An investigation of unburnned hydrocarbon emissions in wall guided, low temperature diesel combustion

Oil and Gas Science and Technology

Volumn 63, Issue 4, 2008, Pages 433-459

  Kashdan, Julian ^a   Mendez, Sylvain ^a   Bruneaux, Gilles ^a  

^a IFP ENERGIES NOUVELLES   (France)

Author keywords

[No Author keywords available]

Indexed keywords

COMBUSTION; COMBUSTION CHAMBERS; CYLINDERS (SHAPES); DIESEL ENGINES; ENGINE CYLINDERS; ENGINES; FLUORESCENCE; FUELS; HYDROCARBONS; LASER PRODUCED PLASMAS; LEAKAGE (FLUID); LIQUID FILMS; ORGANIC COMPOUNDS; QUENCHING; SMOKE; STANDARDS; THERMOCHEMISTRY; THIN FILMS;

BULK QUENCHING; CREVICE VOLUMES; DIESEL COMBUSTIONS; EXPERIMENTAL DATUMS; FILM FORMATIONS; FLASH BOILING; FORMATION MECHANISMS; FUEL FILMS; FUEL OXIDATIONS; GLOBAL EQUIVALENCE RATIOS; HC EMISSIONS; HYDROCARBON EMISSIONS; INJECTION TIMINGS; INTAKE TEMPERATURES; LOCAL EQUIVALENCE RATIOS; LOW LOADS; LOW TEMPERATURES; OPTICAL ACCESSES; OPTICAL-; SINGLE CYLINDER ENGINES; UNBURNED FUELS; UNBURNED HYDROCARBONS;

ENGINE PISTONS;

COMBUSTION; DIESEL; EMISSION; HYDROCARBON; OXIDATION;

EID: 54949138857     PISSN: 12944475     EISSN: None     Source Type: Journal    
DOI: 10.2516/ogst:2008018     Document Type: Article

References (23)

1. Christensen M., Johansson B., Hultqvist A. (2001) The Effect of Piston Topland Geometry on Emissions of Unburned Hydrocarbons from a Homogeneous Charge Compression Ignition (HCCI) Engine, SAE technical paper 2001-01-1893.
2. Aceves S.M., Flowers D.L., Espinoza-Loza F., Martinez-Frias J., Dibble R.W., Christensen M., Johansson B., Hessel R.P. (2002) Piston-Liner Crevice Geometry Effect on HCCI Combustion by Multi-Zone Analysis, SAE technical paper 2002-01-2869.
3. Heywood J.B. (1988) Internal Combustion Engine Fundamentals, McGraw-Hill, New York.
4. Iida M., Hayashi M., Foster D.E., Martin J.K. (2003) Characteristics of Homogeneous Charge Compression Ignition (HCCI) Engine Operation for Variations in Compression Ratio, Speed and Intake Temperature while using n-Butane as a Fuel, Trans. ASME 125, 472-478.
5. Kook S., Bae C., Miles P.C., Choi D., Pickett L.M. (2005) The Influence of Charge Dilution and Injection Timing on Low-Temperature Diesel Combustion and Emissions, SAE technical paper 2005-01-3837.
6. Kook S., Bae C., Miles P.C., Choi D., Bergin M., Reitz R.D. (2006) The Effect of Swirl Ratio and Fuel Injection Parameters on CO Emission and Fuel Conversion Efficiency for High-Dilution, Low-Temperature Combustion in an Automotive Diesel Engine, SAE technical paper 2006-01-0197.
7. Kashdan J.T., Docquier N., Bruneaux G. (2004) Mixture Preparation and Combustion via LIEF and LIF of Combustion Radicals in a Direct-Injection, HCCI Diesel Engine, SAE technical paper 2004-01-2945.
8. Walter B., Gatellier B. (2002) Development of the High Power NADI Concept Using Dual Mode Diesel Combustion to Achieve Zero NOx and Particulate Emissions, SAE technical paper 2002-01-1744.
9. Siebers D.L. (1998) Liquid-Phase Fuel Penetration in Diesel Sprays, SAE technical paper 980809.
10. Siebers D.L. (1999) Scaling Liquid-Phase Fuel Penetration in Diesel Sprays Based on Mixing-Limited Vaporization, SAE technical paper 1999-01-0528.
11. Kimura S., Aoki O., Kitahara Y., Aiyoshizawa E. (2001) Ultra-Clean Combustion Technology Combining a Low-Temperature and Premixed Combustion Concept For Meeting Future Emissions Standards, SAE technical paper 2001-01-0200.
12. Lachaux T., Musculus M.P.B. (2006) In-Cylinder Unburned Hydrocarbon Visualisation During Low-Temperature Compression-Ignition Engine Combustion Using Formaldehyde PLIF, Proc. 31st Combustion Symp. 2006, Heidelberg, Germany, 6-11 August 2006.
13. Kashdan J.T., Papagni, J.-F. (2005) LIF Imaging of Auto-Ignition and Combustion in a Direct-Injection Diesel-Fuelled, HCCI Engine, SAE technical paper 2005-01-3739.
14. Schulz C., Gronki J., Andersson S. (2004) Multi-Species Laser-Based Imaging Measurements in a Diesel Spray, SAE technical paper 2004-01-1917.
15. Bruneaux G. (2007) Study of the Correlation Between Mixing and Auto-ignition Processes in High Pressure Diesel Jets, SAE technical paper 2007-01-0650.
16. Sjöberg M., Dec J.E., Babjimopoulos A., Assanis D. (2004) Comparing Enhanced Natural Thermal Stratification against Retarded Combustion Phasing for Smoothing of HCCI Heat-Release Rates, SAE technical paper 2004-01-2994.
17. Dec J.E., Hwang W., Sjöberg M. (2006) An Investigation of Thermal Stratification in HCCI Engines using Chemiluminescence Imaging, SAE technical paper 2006-01-1518.
18. Stevens E., Steeper R. (2001) Piston Wetting in an Optical DISI Engine: Fuel Films, Pool Fires and Soot Generation, SAE technical paper 2001-01-1203.
19. Witze P.O., Green R.M. (1997) LIF and Flame-Emission Imaging of Liquid Fuel Films and Pool Fires in an SI Engine During a Simulated Cold Start, SAE technical paper 970866.
20. Witze P.O., Green R.M. (2005) Comparison of Single and Dual Spray Fuel Injectors During Cold Start of a PFI Spark-Ignition Engine Using Visualization of Liquid Fuel Films and Pool Fires, SAE technical paper 2005-01-3863.
21. Dec J.E. (2002) A Computational Study of the Effects of Low Fuel Loading and EGR on Heat Release Rates and Combustion Limits in HCCI Engines, SAE technical paper 2002-01-1309.
22. Dec J.E., Sjöberg M. (2003) A Parametric Study of HCCI Combustion - The Sources of Emissions at Low Loads and the Effects of GDI Fuel Injection, SAE technical paper 2003-01-0752.
23. Marriott C.D., Reitz R.D. (2002) Experimental Investigation of Direct Injection Gasoline for Premixed Compression Ignited Combustion Phasing Control, SAE technical paper 2002-01-0418.