Fretting wear of stainless steels under variable temperature conditions: Introduction of a 'composite' wear law

Wear

Volumn 268, Issue 3-4, 2010, Pages 413-423

  Rybiak, R ^a,b   Fouvry, S ^a   Bonnet, B ^c  

^a LABORATOIRE DE TRIBOLOGIE ET DYNAMIQUE DES SYSTÈMES   (France)

^b LODZ UNIVERSITY OF TECHNOLOGY   (Poland)

^c SAFRAN AIRCRAFT ENGINES   (France)

Author keywords

A 286 super alloy; Fretting wear; Glaze layer; Jethete M152 stainless steel; Raman spectroscopy

Indexed keywords

ENERGY DISSIPATION; FRICTION; GLAZES; RAMAN SPECTROSCOPY; SINTERING; WEAR OF MATERIALS; FRETTING CORROSION; SOLIDS; STAINLESS STEEL; TRIBOLOGY;

CONSTANT TEMPERATURE; FRETTING WEAR; FRICTION COEFFICIENTS; GLAZE LAYERS; SPECIFIC WEAR RATES; THRESHOLD TEMPERATURES; TWO CONTACTING BODIES; VARIABLE TEMPERATURE;

STAINLESS STEEL; WEAR OF MATERIALS;

EID: 73449112598     PISSN: 00431648     EISSN: None     Source Type: Journal    
DOI: 10.1016/j.wear.2009.08.029     Document Type: Article

References (29)

1. Kayaba T., and Iwabuchi A. The fretting wear of 0.45% C steel and austenitic stainless steel from 20 to 650 °C in air. Wear 74 (1981) 229-245
2. Hurricks P.L. The fretting wear of mild steel from room temperature to 200 °C. Wear 19 (1972) 207-229
3. Hurricks P.L. The mechanism of fretting-a review. Wear 15 (1970) 389-409
4. Taylor D.E., Hardisty F.B., Waterhouse R.B., and Nehru A.Y. The fretting wear of an austenitic stainless steel in air and in carbon dioxide at elevated temperatures. Wear 56 (1979) 9-18
5. Chin K.J., Zaidi H., and Mathia T. Oxide film formation in magnetized sliding steel/steel contact-analysis of the contact stress field and film failure mode. Wear 259 (2005) 477-481
6. Stott F.H., Glascott J., and Wood G.C. The sliding wear of commercial Fe-12%Cr alloys at high temperature. Wear 101 (1985) 311-324
7. Glascott J., Stott F.H., and Wood G.C. The transition from severe to mild sliding wear for Fe-12%Cr-base alloys at low temperatures. Wear 97 (1984) 155-178
8. Glascott J., Stott F.H., and Wood G.C. The effectiveness of oxides in reducing sliding wear of alloys. Oxidation Metals 24 (1985) 99-114
9. Stott F.H., and Wood G.C. The influence of oxides on the friction and wear of alloys. Tribol. Int. 11 (1978) 211-218
10. Jiang J., Stott F.H., and Stack M.M. The role of triboparticulates in dry sliding wear. Tribol. Int. 31 (1998) 245-256
11. Colombie Ch., Berthier Y., Floquet A., Vincent L., Godet M., and Fretting. Load carrying capacity of wear debris. Trans. ASME J. Tribol. 106 (1984) 194-201
12. Kato H., and Komai K. Tribofilm formation and mild wear by tribo-sintering of nanometer-sized oxide particles on rubbing steel surfaces. Wear 262 (2007) 36-41
13. Kato H. Severe-mild wear transition by supply of oxide particles on sliding surface. Wear 255 (2003) 426-429
14. Iwabuchi A. The role of oxide particles in the fretting wear of mild steel. Wear 151 (1991) 301-311
15. Hiratsuka K., and Muramoto K. Role of wear particles in severe-mild wear transition. Wear 259 (2005) 467-476
16. Fouvry S., Kapsa Ph., Zahouani H., and Vincent L. Wear analysis in fretting of hard coatings through a dissipated energy concept. Wear 203-204 (1997) 393-403
17. Elleuch K., and Fouvry S. Wear analysis of A357 aluminium alloy under fretting. Wear 253 (2002) 662-672
18. Fouvry S., Duo P., and Perruchant Ph. A quantitative approach of Ti-6al-4 V fretting damage: friction, wear and crack nucleation. Wear 257 (2004) 916-929
19. Fouvry S., Kapsa Ph., and Vincent L. Quantification of fretting damage. Wear 200 (1996) 186-205
20. Mohrbacher H., Blanpain B., Celis J.P., Roos J.R., Stals L., and van Stappen M. Oxidational wear of TiN coatings on tool steel and nitrided tool steel in unlubricated fretting. Wear 188 (1995) 130-137
21. Archard J.F. Contact and rubbing of flat surfaces. J. Appl. Phys. 24 (1953) 981-988
22. Zhou Y.-H., Harmelin M., and Bigot J. Sintering behaviour of ultra-fine Fe, Ni and Fe-25 wt.%Ni powders. Scripta Metall. 23 (1989) 1391-1396
23. De Faria D.L.A., Venancio Silva S., and De Oliveira M.T. Raman microscopy of some iron oxides and oxyhydroxides. J. Raman Spectrosc. 28 (1997) 873-878
24. Wang A., Kuebler K.E., Jolliff B.L., and Haskin L.A. Raman spectroscopy of Fe-Ti-Cr-oxides, case study: Martian meteorite EETA79001. Am. Mineral. 89 (2004) 665-680
25. 4. J. Phys. Chem. Solids 64 (2003) 425-431
26. Kim J.H., and Hwang I.S. Development of an in situ Raman spectroscopic system for surface oxide films on metals and alloys in high temperature water. Nuclear Eng. Des. 235 (2005) 1029-1040
27. Renusch D., Veal B., Natesan K., and Grimsditch M. Transient oxidation in Fe-Cr-Ni alloys: a Raman-scattering study. Oxidation Metals 46 (1996) 365-381
28. Paulin C., Fouvry S., and Deyber S. Wear kinetics of Ti-6Al-4 V under constant and variable fretting sliding conditions. Wear 259 (2005) 292-299
29. Liskiewicz T., and Fouvry S. Hard coatings durability under fretting wear. Tribol. Int. 38 (2005) 69-79