One-dimensional Dynamic Modeling and Simulation of a Planar Direct Internal Reforming Solid Oxide Fuel Cell

Chinese Journal of Chemical Engineering

Volumn 17, Issue 2, 2009, Pages 304-317

  KANG, Yingwei ^a   LI, Jun ^a   CAO, Guangyi ^a   TU, Hengyong ^a   LI, Jian ^b   YANG, Jie ^b  

^a SHANGHAI JIAO TONG UNIVERSITY   (China)

^b HUAZHONG UNIVERSITY OF SCIENCE AND TECHNOLOGY   (China)

Author keywords

direct internal reforming; dynamic model; planar; simulation; solid oxide fuel cell

Indexed keywords

AIR FLOW RATES; ANODE GAS; BENCHMARK TESTS; CELL TEMPERATURES; CELL VOLTAGES; CO FLOWS; CURRENT DENSITY DISTRIBUTIONS; DIRECT INTERNAL REFORMING; FUEL FLOW RATES; GAS COMPOSITIONS; INLET AIRS; INTERNATIONAL ENERGY AGENCIES; LOAD CURRENTS; MANIPULATED VARIABLES; MASS AND ENERGY BALANCES; MODEL-BASED SIMULATIONS; MOLAR FRACTIONS; ONE-DIMENSIONAL; OPERATING CONDITIONS; OPERATING PARAMETERS; PLANAR; SIMULATION; SLOW DYNAMICS; SOLID TEMPERATURES; SOLUTION STRATEGIES; STEADY-STATE PERFORMANCE; TRANSIENT BEHAVIORS;

AIR; CELLS; DYNAMIC RESPONSE; DYNAMICS; ELECTROCHEMISTRY; FLOW RATE; SOLID OXIDE FUEL CELLS (SOFC);

DYNAMIC MODELS;

EID: 65449160228     PISSN: 10049541     EISSN: None     Source Type: Journal    
DOI: 10.1016/S1004-9541(08)60209-8     Document Type: Article

References (22)

1. Singhal S.C., Kendall K., and Ormerod R.M. In: Singhal S.C., and Kendall K. (Eds). High Temperature Solid Oxide Fuel Cells: Fundamentals, Design and Applications (2003), Elsevier Advanced Technology, UK 333-341 1-2
2. Ferguson J.R., Fiard J.M., and Herbin R. "Three-dimensional numerical simulation for various geometries of solid oxide fuel cells". J. Power Sources 58 (1996) 109-122
3. Selimovic, A., "Modelling of solid oxide fuel cells applied to the analysis of integrated systems with gas turbines", Ph. D. Thesis, Lund Univ., Sweden (2002).
4. Li P., and Chyu M.K. "Simulation of the chemical/electrochemical reactions and heat/mass transfer for a tubular SOFC in a stack". J. Power Sources 124 (2003) 487-498
5. Nikooyeh K., Jeje A.A., and Hill J.M. "3D modeling of anode-supported planar SOFC with internal reforming of methane". J. Power Sources 171 (2007) 601-609
6. Hall D.J., and Colclaser R.G. "Transient modeling and simulation of a tubular solid oxide fuel cell". IEEE Trans. Energ. Conv. 14 (1999) 749-753
7. Xue X., Tang J., Sammes N., and Du Y. "Dynamic modeling of single tubular SOFC combining heat/mass transfer and electrochemical reaction effects". J. Power Sources 142 (2005) 211-222
8. Achenbach E. "Three-dimensional and time-dependent simulation of a planar solid oxide fuel cell stack". J. Power Sources 49 (1994) 333-348
9. Achenbach E. "Response of a solid oxide fuel cell to load change". J. Power Sources 57 (1995) 105-109
10. Aguiar P., Adjiman C.S., and Brandon N.P. "Anode-supported intermediate temperature direct internal reforming solid oxide fuel cell (I) Model-based steady-state performance". J. Power Sources 138 (2004) 120-136
11. Aguiar P., Adjiman C.S., and Brandon N.P. "Anode-supported intermediate-temperature direct internal reforming solid oxide fuel cell (II) Model-based dynamic performance and control". J. Power Sources 147 (2005) 136-147
12. Braun, R.J., "Optimal design and operation of solid oxide fuel cell systems for small-scale stationary applications", Ph. D. Thesis, Univ. of Wisconsin-Madison, USA (2002).
13. 2 system at the interface of a Ni-YSZ cermet electrode and YSZ electrolyte". J. Electrochem. Soc. 147 (2000) 1630-1635
14. Achenbach E., and Riensche E. "Methane/steam reforming kinetics for solid oxide fuel cells". J. Power Sources 52 (1994) 283-288
15. Campanari S., and Iora P. "Definition and sensitivity analysis of a finite volume SOFC model for a tubular cell geometry". J. Power Sources 132 (2004) 113-126
16. Bossel U.G. Final Report on SOFC Data: Facts and Figures (1992), Swiss Federal Office of Energy, Berne
17. Kyle B.G. Chemical and Process Thermodynamics (1984), Prentice Hall, Englewood Cliffs
18. Chan S.H., Khor K.A., and Xia Z.T. "A complete polarization model of a solid oxide fuel cell and its sensitivity to the change of cell component thickness". J. Power Sources 93 (2001) 130-140
19. Costamagna P., and Honegger K. "Modeling of solid oxide heat exchanger integrated stacks and simulation at high fuel utilization". J. Electrochem. Soc. 145 (1998) 3995-4007
20. Larminie J., and Dicks A. Fuel Cell Systems Explained (2000), John Wiley & Sons, Chichester 51
21. Patankar S.V. Numerical Heat Transfer and Fluid Flow (1980), Hemisphere, Washington
22. Yu L.J., Yuan J.Q., Cao G.Y., and Jiang X.M. "Numerical simulation of dynamic performance of the molten carbonate fuel cell". Chin. J. Chem. Eng. 12 (2004) 272-276