Detection of the point of impact on a stiffened plate by the acoustic emission technique

Smart Materials and Structures

Volumn 18, Issue 3, 2009, Pages

  Kundu, Tribikram ^a   Das, Samik ^a   Jata, Kumar V ^b  

^a University of Arizona   (United States)

^b AIR FORCE RESEARCH LABORATORY   (United States)

Author keywords

[No Author keywords available]

Indexed keywords

ACOUSTIC EMISSION TECHNIQUES; ACOUSTIC SIGNALS; ALTERNATIVE METHODS; COMPOSITE PLATES; GUIDED WAVE; IMPACT PHENOMENA; IMPACT POINT; INHOMOGENEOUS PLATE; METAL BALL; OPTIMIZATION SCHEME; PASSIVE SENSOR; PING PONG; STIFFENED PLATE; TIME OF ARRIVAL; TRIANGULATION TECHNIQUES; ULTRASONIC SIGNALS; WAVE SPEED;

ACOUSTIC EMISSIONS; ACOUSTIC TRANSDUCERS; ACOUSTICS; PLATE METAL; TRIANGULATION; ULTRASONIC APPLICATIONS;

PLATES (STRUCTURAL COMPONENTS);

EID: 68549099956     PISSN: 09641726     EISSN: 1361665X     Source Type: Journal    
DOI: 10.1088/0964-1726/18/3/035006     Document Type: Article

References (32)

1. Kundu T, Das S and Jata K V 2007 Point of impact prediction in isotropic and anisotropic plates from the acoustic emission data J. Acoust. Soc. Am. 122 2057-66 (Pubitemid 47493335)
2. Kundu T, Das S, Martin S A and Jata K V 2008 Locating point of impact in anisotropic fiber reinforced composite plates Ultrasonics 48 193-201
3. Nagy P B, Adler L, Mih D and Sheppard W 1989 Single mode Lamb wave inspection of composite laminates Rev. Prog. Quant. Nondestruct. Eval. 8B 1535-42
4. Chimenti D E and Martin R W 1991 Nondestructive evaluation of composite laminates by leaky Lamb waves Ultrasonics 29 13-21
5. Mal A K, Yin C C and Bar-Cohen Y 1991 Ultrasonic nondestructive evaluation of cracked composite laminates Compos. Eng. 1 85-101
6. Kundu T, Maslov K I, Karpur P, Matikas T and Nicolaou P 1996 A Lamb wave scanning approach for mapping defects in [0/90] titanium matrix composites Ultrasonics 34 43-9
7. Yang R B and Mal A K 1996 Elastic waves in a composite containing inhomogeneous fibers Int. J. Eng. Sci. 34 67-79
8. Maslov K I and Kundu T 1997 Selection of Lamb modes for detecting internal defects in composite laminates Ultrasonics 35 141-50
9. Yang W and Kundu T 1998 Guided waves in multilayered anisotropic plates for internal defect detection ASCE J. Eng. Mech. 124 311-8
10. Kundu T, Potel C and de Belleval J F 2001 Importance of the near Lamb mode imaging of multilayered composite plates Ultrasonics 39 283-90
11. Alleyne D N and Cawley P 1992 The interaction of Lamb waves with defects IEEE Trans. Ultrason. Ferroelectr. Freq. Control 39 381-96
12. Ghosh T and Kundu T 1998 A new transducer holder mechanism for efficient generation and reception of Lamb modes in large plates J. Acoust. Soc. Am. 104 1498-502
13. Ghosh T, Kundu T and Karpur P 1998 Efficient use of Lamb modes for detecting defects in large plates Ultrasonics 36 791-801
14. Kundu T and Maslov K I 1997 Material interface inspection by Lamb waves Int. J. Solids Struct. 34 3885-901
15. Kundu T, Maji A, Ghosh T and Maslov K I 1998 Detection of kissing bonds by Lamb waves Ultrasonics 35 573-80
16. Jata K V, Kundu T and Parthasarathy T 2007 An introduction to failure mechanisms and ultrasonic inspection Advanced Ultrasonic Methods for Material and Structure Inspection (Newport Beach, CA: ISTE) chapter 1 pp1-42
17. Giurgiutiu V 2003 Lamb wave generation with piezoelectric wafer active sensors for structural health monitoring Proc. SPIE 505 111-22
18. Mal A K, Shih F and Banerjee S 2003 Acoustic emission waveforms in composite laminates under low velocity impact Proc. SPIE 5047 1-12
19. Mal A K, Ricci F, Gibson S and Banerjee S 2003 Damage detection in structures from vibration and wave propagation data Proc. SPIE 5047 202-10
20. Köhler B, Schubert F and Frankenstein B 2004 Numerical and experimental investigation of Lamb wave excitation, propagation and detection for SHM Proc. 2nd Eur. Workshop on Struct. Health Monitor. (Munich)
21. Park J and Chang F K 2003 Built-in detection of impact damage in multi-layered thick composite structures Proc. 4th Int. Workshop on Struct. Health Monitor. (Stanford, CA)
22. Mal A K, Ricci F, Banerjee S and Shih F 2005 A conceptual structural health monitoring system based on wave propagation and modal data Struct. Health Monit.: Int. J. 4 283-93
23. Manson G, Worden K and Allman D J 2003 Experimental validation of structural health monitoring methodology II: novelty detection on an aircraft wing J. Sound Vib. 259 345-63
24. Wang S C and Chang F K 2000 Diagnosis of impact damage in composite structures with built-in piezoelectrics network Proc. SPIE 3990 13-9
25. Kessler S S, Spearing S M and Soutis C 2002 Damage detection in composite materials using Lamb wave methods Smart Mater. Struct. 12 795-803
26. Kundu T, Das S and Jata K V 2007 Point of impact prediction in anisotropic fiber reinforced composite plates from the acoustic emission data Review of Progress in Quantitative Nondestructive Evaluation Conf. (Golden, CO)
27. Sachse W and Sancar S 1986 Acoustic emission source location on plate-like structures using a small array of transducers US Patent Specification 4,592,034
28. Castagnede B, Sachse W and Kim K Y 1989 Location of pointlike acoustic emission sources in anisotropic plates J. Acoust. Soc. Am. 86 1161-71
29. Kosel T, Grabec I and Muzic P 2000 Location of acoustic emission sources generated by air flow Ultrasonics 38 824-6
30. Ziola S M and Gorman M R 1991 Source location in thin plates using cross-correlation J. Acoust. Soc. Am. 90 2551-6
31. Gaul L and Hurlebaus S 1997 Identification of the impact location on a plate using wavelets Mech. Syst. Signal Process. 12 783-95
32. Nelder J A and Mead R 1965 A simplex method for function minimization Comput. J. 7 308-15