Air-cooling used for metal cutting

American Journal of Applied Sciences

Volumn 6, Issue 2, 2009, Pages 251-262

  Boswell, Brian ^a   Chandratilleke, Tilak T ^a  

^a CURTIN UNIVERSITY   (Australia)

Author keywords

Air cooled; Coefficient of performance; Cold fraction; Environmentally friendly; Flank wear; Tool life; Vortex tube

Indexed keywords

EID: 52949120981     PISSN: 15469239     EISSN: 15543641     Source Type: Journal    
DOI: 10.3844/ajas.2009.251.262     Document Type: Article

References (12)

1. Silverman, M.P., 1993. The Wirbelrohr's Roar. Cambridge University Press, Chpt 6, pp: 221-240.
2. Ranque, G., 1993. Experiences sur la détente giratore avee productions simulanees d'un echappement d'air chaud et d'um echappement d'air froid. Bull. Soc. France Phys., 1129: (J. Phys. Radium, 4, Ser.7).
3. Dissler, R.G. and M. Permutter, 1960. Analysis of the flow and energy separation in a turbulent vortex. Int. J. Heat Mass Transfer, 1: 173-191.
4. Gulyaev, A., 1966. Vortex tube and the vortex effect, soviet physics. Tech. Phys., 10 (10): 326-331.
5. Hilsch, R., 1947. The use of the expansion of gases in a centrifugal field as cooling process. Rev. Sci. Instrum., 18 (2): 108-1113.
6. Lewins J, and A. Benjan, 1999. Vortex tube optimisation theory. J. Energy, 24: 931-943.
7. Saidi, M.H. and M.R. Allaf Yazdi, 1999. Energy model of a vortex tube system with experimental results. J. Energy, 24: 625-632.
8. Ay, H. and W.J. Yang, 1999. Heat transfer and life of metal cutting tools in turning. Int. J. Heat Mass Trans., 41: 613-623.
9. O'Sullivan, D. and M. Cotterell, 2001. Temperature measurement in single turning point. J. Master. Proc. Tech., 118: 301-308.
10. Young, H.T., 1996. Cutting temperatures to flank wear. Wear, 201: 117-120.
11. Cook, N., 1973. Tool wear and tool life. ASME Tran. J. Energy. Ind., 95: 931-938.
12. Liu, J., 2005. Research on experiments and action mechanism with water vapour as coolant and lubricant in green cutting, Int. J. Mach. Tools Manuf., 45: 687-694.