State of the art powder-in-tube niobium-tin superconductors

Cryogenics

Volumn 48, Issue 7-8, 2008, Pages 308-316

  Godeke, A ^a   den Ouden, A ^b   Nijhuis, A ^b   ten Kate, H H J ^b  

^a LAWRENCE BERKELEY NATIONAL LABORATORY   (United States)

^b UNIVERSITY OF TWENTE   (Netherlands)

Author keywords

Nb3 Sn; Niobium tin; Powder in tube; Superconducting wire

Indexed keywords

CURRENT DENSITY; NIOBIUM; POWDERS; TIN; TINNING; TITANIUM COMPOUNDS; TRANSITION METALS; TUBES (COMPONENTS);

HIGH-CURRENT-DENSITY (HCD); NIOBIUM-TIN; POWDER IN TUBE (PIT); STATE OF THE ARTS;

SUPERCONDUCTING MATERIALS;

EID: 46049103345     PISSN: 00112275     EISSN: None     Source Type: Journal    
DOI: 10.1016/j.cryogenics.2008.04.003     Document Type: Article

References (69)

1. 3 Sn superconducting wire. Bul Am Phys Soc 15 6 (1970) 838
2. 3 Sn filamentary wires. In: Proc 5th Int Cryo Eng Conf, Kyoto, Japan, 1974, IPC Sci and Technol Press, Surrey, England; 1974. p. 332.
3. 3 Sn strand. Cryogenics 48 (2008) 283-292
4. 3 Sn research and development in the U.S.A. - wires and cables. Cryogenics 48 (2008) 331-340
5. van Beijnen C.A.M., and Elen J.D. Potential fabrication method of superconducting multifilament wires of the A-15-type. IEEE Trans Magn MAG-11 2 (1975) 243
6. 3 Ga multifilament wire. In: Proc 5th Int Conf on Magnet Techn (MT-5), Roma, Italy; 1975. p. 730.
7. 3 Sn superconductors produced by the ECN-technique. IEEE Trans Magn MAG-13 1 (1977) 470
8. 3 Sn superconductors produced by the E.C.N. technique. IEEE Trans Magn MAG-15 1 (1979) 87
9. 3 Sn wire containing a reduced number of filaments. IEEE Trans Magn MAG-17 1 (1981) 1002
10. 3 Sn multifilament superconducting material following the ECN powder method. IEEE Trans Magn MAG-19 3 (1983) 556
11. Veringa H., Hoogendam P., and van Wees A.C.A. Growth kinetics and characterization of superconducting properties of multifilament materials made by the ECN powder method. IEEE Trans Magn MAG-19 3 (1983) 773
12. Veringa H., Hornsveld E.M., and Hoogendam P. Optimization of high current density A-15 superconductors made by the ECN powder method. Adv Cryo Eng (Materials) 30 (1984) 813
13. 3 Sn superconductors. In: Proc 8th Int Cryo Eng Conf, Genova, Italy, 1980, IPC Sci and Technol Press, Surrey, England; 1980. p. 499.
14. Veringa HJ. Intrinsic stability of technical superconductors, PhD thesis, University of Twente, The Netherlands; 1981.
15. Hornsveld E.M., Elen J.D., van Beijnen C.A.M., and Hoogendam P. Development of ECN-type niobium-tin wire towards smaller filament size. Adv Cryo Eng (Materials) 34 (1988) 493
16. Hornsveld E.M., and Elen J.D. Development of niobium-tin conductors at ECN. Adv Cryo Eng (Materials) 36A (1990) 157
17. 3 Sn conductors based on the "powder in tube" method with finer filaments. IEEE Trans Appl Supercond 9 2 (1999) 1451
18. 3 Sn conductors for high-field magnets. IEEE Trans Appl Supercond 10 (2000) 975
19. 3 Sn conductors. J Appl Phys 97 (2005) 093909
20. 3 Sn conductors. Master's thesis, University of Wisconsin-Madison; 2002.
21. 3 Sn by the powder in tube process. IEEE Trans Appl Supercond 11 1 (2001) 3584
22. 3 Sn and their variation with A15 composition, morphology and strain state. Supercond Sci Technol 19 8 (2006) R68
23. 3 Sn conductor development at Superconductors. IEEE Trans Appl Supercond 13 2 (2003) 3490
24. 3 Sn powder-in-tube superconductor: processing, design optimization and properties. Adv Cryo Eng (Materials) 50B (2004) 376
25. 3 Sn conductor for high magnetic field applications. Presentation 1MJ07 at the 2006 applied superconductivity conference, Seattle WA, USA; 2006.
26. 3 Sn multifilamentary wires through the FEAT process. Presentation 1MJ05 at the 2006 applied superconductivity conference, Seattle WA, USA; 2006.
27. Lefranc G., and Müller A. Effect of copper additions to superconducting niobium-tin sinter material. J Less Common Metals 45 (1976) 339
28. 3 Sn superconductors, PhD thesis, University of Twente, Enschede, The Netherlands; 2005.
29. Charlesworth J.P., MacPhail I., and Madsen P.E. Experimental work on the niobium-tin constitution diagram and related studies. J Mater Sci 5 (1970) 580
30. Lee P.J., and Larbalestier D.C. Niobium-titanium superconducting wires: nanostructures by extrusion and wire drawing. Wire J Int 36 2 (2003) 61
31. 3 Sn, and development of W&R Bi-2212 high field accelerator magnets. IEEE Trans Appl Supercond 17 2 (2007) 1149
32. 3 Sn wires. Supercond Sci Technol 19 (2006) R100
33. 3 Sn. J Appl Phys 46 (1975) 2244
34. 3 Sn formed by solid state diffusion in the range 650-800 °C. J Appl Phys 47 (1976) 2143
35. 3 Sn superconducting wire. J Appl Phys 54 12 (1983) 7139
36. 3 Sn composite wire. IEEE Trans Appl Supercond 10 1 (2000) 988
37. 3 Sn conductor. Master's thesis, University of Wisconsin-Madison; 2002.
38. 3 Sn powder-in-tube superconducting strand. Supercond Sci Technol 19 (2006) S27
39. 3 Sn. Adv Cryo Eng (Materials) 50B (2004) 474
40. 3 Sn conductors. J Appl Phys 96 4 (2004) 2122
41. c. Supercond Sci Technol 16 (2003) 1019
42. 3 Sn multifilamentary wires using Osprey Bronze. IEEE Trans Appl Supercond 15 (2005) 3482
43. 3 Sn bronze route and internal Sn wires. Presentation THA01PO06 at the 19th international conference on magnet technology, Genova, Italy; 2005.
44. 3 Sn layer critical current density. IEEE Trans Appl Supercond 15 2 (2005) 3474
45. 3 Sn conductor develeopment for Fusion and particle accelerator applications. Adv Cryo Eng (Materials) 50B (2004) 369
46. Devred A., Baudouy B., Baynham D.E., Boutboul T., Canfer S., Chorowski M., et al. Overview and status of the next European dipole joint research activity. Supercond Sci Technol 19 (2006) S67
47. 3 Sn strand geometry on filament breakage under bend strain as revealed by metallography. Supercond Sci Technol 16 (2003) 1005
48. Godeke A., Dhalle M., Morelli A., Stobbelaar L., van Weeren H., van Eck H.J.N., et al. A device to investigate the axial strain dependence of the critical current density in superconductors. Rev Sci Instrum 75 12 (2004) 5112
49. 3 Sn strand subjected to spatial periodic bending. Supercond Sci Technol 19 (2006) 1136
50. Ekin J.W. High-field flux pinning and the strain scaling law. In: Matsushita T., Yamafuji K., and Irie F. (Eds). Proc Int Symp on flux pinning and electromagnetic properties in superconductors (1985), Matsukuma Press, Fukuoka 267
51. 3 Sn cables under transverse pressure. IEEE Trans Appl Supercond 3 1 (1993) 1334
52. 3 Sn LHC type of dipole magnet. IEEE Trans Magn 30 4 (1994) 2320
53. 3 Sn superconductors in accelerator magnets. IEEE Trans Appl Supercond 7 2 (1997) 733
54. 3 Sn model dipole magnet MSUT. In: Liangzhen L., Guoliao S., and Luguang Y. (Eds). Proceedings of the 15th international conference on magnet technology (1998), Science Press, Beijing, China 339
55. Dietderich D.R., Scanlan R.M., Walsh R.P., and Miller J.R. Critical current of superconducting Rutherford cable in high magnetic fields with transverse pressure. IEEE Trans Appl Supercond 9 2 (1999) 122
56. Scanlan R.M., Benjegerdes R.J., Bish P.A., Caspi S., Chow K., Dell'Orco D., et al. Preliminary test results of a 13 Tesla niobium-tin dipole. Applied superconductivity 1997. Proceedings of EUCAS 1997 third European conference on applied superconductivity vol. 2 (1997), Institute of Physics Publishing, Bristol, UK 1503
57. 3 Sn Rutherford-type cables to transverse pressure. IEEE Trans Appl Supercond 15 2 (2005) 1541
58. Feher S., Ambrosio G., Andreev N., Barzi E., Bordini B., Carcagno B.R.R., et al. Cable testing for Fermilab's high field magnets using small racetrack coils. IEEE Trans Appl Supercond 15 2 (2005) 1550
59. 3 Sn cos-theta dipoles based on PIT strands. IEEE Trans Appl Supercond 15 2 (2005) 1160
60. 3 Sn accelerator magnets at Fermilab. IEEE Trans Appl Supercond 15 2 (2005) 1113
61. Roeterdink JA, Elen JD, Franken WMP. The ECN 12 Tesla insert coil for Sultan. In: Marinucci C, Weymuth P. editors, Proc 9th Int Conf on Magnet Technology, Zurich, Switzerland, Swiss Institute for Nuclear Research; 1985. p. 402.
62. 3 Sn cables for high field accelerator magnets. IEEE Trans Appl Supercond 15 2 (2005) 1545
63. 3 Sn wire properties via the reduction of inhomogeneities. Presented at the 2003 low temperature superconductor workshop, Monterey CA, USA; 2003.
64. Jewell MC, Gerczak TJ, Larbalestier DC. Putting a different "P" in PIT: phase equilibria in high-Sn intermetallics. Presentation 1MB05 at the 2006 applied superconductivity conference, Seattle WA, USA; 2006.
65. 3 Sn processing and properties. IEEE Trans Appl Supercond 15 2 (2005) 3418
66. 3 Sn superconductors fabricated by the internal-tin-tube process. Adv Cryo Eng (Materials) 52B (2006) 497
67. 3 Sn composites. PhD thesis, University of Wisconsin-Madison; 2002.
68. 3 Sn utilizing disorder introduced by ball milling the elements. Appl Phys Lett 88 (2006) 142506
69. Bose S., Raychaudhuri P., Banerjee R., and Ayyub P. Upper critical field in nanostructured Nb: Competing effects of the reduction in density of states and the mean free path. Phys Rev B 74 (2006) 224502