메뉴 건너뛰기




Volumn 1, Issue , 2008, Pages 905-910

Three-dimensional stress analysis and configuration optimization of cross wavy primary surface recuperator for microturbine system

Author keywords

Cross wavy; Microturbine system; Optimization; Recuperator

Indexed keywords

AIR PASSAGES; AIR PRESSURES; ANSYS PARAMETRIC DESIGN LANGUAGE; AUTOMATIC GENERATION; CALCULATION PROCEDURE; CONFIGURATION OPTIMIZATION; CROSS WAVY; CROSS-WAVY PRIMARY SURFACE; ELECTRICITY EFFICIENCIES; ENERGY MINIMA; GAS PASSAGE; HIGH STRESS; HIGH TEMPERATURE AND HIGH PRESSURE; HIGH TEMPERATURE AND PRESSURE; KEY COMPONENT; MICRO TURBINE; MICROTURBINE SYSTEM; NUMERICAL MODELS; OPTIMAL CONFIGURATIONS; STRENGTH PREDICTION; STRESS DISTRIBUTION; THERMO-MECHANICAL DESIGN; THREE-DIMENSIONAL STRESS;

EID: 70049110884     PISSN: None     EISSN: None     Source Type: Conference Proceeding    
DOI: 10.1115/GT2008-51506     Document Type: Conference Paper
Times cited : (2)

References (18)
  • 1
    • 0037562857 scopus 로고    scopus 로고
    • Recuperator considerations for future higher efficiency microturbines[J]
    • McDonald C.F., Recuperator considerations for future higher efficiency microturbines[J], Applied Thermal Engineering, 2003, 23:1463-1487.
    • (2003) Applied Thermal Engineering , vol.23 , pp. 1463-1487
    • McDonald, C.F.1
  • 2
    • 0036535513 scopus 로고    scopus 로고
    • Networked solid oxide fuel cell stacks combined with a gas turbine cycle[J]
    • Selimovic A, Palsson J. Networked solid oxide fuel cell stacks combined with a gas turbine cycle[J], Journal of Power Sources, 2002, 106:76-82.
    • (2002) Journal of Power Sources , vol.106 , pp. 76-82
    • Selimovic, A.1    Palsson, J.2
  • 3
    • 0030215675 scopus 로고    scopus 로고
    • McDonald C.F., Wilson D.G., The utilization of recuperated and regenerated engine cycles for high efficiency gas turbines in the 21st century [J], Journal of Applied Thermal Energy. 1996, 16(8/9): 635-653.
    • McDonald C.F., Wilson D.G., The utilization of recuperated and regenerated engine cycles for high efficiency gas turbines in the 21st century [J], Journal of Applied Thermal Energy. 1996, 16(8/9): 635-653.
  • 4
    • 0000535235 scopus 로고    scopus 로고
    • Heat recovery exchanger technology for very small gas turbines[J], Int
    • McDonald C.F., Heat recovery exchanger technology for very small gas turbines[J], Int. Journal of Turbo and Jet Engines, 1996,13(4):239-261.
    • (1996) Journal of Turbo and Jet Engines , vol.13 , Issue.4 , pp. 239-261
    • McDonald, C.F.1
  • 5
    • 0033908795 scopus 로고    scopus 로고
    • Low-cost compact primary surface recuperator concept for microturbines[J]
    • Colin F. McDonald, Low-cost compact primary surface recuperator concept for microturbines[J], Applied Thermal Engineering. 2000(20):471-497.
    • (2000) Applied Thermal Engineering , vol.20 , pp. 471-497
    • McDonald, C.F.1
  • 10
    • 10344266464 scopus 로고    scopus 로고
    • The use and performance of oxidation and creep-resistant stainless steels in an exhaust gas primary surface recuperator application
    • Rakowski J. M., Stinner C. P., Lipschutz M. et al, The use and performance of oxidation and creep-resistant stainless steels in an exhaust gas primary surface recuperator application, Proceedings of the ASME Turbo Expo 2004. 2004,6: 103-113.
    • (2004) Proceedings of the ASME Turbo Expo 2004 , vol.6 , pp. 103-113
    • Rakowski, J.M.1    Stinner, C.P.2    Lipschutz, M.3
  • 12
    • 0036693323 scopus 로고    scopus 로고
    • A numerical investigation of primary surface rounded cross wavy ducts
    • Utriainen E. and Sunden B., A numerical investigation of primary surface rounded cross wavy ducts, Heat and Mass Transfer ,2002, 38(7-8):537-542.
    • (2002) Heat and Mass Transfer , vol.38 , Issue.7-8 , pp. 537-542
    • Utriainen, E.1    Sunden, B.2
  • 13
    • 70049100455 scopus 로고    scopus 로고
    • A method and procedure of welding a cell and assembling them into a primary recuperator
    • in Chinese,Application number: 200510041940.6
    • Wang Q.W., Zhang D.J., A method and procedure of welding a cell and assembling them into a primary recuperator. Application number: 200510041940.6, 2005.(in Chinese)
    • (2005) Application
    • Wang, Q.W.1    Zhang, D.J.2
  • 14
    • 0003714019 scopus 로고    scopus 로고
    • 3rd Edition, Beijing, Higher Education Press, in Chinese
    • Yang S. M., Tao W. Q., Heat Transfer. 3rd Edition, Beijing, Higher Education Press.2002, 25-27. (in Chinese)
    • (2002) Heat Transfer , pp. 25-27
    • Yang, S.M.1    Tao, W.Q.2
  • 15
    • 27744489032 scopus 로고    scopus 로고
    • Liang H. X., Wang Q. W., Luo L. Q. et al, Numerical simulation of gas flow and heat transfer in cross-wavy primary surface channel for microtubine recuperators, ASME Turbo Expo 2005, GT2005- 68292.
    • Liang H. X., Wang Q. W., Luo L. Q. et al, Numerical simulation of gas flow and heat transfer in cross-wavy primary surface channel for microtubine recuperators, ASME Turbo Expo 2005, GT2005- 68292.
  • 16
    • 34848887777 scopus 로고    scopus 로고
    • Genetic algorithm optimization for primary surfaces recuperator of microturbine
    • Wang Q. W., Liang H. X., Xie G. N. et al, Genetic algorithm optimization for primary surfaces recuperator of microturbine. ASME J. Engineering for Gas Turbines and Powers, 2007, 129:436-442.
    • (2007) ASME J. Engineering for Gas Turbines and Powers , vol.129 , pp. 436-442
    • Wang, Q.W.1    Liang, H.X.2    Xie, G.N.3


* 이 정보는 Elsevier사의 SCOPUS DB에서 KISTI가 분석하여 추출한 것입니다.