Flow boiling of R134a and ammonia in a plate heat exchanger

International Journal of Heat and Mass Transfer

Volumn 51, Issue 25-26, 2008, Pages 6235-6242

  Djordjevic, E ^a   Kabelac, S ^b  

^a UNIVERSITY OF BELGRADE   (Serbia)

^b HELMUT SCHMIDT UNIVERSITY   (Germany)

Author keywords

Ammonia; Evaporation; Heat transfer coefficient; Plate heat exchanger; R134a

Indexed keywords

AMMONIA; ETHYLENE GLYCOL; EVAPORATION; GLYCOLS; HEAT EXCHANGERS; HEAT FLUX; HEAT TRANSFER COEFFICIENTS; HEATING EQUIPMENT; MOISTURE; PLATES (STRUCTURAL COMPONENTS); SOLAR WATER HEATERS; THERMOANALYSIS; VAPORS;

BOILING CORRELATIONS; CORRUGATED PLATES; COUNTER FLOWS; EVAPORATION HEAT TRANSFERS; FLOW BOILING; HEAT TRANSFER MECHANISMS; LIMITED DATUMS; LOCAL HEAT TRANSFER COEFFICIENTS; MASS FLUXES; OVERALL PERFORMANCES; PARALLEL FLOWS; PHASE DISTRIBUTIONS; PLATE HEAT EXCHANGER; PLATE HEAT EXCHANGERS; R134A; SATURATION TEMPERATURES; SECONDARY FLUIDS; VAPOR QUALITIES;

HEAT TRANSFER;

EID: 55649111358     PISSN: 00179310     EISSN: None     Source Type: Journal    
DOI: 10.1016/j.ijheatmasstransfer.2008.01.042     Document Type: Article

References (18)

1. Steiner D., and Taborek J. Flow boiling heat transfer in vertical tubes correlated by an asymptotic model. Heat Transfer Eng. 13 (1992) 43-69
2. see also:. Steiner D. Stroemungssieden gesaettigter Fluessigkeiten. VDI-Waermeatlas. 10th ed. (2006), Springer, Berlin (Chapter Hbb)
3. Danilova D.N., et al. Heat transfer in different plate geometries. Kholod. Tek. 4 (1981) 25-31
4. see also:. Osterberger R., and Slipcevic B. Waermeuebergang beim Blasensieden in Plattenverdampfern (Heat Transfer at Nucleate Boiling in Plate Heat Exchangers). Ki Klima-Kälte-Heizung 11 (1990) 481-483
5. Yan Y.Y., and Lin T.F. Evaporation heat transfer and pressure drop of refrigerant R134a in a plate heat exchanger. ASME J. Heat Transfer 121 (1999) 118-127
6. Hsieh Y., and Lin T.P. Saturated flow boiling heat transfer and pressure drop of refrigerant R410A in a vertical plate heat exchanger. Int. J. Heat Mass Transfer 125 (2003) 852-857
7. S. Wellsandt, Heat transfer and pressure drop in a plate type evaporator, Ph.D. Thesis, Department of Heat and Power Technology at Chalmers University of Technology, Gothenburg, Sweden, 2001.
8. G. Longo, A. Gasparella, Experimental heat transfer coefficients and pressure drop during refrigerant R134a vaporization inside a commercial brazed plate heat exchanger, in: Proceedings of the IIR Conference, Vicenza, Italy, 2005.
9. Longo G., Gasparella A., and Sartori R. Experimental heat transfer coefficients during refrigerant vaporisation and condensation inside herringbone-type plate heat exchangers with enhanced surfaces. Int. J. Heat Mass Transfer 47 (2004) 4125-4136
10. Sterner D., and Sunden B. Performance of plate heat exchangers for evaporation of ammonia. Heat Transfer Eng. 27 (2006) 45-55
11. Han D.-H., Lee K.-J., and Kim Y.-H. Experiments on the characteristics of evaporation of R410A in brazed plate heat exchangers with different geometric configurations. Appl. Therm. Eng. 23 10 (2003) 1209-1225
12. Thonon B., Feldman A., Margat L., and Marvillet C. Transition from nucleate boiling to convective boiling in compact heat exchangers. Int. J. Refrigerat. 20 8 (1997) 592-597
13. Vist S., and Pettersen J. Two-phase flow distribution in compact heat exchanger manifolds. Exp. Therm. Fluid Sci. 28 (2004) 209-215
14. Watel B. Review of saturated flow boiling in small passages of compact heat exchangers. Int. J. Therm. Sci. 42 (2003) 107-140
15. M. André, Waermeuebergang bei der Verdampfung von Ammoniak in Plattenwaerme- uebertragern (Heat transfer during evaporation of ammonia in plate heat exchangers), Ph.D. Thesis, Institute of Thermodynamics, University of Hannover, Germany, 2004.
16. Martin H. A theoretical approach to predict the performance of chevron-type plate heat exchangers. Chem. Eng. Process. 35 (1996) 301-310
17. Shah R.K., and Focke W. Plate heat exchangers and their design theory. Heat Transfer Equipment Design (1988), Hemisphere Publ. Corp., New York
18. Baehr H.-D., and Stephan K. Heat and Mass Transfer (1998), Springer Corp., Berlin