Fabrication of large preforms for low-loss single-mode optical fibers by a hybridized process

Glass Science and Technology: Glastechnische Berichte

Volumn 69, Issue 12, 1996, Pages 412-416

  Yoshida, Kazuaki ^a   Satoh, Tsuguo ^a   Enomoto, Noritsugu ^a   Yagi, Takeshi ^a   Hihara, Hiroshi ^a   Oku, Masato ^a  

^a FURUKAWA ELECTRIC CO LTD   (Japan)

Author keywords

[No Author keywords available]

Indexed keywords

EID: 5844412999     PISSN: 09467475     EISSN: None     Source Type: Journal    
DOI: None     Document Type: Article

References (6)

1. Dorn, R.; Baumgärtner, A.; Gutu-Nelle, A. et al.: Mechanical shaping of preforms for low loss at low cost. J. Opt. Commun. 10 (1989) no. 1, p. 2-5.
2. Dorn, R.: Baumgärtner, A.; Göth, A. et al.: 0.27 dB/km attenuation achieved by MSP preform process. J. Lightwave Technol. 9 (1991) no. 6, p. 709-714.
3. MacChesney, J. B.; Johnson, D. W.; Fleming, D. A. et al.: Hybridised sol-gel process for optical fibers. Electron. Lett. 23 (1987) no. 19, p. 1005-1007.
4. Yoshida, K.; Satoh, T.; Enomoto, N. et al.: New hybridized fabrication process for optical fibers. Electron. Lett. 32 (1996) p. 242-243.
5. MacChesney, J. B.; Johnson, D. W.; Fleming, D. A. et al.: Influence of dehydration/sintering conditions on the distribution of impurities in sol-gel derived silica glass. Mater. Res. Bull. 22 (1987) p. 1209-1216.
6. Clasen, R.: Optical impurity measurements on silica glass prepared via the colloidal gel route. Glastech. Ber. 63 (1990) no. 10, p. 291-299.