Multi-frequency identification method in signal processing

Digital Signal Processing: A Review Journal

Volumn 19, Issue 4, 2009, Pages 555-566

  Zhao, Sanxing ^a   Wang, Fengcai ^a   Xu, Hua ^b   Zhu, Jun ^b  

^a WUHAN UNIVERSITY OF SCIENCE AND TECHNOLOGY   (China)

^b XI'AN JIAOTONG UNIVERSITY   (China)

Author keywords

Frequency estimation; Multi frequency identification; Oil film coefficients; Signal processing

Indexed keywords

BANDPASS FILTERS; LEAST SQUARES APPROXIMATIONS; LUBRICATING OILS; SIGNAL PROCESSING;

FREQUENCY COMPONENTS; LEAST SQUARES METHODS; MULTI FREQUENCY; MULTI-FREQUENCY SIGNALS; OIL-FILM COEFFICIENTS; OPTIMIZATION PROCEDURES; SINE-WAVE SIGNALS; VIBRATION SIGNAL;

FREQUENCY ESTIMATION;

EID: 67349260436     PISSN: 10512004     EISSN: None     Source Type: Journal    
DOI: 10.1016/j.dsp.2008.07.008     Document Type: Article

References (18)

1. Zhu L.M., Song X.M., Li H.X., et al. High accuracy estimation of multi-frequency signal parameters by improved phase linear regression. Signal Process. 87 (2007) 1066-1077
2. Offelli C., and Petri D. Interpolation techniques for real-time multi-frequency waveform analysis. IEEE Trans. Instrum. Meas. 39 1 (1990) 106-111
3. Santamaria I., Pantaleon C., and Ibanez J. A comparative study of high-accuracy frequency estimation methods. Mech. Syst. Signal Process. 14 5 (2000) 819-834
4. A. Sarhegyi, Testing of analog-digital converters with sine wave fitting, Diploma thesis, Budapest University of Technology and Economics, Budapest, Hungary, May 14, 2004
5. Liu Y. Fast frequency estimation of single tone. J. Data Acquisition Process. 13 1 (1998) 7-11
6. Zhu L.M., Ding H., and Ding K. Phase regression approach for estimating the parameters of a noisy multi-frequency signal. IEE Proc.-Vision Image Signal Process. 151 5 (2004) 411-420
7. Markovskya I., and Huffel S.V. Overview of total least-squares methods. Signal Process. 87 (2007) 2283-2302
8. IEEE 1241-2000 Standard for Analog to Digital Converters (2001), The Institute of Electrical and Electronics Engineers, Inc., New York
9. Silva M.F.D., and Serra A.C. New methods to improve convergence of sine fitting algorithms. Comput. Stand. Interfaces 25 (2003) 23-31
10. Sheen Y.T. An analysis method for the vibration signal with amplitude modulation in a bearing system. J. Sound Vibrat. 303 (2007) 538-552
11. Jing J.P., Meng G., Sun Y., et al. On the non-linear dynamic behavior of a rotor-bearing system. J. Sound Vibrat. 274 (2004) 1031-1044
12. Jing J.P., Meng G., Sun Y., et al. On the oil-whipping of a rotor-bearing system by a continuum model. Appl. Math. Modell. 29 (2005) 461-475
13. Zhao S.X., Xu H., Meng G., et al. Stability and response analysis of symmetrical single-disk flexible rotor-bearing system. Tribol. Int. 38 (2005) 749-756
14. Kostrzewsky G.J., and Flack R.D. Accuracy evaluation of experimentally derived dynamic coefficients of fluid film bearings, Part I: Development of method. Tribol. Trans. 33 (1990) 105-114
15. Zhao S.X., Zhou H., Meng G., et al. Experimental identification of linear oil-film coefficients using least squares method in time domain. J. Sound Vibrat. 287 (2005) 809-825
16. Orfanidis S.J. Introduction to Signal Processing (1996), Pretice-Hall, Inc./A Simon & Schuster Company Chapter 13, pp. 734-755
17. L.A. Branagan, Thermal analysis of fixed and tilting pad-journal bearings including cross-film viscosity variations and deformations, PhD dissertation, University of Virginia, Charlottesville, VA, 1988
18. Qiu Z.L., and Tieu A.K. The effect of perturbation amplitudes on eight force coefficients of journal bearing. Tribol. Trans. 39 (1996) 469-475