High step-up resonant push-pull converter with high efficiency

IET Power Electronics

Volumn 2, Issue 1, 2009, Pages 79-89

  Kim, E H ^a   Kwon, B H ^a  

^a Pohang University of Science and Technology (POSTECH)   (South Korea)

Author keywords

[No Author keywords available]

Indexed keywords

BOOST INDUCTORS; CONVENTIONAL CURRENTS; DOUBLERS; DUTY RATIOS; FULL-LOAD; HIGH EFFICIENCY; HIGH OUTPUT VOLTAGE; HIGH-CURRENT SOURCES; HIGH-VOLTAGES; INDUCTOR CURRENTS; INPUT CURRENT; INPUT VOLTAGE RANGES; LOW-VOLTAGE; OUTPUT POWER; OUTPUT VOLTAGES; PUSH-PULL CONVERTERS; RIPPLE CURRENTS; VOLTAGE CONVERSION RATIO;

DISTILLATION; FUEL CELLS; PHOTOVOLTAIC CELLS; POWER CONVERTERS; SOFTWARE PROTOTYPING;

ELECTRIC RECTIFIERS;

EID: 72449131683     PISSN: 17554535     EISSN: 17554543     Source Type: Journal    
DOI: 10.1049/iet-pel:20070140     Document Type: Article

References (16)

1. Wang, C., Kang, Y., and Lu, B.: et al. ' A high power-density, high efficiency front-end converter for capacitor charging application ', IEEE Applied Power Electronics Conf., 2005, 2, p. 1258-1264
2. Qun, Z., and Lee, F.C.: ' High-efficiency, high step-up DC-DC converters ', IEEE Trans. Power Electron., 2003, 18, p. 65-73 10.1109/TPEL.2002.807188 0885-8993
3. Qun, Z., Fengfeng, T., Lee, F.C., Peng, X., and Jia, W.: ' A simple and effective method to alleviate the rectifier reverse-recovery problem in continuous-current-mode boost converters ', IEEE Trans. Power Electron., 2001, 16, p. 649-658 10.1109/63.949497 0885-8993 (Pubitemid 32949931)
4. Ned, M., Tore, M.U., and William, P.R.: ' Power electronics, converters, applications, and design ', 3rd edn. (Wiley, 2003), p. 500-502
5. Domingo, A., Ruiz, C., and Ivo, B.: ' A new flyback-current-fed push-pull DC-DC converter ', IEEE Trans. Power Electron., 1999, 14, p. 1056-1064 0885-8993
6. Han, S.K., Yoon, H.K., Yoon, G.W., Youn, M.J., Kim, Y.H., and Lee, K.H.: ' A new active clamping zero-voltage switching PWM current-fed half-bridge converter ', IEEE Trans. Power Electron., 2005, 20, p. 1271-1279 0885-8993
7. Abraham, I.P.: ' Switching power supply design ', 2nd edn. (McGraw-Hill, 1998), p. 189-192
8. Rabello, A.L., Co, M.A., Simonetti, D.S.L., and Vieira, J.L.F.: ' An isolated DC-DC boost converter using two cascade control loops ', Proc. IEEE Ind. Electron., 1997, 1635, p. 452-456
9. Nome, F.J., and Barbi, I.: ' A ZVS clamping-mode current-fed push-pull DC-DC converter ', Proc. IEEE Ind. Electron., 1998, 2, p. 617-621
10. Wai, R.J., Lin, C.Y., Liu, L.W., and Duan, R.Y.: ' Voltage-clamped forward quasi-resonant converter with soft switching and reduced switch stress ', IEE Proc., Electr. Power Appl., 2008, 152, p. 558-564 10.1049/ip-epa:20045025 1350-2352
11. Lee, F.C.: ' High-frequency quasi-resonant converter technologies ', Proc. IEEE, 1988, 76, p. 377-390 10.1109/5.4424 0018-9219
12. Law, K.K., Cheng, K.W.E., and Yeung, Y.P.B.: ' Design and analysis of switched-capacitor-based step-up resonant converters ', IEEE Trans. Circuits Syst., 2005, 52, p. 943-948 0098-4094
13. Dongyan, Z., Pietkiewicz, A., and Cuk, S.: ' A three-switch high-voltage converter ', IEEE Trans. Power Electron., 1999, 14, p. 177-183 10.1109/63.737606 0885-8993
14. Xingsheng, Z., Dan, C., and Jamerson, C.: ' Leading-edge modulation voltage-mode control with flux unbalance correction for push-pull converter ', IEEE Applied Power Electronics Conf., 2000, 1, p. 327-333
15. Lizhi, Z., Kunrong, W., Lee, F.C., and Lai, J.S.: ' New start-up schemes for isolated full-bridge boost converters ', IEEE Trans. Power Electron., 2003, 18, p. 946-951 10.1109/TPEL.2003.813758 0885-8993
16. Watson, R., Lee, F.C., and Hua, G.C.: ' Utilization of an active-clamp circuit to achieve soft switching in flyback converters ', IEEE Trans. Power Electron., 1996, 11, p. 162-169 10.1109/63.484429 0885-8993