Novel three-phase CM/DM conducted emission separator

IEEE Transactions on Industrial Electronics

Volumn 56, Issue 9, 2009, Pages 3693-3703

  Heldwein, Marcelo Lobo ^a   Biela, Jürgen ^b   Ertl, Hans ^c   Nussbaumer, Thomas ^d   Kolar, Johann W ^b  

^a FEDERAL UNIVERSITY OF SANTA CATARINA   (Brazil)

^b ETH ZURICH   (Switzerland)

^c VIENNA UNIVERSITY OF TECHNOLOGY   (Austria)

^d LEVITRONIX GMBH   (Switzerland)

Author keywords

Conducted emissions (CEs); Electromagnetic compatibility (EMC) measurements; EMC test setup; Noise separator

Indexed keywords

COMMONMODE; CONDUCTED EMISSIONS; CONDUCTED EMISSIONS (CES); DIFFERENTIAL-MODE NOISE; ELECTROMAGNETIC COMPATIBILITY (EMC) MEASUREMENTS; EMC TEST SETUP; FREQUENCY RESPONSE MEASUREMENT; ITS EVALUATION; MEASUREMENT CONDITIONS; NOISE SEPARATOR; THREE PHASE MOTOR;

ACTIVE NETWORKS; ELECTRIC DRIVES; ELECTRIC INVERTERS; ELECTROMAGNETISM; FREQUENCY RESPONSE; PASSIVE NETWORKS; PLASTIC MOLDS; SEPARATION; SEPARATORS;

ELECTROMAGNETIC COMPATIBILITY;

EID: 69349090419     PISSN: 02780046     EISSN: None     Source Type: Journal    
DOI: 10.1109/TIE.2009.2025287     Document Type: Article

References (23)

1. H. I. Hsieh, J. S. Li, and D. Chen, "Effects of X capacitors on EMI filter effectiveness," IEEE Trans. Ind. Electron., vol. 55, no. 2, pp. 949-955, Feb. 2008.
2. M. Jin and M. Weiming, "Power converter EMI analysis including IGBT nonlinear switching transient model," IEEE Trans. Ind. Electron., vol. 53, no. 5, pp. 1577-1583, Oct. 2006.
3. J.-S. Lai, X. Huang, E. Pepa, S. Chen, and T. W. Nehl, "Inverter EMI modeling and simulation methodologies," IEEE Trans. Ind. Electron. vol. 53, no. 3, pp. 736-744, Jun. 2006.
4. J. Meng, W. Ma, Q. Pan, Z. Zhao, and L. Zhang, "Noise source lumped circuit modeling and identification for power converters," IEEE Trans. Ind. Electron., vol. 53, no. 6, pp. 1853-1861, Dec. 2006.
5. M. M. Hernando, A. Fernandez, M. Arias, M. Rodriguez, Y. Alvarez, and F. Las-Heras, "EMI radiated noise measurement system using the source reconstruction technique," IEEE Trans. Ind. Electron., vol. 55, no. 9, pp. 3258-3265, Sep. 2008.
6. C. R. Paul and K. B. Hardin, "Diagnosis and reduction of conducted noise emissions," IEEE Trans. Electromagn. Compat., vol. 30, no. 4, pp. 553-560, Nov. 1988.
7. M. J. Nave, "A novel differential mode rejection network for conducted emissions diagnostics," in Proc. IEEE Nat. Symp. Electromagn. Compat., 1989, pp. 223-227.
8. M. J. Nave, Power Line Filter Design for Switched-Mode Power Supplies New York: Van Nostrand Reinhold, 1991.
9. T. Guo, D. Y. Chen, and F. C. Lee, "Separation of the common-mode- and differential-mode-conducted EMI noise," IEEE Trans. Power Electron. vol. 11, no. 3, pp. 480-488, May 1996.
10. K. Y. See, "Network for conducted EMI diagnosis," Electron. Lett. vol. 35, no. 17, pp. 1446-1447, Aug. 1999.
11. S. Wang, F. C. Lee, and W. G. Odendaal, "Characterization, evaluation, and design of noise separator for conducted EMI noise diagnosis," IEEE Trans. Power Electron., vol. 20, no. 4, pp. 974-982, Jul. 2005.
12. K. Jia, J. Wang, C. Wu, and C. Bi, "A new method for conducted EMI noise diagnosis," in Proc. 8th Int. Conf. Electron. Meas. Instruments, 2007, pp. 4-59-4-63.
13. M. Mardiguian and J. Raimbourg, "An alternate, complementary method for characterizing EMI filters," in Proc. IEEE Int. Symp. Electromagn. Compat., 1999, pp. 882-886.
14. L. Ran, J. C. Clare, K. J. Bradley, and C. Christopoulos, "Measurement of conducted electromagnetic emissions in PWM motor drive systems without the need for an LISN," IEEE Trans. Electromagn. Compat., vol. 41, no. 1, pp. 50-55, Feb. 1999.
15. A. De Bonitatibus, C. De Capua, and C. Landi, "A new method for conducted EMI measurements on three phase systems," in Proc. 17th IEEE Instrum. Meas. Technol. Conf., 2000, vol. 1, pp. 461-464.
16. L. Ran, S. Gokani, J. Clare, K. J. Bradley, and C. Christopoulos, "Conducted electromagnetic emissions in induction motor drive systems. Part I. Time domain analysis and identification of dominant modes," IEEE Trans. Power Electron., vol. 13, no. 4, pp. 757-767, Jul. 1998.
17. W. Shen, F. Wang, D. Boroyevich, and Y. Liu, "Definition and acquisition of CM and DM EMI noise for general-purpose adjustable speed motor drives," in Proc. IEEE Power Electron. Spec. Conf., 2004, vol. 2, pp. 1028-1033.
18. T. Nussbaumer, M. L. Heldwein, and J. W. Kolar, "Differential mode input filter design for a three-phase buck-type PWM rectifier based on modeling of the EMC test receiver," IEEE Trans. Ind. Electron., vol. 53, no. 5, pp. 1649-1661, Oct. 2006.
19. M. L. Heldwein, T. Nussbaumer, and J. W. Kolar, "Differential mode EMC input filter design for three-phase AC-DC-AC sparse matrix PWM converters," in Proc. IEEE Power Electron. Spec. Conf., Aachen, Germany, 2004, pp. 284-291, CD-ROM.
20. IEC Int. Special Committee Radio Interference - C.I.S.P.R., C.I.S.P.R. Specification for Radio Interference Measuring Apparatus and Measurement Methods - Publication 16, Geneva, Switzerland, 1977.
21. J. W. Kolar and H. Ertl, Vorrichtung zur Trennung der Funkstoerspannungen dreiphasiger Stromrichtersysteme in eine Gleich-und eine Gegentaktkomponente, Switzerland, 2004.
22. F. Beck and W. L. Klampfer, "Measurements of conducted voltage in the low-frequency range from 2 kHz to 30 MHz for high-current industrial applications with regeneration drives," in Proc. Int. Symp. Electromagn. Compat., 2004, vol. 1, pp. 5-10.
23. J. Biela and J. W. Kolar, "Using transformer parasitics for resonant converters - A review of the calculation of the stray capacitance of transformers," in Conf. Rec. IEEE IAS Annu. Meeting, Hong Kong, 2005, pp. 1868-1875.