Chip root tests using PCD and MCD cutting tools

Industrial Diamond Review

Volumn 57, Issue 574, 1997, Pages 96-101

  Byrne, G ^a   Heinzl, J ^b   Barry, J ^a   Eitzenberger, H ^b  

^a UNIVERSITY COLLEGE DUBLIN   (Ireland)

^b TECHNICAL UNIVERSITY OF MUNICH   (Germany)

Author keywords

[No Author keywords available]

Indexed keywords

EID: 5244224750     PISSN: 00198145     EISSN: None     Source Type: Journal    
DOI: None     Document Type: Article

References (13)

1. H. Steidle. Machining bores in aluminium alloys, Industrial Diamond Review, 6/87.
2. L.F. Mondolfo. Aluminium alloys (structures and properties), 1976, Butterworths, London.
3. J.L. Jorstad. Influence of aluminium casting metallurgical factors on machinability, SAE (Society of Automotive Engineers) technical paper No. 800486, 1980.
4. P.M. Noaker. The well honed competitive edge, Manufacturing Engineering, 1995, Vol. 115(3).
5. K.S. Moon, J.W. Sutherland. The origin and interpretation of spatial frequencies in a turned surface profile, Trans ASME, Eng Ind , 1994, Vol. 116.
6. W. König, A. Neises. Wear mechanisms of ultrahard nonmetallic cutting tools. Wear, 1993, Vol. 162-164.
7. D. Keen. An investigation of the possible advantages of using polycrystalline diamond tools instead of single-crystal diamond tools for turning AISi alloy. Wear, 1974, Vol. 28.
8. F. Setz. Untersuchungen zur Entstehung der Schnittflächenrauheit bei der spanenden Bearbeitung (Studies into the development of surface roughness in metal cutting), PhD thesis, 1971, ETH Zurich, Switzerland.
9. H. Eitzenberger. Guidance and roughness, Proceedings of the Third International Conference on Ultra-precision in Manufacturing Engineering, 2-6 May 1994, Aachen, Germany.
10. J. Barry, P. Young, G. Byrne. Surface integrity of AISi9 alloy machined with polycrystalline diamond tools, Proceedings 13 Conf. of the Irish Manufacturing Committee.
11. D. Haslam, C. Rubenstein. Surface and sub-surface work-hardening produced by the planing operation, Annals of the CIRP, 1970, Vol. 18
12. M.C. Shaw. Metal cutting principles, 1983, Oxford Sci. Publ., London.
13. N. Ikawa, R.R. Donaldson, R. Komanduri, W. König, P.A. McKeown, I.F. Stowers. Ultraprecision metal cutting - the past, the present and the future, Annals of the CIRP1 1991, Vol. 40/2, pp 587-593.