Magnetic force improvement and parameter optimization for magnetic abrasive polishing of AZ31 magnesium alloy

Transactions of Nonferrous Metals Society of China (English Edition)

Volumn 18, Issue SPEC. ISSUE 1, 2008, Pages

  Kim, S O ^a   Kwak, J S ^a  

^a Pukyong National University   (South Korea)

Author keywords

Magnetic abrasive polishing process; Magnetic force improvement; Nonferrous material; Permanent magnet; Process parameter

Indexed keywords

HIGH STRENGTH ALLOYS; MAGNETISM; PERMANENT MAGNETS; POLISHING; STRENGTH OF MATERIALS; SURFACE ROUGHNESS;

AZ31 MAGNESIUM ALLOY; EXPERIMENTAL VERIFICATION; HIGH SPECIFIC STRENGTH; MAGNETIC ABRASIVE; MAGNETIC FORCE; NONFERROUS MATERIALS; PARAMETER OPTIMIZATION; PROCESS PARAMETERS;

MAGNESIUM ALLOYS;

EID: 71649098593     PISSN: 10036326     EISSN: None     Source Type: Journal    
DOI: 10.1016/s1003-6326(10)60234-8     Document Type: Article

References (11)

1. International Magnesium Association Technical Committee. Machining of magnesium and magnesium and magnesium alloys [M]// Metals Handbook. 1989, 16: 820-830.
2. SOHN K Y. The effect of heat treatment and extruded Mg-Al-Zn alloy [J]. Material Science Forum, 2003, 419/422: 135-140.
3. CHINO Y, KIMURA K, MABUCHI M. Twinning behavior and deformation mechanisms of extruded AZ31 Mg alloy [J]. Mater Sci Eng A, 2008, 486: 481-488.
4. TOMAC N, TONNESSEN K. Formation of flank build-up in cutting magnesium alloys [J]. Ann CIRP, 1991, 40(1): 79-82.
5. ARAI M, SATO S, OGAWA M, SHIKATA H. Chip control in finish cutting of magnesium alloy [J]. Journal of Material Process Technology, 1996, 62: 341-344.
6. TRENT E M, WRIGHT P K. Metal cutting [M]. USA: Butterworth-Heinemann, 2000.
7. JAIN V K, KUMAR P, BEHERA P K, JAYWAL S C. Effect of working gap and circumferential speed in the performance of magnetic abrasive finishing process [J]. Wear, 2001, 250: 384-390. (Pubitemid 33050457)
8. SINGH D K, JAIN V K, RAGHURAM V, KOMANDURI R. Analysis of surface texture generated by a flexible magnetic abrasive brush [J]. Wear, 2005, 259: 1254-1261. (Pubitemid 40762967)
9. SINGH D K, JAIN V K, RAGHURAM V. Parametric study of magnetic abrasive finishing process [J]. Journal of Material Processing Technology, 2004, 149: 22-29.
10. KWAK J S, KIM I K, HA M K, KIM Y S. Optimization strategies of grinding parameters for metal matrix composites by design of experiments and genetic algorithm [C]// International Conference on Leading Edge Manufacturing in 21st Century. 2005: 607-612.
11. SINGH S, SHAN H S, KUMAR P. Parametric optimization of magnetic-field-assisted abrasive flow machining by the Taguchi method [J]. Quality and Reliability Engineering International, 2002, 18: 273-283.