Optimization of machining process using evolutionary algorithms

CISM International Centre for Mechanical Sciences, Courses and Lectures

Volumn 486, Issue , 2005, Pages 135-142

  Cukor, G ^a   Kuljanic, E ^b   Barisic, B ^a  

^a University of Rijeka   (Croatia)

^b UNIVERSITY OF UDINE   (Italy)

Author keywords

Cutting; Evolutionary algorithms; Optimization

Indexed keywords

EID: 48849098533     PISSN: 02541971     EISSN: 23093706     Source Type: Book Series    
DOI: 10.1007/3-211-38053-1_12     Document Type: Chapter

References (12)

1. Kiliç, S.E., Cogun, C, Sen, D.T., (1992), A Computer-Aided Graphical Technique for the Optimisation of Machining Conditions, Comp. Ind., Vol. 20, 319-326.
2. Ermer, D.S., Patel, D.C., (1974), Maximization of the Production Rate with Constraints by Linear Programming and Sensitivity Analysis, Proc. 2nd NAMRC, Madison, 436-443.
3. Chua, M.S., Loh, H.T., Wong, Y.S., Rahman, M., (1991), Optimisation of Cutting Conditions for Multi-Pass Turning Operations Using Sequential Quadratic Programming, J. Mater. Proc. Technol., Vol. 28, 253-262.
4. Eskicioglu, H., Nisli, M.S., Kiliç, S.E., (1985), An Application of Geometric Programming to Single-Pass Turning Operations, Proc. 25th Int. Mach. Tool Des. Res. Conf., Birmingham, 149-157.
5. Shin, Y.C., Joo, Y.S., (1992), Optimisation of Machining Conditions with Practical Constraints, Int. J. Prod. Res., Vol. 30, 12, 2907-2919.
6. Cukor, G, Kuljanic, E., (1999), CAPP Software for Tool Selection, Optimisation and Tool Life Data Base Adaptation in Turning, AMST, CISM Courses and Lectures No. 406, Springer Verlag, Wien New York, 241-248.
7. Wang, J., (1993), Multiple-Objective Optimisation of Machining Operations Based on Neural Networks, Int. J. Advanced Manufacturing Technol., Vol. 8, 235-243.
8. Abuelnaga, A.M., El-Dardiry, M., (1984), Optimisation Methods for Metal Cutting, Int. J. Mach. Tool Des. Res., Vol. 24, 1, 11-18.
9. Tandon, V, El-Mounayri, H., Kishawy, H., (2002), NC End Milling Optimisation Using Evolutionary Computation, Int. J. Mach. Tools Manuf., Vol. 42, 595-605.
10. Saravanan, R., Asokan, P., Sachidanandam, M., (2002), A Multi-Objective Genetic Algorithm (GA) Approach for Optimisation of Surface Grinding Operations, Int. J. Mach. Tools Manuf., Vol. 42, 1327-1334.
11. Brezocnik, M., Kovacic, M., (2002), Integrated Evolutionary Computation Environment for Optimising and Modelling of Manufacturing Processes, Proc. 6th TMT, Neum, 107-110.
12. Cukor, G., (1999), Optimisation of Machining Process for Advanced Machining Systems, PhD Thesis, Faculty of Engineering of the University of Rijeka.