 109-117
20. Wile D.D. The measurement of expansion valve capacity. Refrigeration Engineering 8 (1935) 108-112
21. Xu X.G., Leung C.W., Chan M.Y., and Deng S.M. Condensate retention on a louver-fin-and-tube air cooling coil. International Journal of Refrigeration 19 (2007) 223-230
22. Xu Y., and Zhang Y.P. An improved mass transfer based model for analyzing VOC emissions from building materials. Atmospheric Environment 37 (2003) 2497-2505
23. Xu Y., and Zhang Y.P. A general model for analyzing VOC emission characteristics from building materials and its application. Atmospheric Environment 38 (2004) 113-119
24. Zhang L.Z. Total Heat Recovery: Heat and Moisture Recovery from Ventilation Air (2008), Nova Science Publishing Co, New York
25. Zhang L.Z. Energy performance of independent air dehumidification systems with energy recovery measures. Energy 31 (2006) 1228-1242
26. Zhang L.Z. Heat and mass transfer in plate-fin sinusoidal passages with vapor-permeable wall materials. International Journal of Heat and Mass Transfer 51 (2008) 618-629
27. Zhang L.Z. Heat and mass transfer in plate-fin enthalpy exchangers with different plate and fin materials. International Journal of Heat and Mass Transfer 52 (2009) 2704-2713
28. Zhang L.Z., and Xiao F. Simultaneous heat and moisture transfer through a composite supported liquid membrane. International Journal of Heat and Mass Transfer 51 (2008) 2179-2189
29. Zhang L.Z., Zhu D.S., Deng X.H., and Hua B. Thermodynamic modeling of a novel air dehumidification system. Energy and Buildings 37 (2005) 279-286
30. Zhang Y.P., Yang R., and Zhao R.Y. A model for analyzing the performance of photocatalytic air cleaner in removing volatile organic compounds. Atmospheric Environment 37 (2003) 3395-3399