Numerical study of rate-dependent strength behavior under ramp and shock wave loading

International Journal of Plasticity

Volumn 25, Issue 4, 2009, Pages 695-714

  Ding, J L ^a   Asay, J R ^b  

^a Washington State University   (United States)

^b SANDIA NATIONAL LABORATORIES   (United States)

Author keywords

Material dissipation; Ramp wave; Shock wave; Strength; Viscoplasticity

Indexed keywords

DEFORMATION; LOADING; MATERIALS; MECHANICAL WAVES; PLASTICITY; SHOCK WAVES; STRESSES; VISCOPLASTICITY; VISCOSITY;

ARBITRARY MODELS; CAUSE AND EFFECT ANALYSIS; DEFORMATION HISTORY; DEGREE OF INTERACTIONS; DIRECT MEASUREMENTS; EFFECTIVE TOOLS; EXTERNAL LOADINGS; INTRINSIC STRENGTHS; MATERIAL RESPONSE; MATERIAL STRENGTHS; MECHANICAL RESPONSE; NUMERICAL STUDIES; RAMP WAVE; RATE SENSITIVITIES; RESEARCH OBJECTIVES; RISETIMES; SHOCK-WAVE LOADINGS; SIMULATION-BASED; STRAIN RATE HISTORY; STRENGTH; STRENGTH BEHAVIORS; THERMAL DISSIPATIONS; TRIAL AND ERRORS; WAVE PROFILES;

STRAIN RATE;

EID: 60849108619     PISSN: 07496419     EISSN: None     Source Type: Journal    
DOI: 10.1016/j.ijplas.2008.12.002     Document Type: Article

References (20)

1. Asay J.R. Isentropic compression experiments on the Z accelerator. In: Chhabildas L.C., and Hixson R.S. (Eds). Shock Compression of Condensed Matter Furnish 2000 (1999), American Institute of Physics 261-266
2. Barker L.M., and Hollenbach R.E. Laser interferometer for measuring high velocities of any reflecting surface. J. Appl. Phys. 43 (1972) 4669-4675
3. Ding J.L. Thermal and mechanical analysis of material response to non-steady ramp and steady shock wave loading. J. Mech. Phys. Solids 56 (2006) 237-265
4. Ding J.L., and Asay J.R. Material characterization with ramp wave experiments. J. Appl. Phys. 101 5 (2007)
5. Dwivedi S.K., Ding J.L., and Gupta Y.M. Computational study of interface effect on impact load spreading in SiC multilayered targets. Int. J. Comput. Meth. 2 3 (2005) 341-373
6. Fowles G.R. Shock wave compression of hardened and annealed 2024 aluminum. J. Appl. Phys. 32 8 (1960) 1475-1487
7. Gupta Y.M. COPS Wave Propagation Code (1978), SRI International, Menlo Park, CA
8. Gupta Y.M., and Ding J.L. Impact load spreading in layered materials and structures: concept and quantitative measure. Int. J. Impact Eng. 27 3 (2002) 277-291
9. Hall C.A., et al. Experimental configuration for isentropic compression of solids using pulsed magnetic loading. Rev. Sci. Instrum. 72 9 (2001) 3587-3595
10. Huang H., and Asay J.R. Compressive strength measurement in aluminum for shock compression over the stress range of 4-22 GPa. J. Appl. Phys. 98 3 (2005) 033524
11. Huang H., and Asay J.R. Reshock response of shock deformed aluminum. J. Appl. Phys. 100 4 (2006) 043514
12. Lorentz K.T., Edwards M.J., Glendinning S.G., Jankowski A.F., McNaney J., Pollaine S.M., and Remington B.A. Accessing ultrahigh-pressure, quasi-isentropic states of matter. Phys. Plasmas 12 (2005) 056309
13. Marsh S.P. LASL Shock Hugoniot Data (1980), University of California Press, Berkeley
14. Martin L.P., Orlikowski D., and Nguyen J.H. Fabrication and characterization of graded impedance impactor for gas gun experiments from tape cast metal powders. Mater. Sci. Eng. A427 (2006) 83-91
15. Robbins J.R., Ding J.L., and Gupta Y.M. Load spreading and penetration resistance of layered structures - a numerical study. Int. J. Impact Eng. 30 6 (2004) 593-615
16. Steinberg D.J., Cochran S.G., and Guinan M.W. A constitutive model for metals applicable at high strain rate. J. Appl. Phys. 51 3 (1980) 1498-1504
17. Swegle J.W., and Grady D.E. Shock viscosity and the prediction of shock wave rise times. J. Appl. Phys. 58 2 (1985) 692-701
18. Walsh, R.T., 1973. Finite difference method. In: Chou, P.C., Hopkins, A.K. (Ed.), Dynamic Response of Materials to Intense Impulsive Loading, USA, pp. 363-403.
19. Wallace D.C. Irreversible thermodynamics of flow in solids. Phys. Rev. B 22 4 (1980) 1477-1486
20. Wallace D.C. Nature of the process of overdriven shocks in metals. Phys. Rev. B 24 10 (1981) 5607-5615