Influence of drying strategy on coating layer structure formation

Nordic Pulp and Paper Research Journal

Volumn 23, Issue 1, 2008, Pages 46-51

  Sand, Anders ^a   Toivakka, Martti ^a   Hjelt, Tuomo ^b  

^a ÅBO AKADEMI UNIVERSITY   (Finland)

^b KCL   (Finland)

Author keywords

Consolidation; Drying; Dynamics; Micro structure; Pigment coating; Simulation

Indexed keywords

BROWNIAN MOVEMENT; CALCIUM CARBONATE; COATINGS; DRYING; PLANNING; THICKNESS MEASUREMENT;

COATING LAYER; DYNAMIC MICROSTRUCTURES; LAYER STRUCTURES; MICRO-STRUCTURES; MICROSTRUCTURE DEVELOPMENT; PARTICLES DISTRIBUTION; PIGMENT COATING; SIMULATION; SMALL PARTICLES; STRUCTURE FORMATIONS;

MICROSTRUCTURE;

CALCIUM CARBONATE; COATINGS; DRYING; MICROSTRUCTURE; PLANNING; SIMULATION;

EID: 50949085866     PISSN: 02832631     EISSN: None     Source Type: Journal    
DOI: 10.3183/npprj-2008-23-01-p046-051     Document Type: Article

References (45)

1. Ackler, H., French, R. and Chiang, Y.-M. (1996): Comparisons of Hamaker Constants for Ceramic Systems with Intervening Vacuum or Water: From Force Laws and Physical Properties, J. Colloid Interface Sci. 179, 460.
2. Al-Turaif, H. and Lepoutre, P. (2000): Evolution of Surface Structure and Chemistry of Pigmented Coatings During Drying, Prog. Org. Coat. 38(1), 43.
3. Bousfield, D. (1990): The Simulation of Pigment Motion During Blade Coating, Tappi Coat. Conf., May 13-16, Boston, MA, 325.
4. Brady, J.F. and Bossis, G. (1988): Stokesian Dynamics, Annu. Rev. Fluid Mech. 20, 111.
5. Dappen, J. (1951): Distribution of Starch in Clay Coatings, Tappi, 34(7), 324.
6. Dubé, M. and Daneault, C. (2006): Front Instability in Drying of Paper Coatings, Nord. Pulp Paper Res. J. 21(5), 676.
7. Eksi, G. and Bousfield, D. (1997): Modeling of Coating Structure Development, Tappi J. 80(2), 125.
8. Engström, G. (1986): Die Entwicklung des Feststoffgehaltes in der Strichschicht zwischen Auftrag und Blade, Wochenbl. Papierfabr. 114(6), 195.
9. Engström, G., Rigdahl, M., Kline, J. and Ahlroos, J. (1991): Binder Distribution and Mass Distribution of the Coating Layer - Cause and Consequence. Tappi Coat. Conf., May 19-22, Montreal, Quebec, 169.
10. Engström, G. (1994): Formation and Consolidation of a Coating Layer and the Effect on Offset-Print Mottle, Tappi J. 77(4), 160.
11. Eriksson, U., Rigdahl, M. (1994): Dewatering of Coating Colours Containing CMC or Starch, J. Pulp Paper Sci. 20(11), J333.
12. Eriksson, R., Merta, J. and Rosenholm, J. (2007): The calcite/water interface I: Surface Charges in Indifferent Electrolyte Media and the Influence of Low Molecular Weight Polyelectrolyte, J. Colloid Interface Sci. 313(1), 184.
13. Heikkilä, P. (1993): A Study on the Drying Process of Pigment Coated Paper Webs, Ph. D. Thesis, Process Design Laboratory, Åbo Akademi University, Turku, Finland.
14. Hiorns, T. and Nesbitt, T. (2003): Particle Packing of Blocky and Platey Pigments - A Comparison of Computer Simulations and Experimental Results, Tappi Adv. Coat. Fund. Symp., May 8-10, Chicago, IL, 252.
15. Inoue, T., Matsubayashi, H., Kline, J. and Janes, R. (1992): Effect of Coating Structure on Ink Absorption Mottle, Tappi Int. Print. Graph. Arts Conf., October 18-21, Pittsburgh, PA, 33.
16. Järnström, J., Peltonen, J., Sinervo, L. and Toivakka, M. (2006): Topography and Gloss of Paper Coating Layers, Tappi Adv. Coat. Fund. Symp., February 8-10, Turku, Finland, 329.
17. Kugge, C. (2003): Consolidation and Structure of Paper Coating and Fibre Systems, Ph. D. Thesis, KTH, Stockholm, Sweden.
18. Lepoutre, P. (1989): The Structure of Paper Coatings: An Update, Prog. Org. Coat. 17, 89.
19. Letzelter, R. and Eklund, D. (1993a): Coating Color Dewatering in Blade Coaters, Part 1: Mathematical Model and the Influence of Color Parameters, Tappi J. 76(5), 63.
20. Letzelter, R. and Eklund, D. (1993b): Coating Color Dewatering in Blade Coaters, Part 2: The Influence of Machine Configuration, Tappi J. 76(6), 93.
21. Lohmander, S., Martinez, M., Lason, L., Rigdahl, M. and Li, T.-Q. (2001): Dewatering of Coating Dispersions -Model Experiments and Analysis, J. Pulp Paper Sci. 27(6), 183.
22. Ma, Y., Davis, H. and Scriven, L. (2004): Microstructure Development in Drying Latex Coatings, Prog. Org. Coat. 52(1), 46.
23. Ming, Y., Takamura, K., Davis, H. and Scriven, L. (1995): Microstructure Development in Latex Coatings, Tappi J. 78(11), 151.
24. Nopola, T. (2004): Simulation of Particle Motion in Concentrated Colloidal Suspensions, Licenciate thesis, Department of Mathematics, University of Turku, Finland.
25. Parpaillon, M., Engström, G., Pettersson, I., Fineman, I., Svanson, S., Dellenfalk, B. and Rigdahl, M. (1985): Mechanical Properties of Clay Coating Films Containing Styrene-Butadiene Copolymers, J. Appl. Polym. Sci. Vol. 30, 581.
26. Prall, K., Shaler, S. and Lepoutre, R. (2000): Pigmented Latex Coatings: Microstructure and Viscoelastic Mechanical Properties, Nord. Pulp Paper Res. J. 15(5), 564.
27. Pöhler, T., Juvonen, K. and Sneck, A. (2006): Coating Layer Microstructure and Location of Binder -Results from SEM Analysis, Tappi Adv. Coat. Fund. Symp., February 8-10, Turku, Finland, 89.
28. Rajala, P., Häkkänen, H. and Berg, C.-G. (2002): The Effect of Intense Air Drying on Material Distribution and Quality in Coated Papers, 13th Int. Drying Symp., August 27-30, Beijing, China, 1800.
29. Rajala, R. (2004): The Influence of New Drying Methods on the Quality of Blade-Coated Offset Paper, Ph. D. Thesis, Helsinki University of Technology, Espoo, Finland.
30. Salminen, P., Roper, J., Pollock, M. and Chonde, Y. (1995): Determining the Dynamic Water Retention Contribution of Various Cobinders and Thickeners, Tappi Coat. Conf., May 19-20, Dallas, TX, 277.
31. Sand, A., Toivakka, M. and Hjelt, T. (2006): Investigation of Filter Cake Stability Using Numerical Simulation Technique, Tappi Adv. Coat. Fund. Symp., February 8-10, Turku, Finland, 279.
32. Sand, A., Toivakka, M. and Hjelt, T. (2007): The Application of Modified Stokesian Dynamics to 3D Particle Motion Simulations of Pigment Coating Colours, Int. Conf. Comp. Meth., April 4-6, Hiroshima, Japan, 97.
33. Santos, N. and Velho, J. (2004): Coating Structure with Calcium Carbonate Pigments and its Influence on Paper and Print Gloss, Pulp Paper Can. 105(9), 43.
34. Sheehan, J., Takamura, K., Davis, H. and Scriven, L. (1993): Microstructure Development in Particulate Coatings Examined With High-Resolution Cryogenic Scanning Electron Microscopy, Tappi J. 76(12), 93.
35. Shen, Y., Bousfield, D., van Heiningen, A. and Donigian, D. (2005): Linkage Between Coating Absorption Uniformity and Print Mottle, J. Pulp Paper Sci. 31(3), 105.
36. Timofeev, O., Pajari, H., Koskela, H., Paaso, J. and Kiiskinen, H. (2007): Drying of Coated Paper: Simulation and Pilot Experiments, PAPTAC 93rd Annual Meeting, February 5-9, Montreal, Canada, A221.
37. Toivakka, M. and Eklund, D. (1992): Simulation of Pigment Motion During Drying, Tappi Coat. Cont., May 17-20, Orlando, FL, 403.
38. Toivakka, M. (1997): Simulation of Particle Motion in Pigment Coating Colors, Ph.D. thesis, Laboratory of Paper Chemistry, Åbo Akademi University, Turku, Finland.
39. Toivakka, M., Salminen, P., Chonde, Y. and Bousfield, D. (1997): Consolidation of Particulate Suspensions -Model Study with Plastic Pigments, Tappi Coat. Fund. Symp., May 9-10, Philadelphia, PA, 89.
40. Usher, S., De Kretser, R. and Scales, R (2001): Validation of a New Filtration Technique for Dewaterability Characterization, AIChE J. 47(7), 1561.
41. Vanni, M. and Baldi, G. (2002): Coagulation Efficiency of Colloidal Particles in Shear Flow, Adv. Colloid Interface Sci. 97, 151.
42. Vidal, D., Zou, X. and Uesaka, T. (2003a): Modeling Coating Structure Development using a Monte Carlo Deposition Method Part 1: Modeling Methodology, Tappi J. 86(4), 3.
43. Vidal, D., Zou, X. and Uesaka, T. (2003b): Modeling Coating Structure Development using a Monte Carlo Deposition Method Part 2: Validation of the Model and Case Study, Tappi J. 86(5), 16.
44. Vidal, D. and Bertrand, F. (2006): Recent Progress and Challenges in the Numerical Modeling of Coating Structure Development, Tappi Adv. Coat. Fund. Symp., February 8-10, Turku, Finland, 241.
45. Watanabe, J. and Lepoutre R. (1982): A Mechanism for the Consolidation of the Structure of Clay-Latex Coatings, J. Appl. Polym. Sci. 27(11), 4207.