Analysis of surface roughness parameters in turning of FRP tubes by PCD tool

Journal of Materials Processing Technology

Volumn 204, Issue 1-3, 2008, Pages 469-474

  Palanikumar, K ^a   Mata, F ^b   Davim, J Paulo ^c  

^a SATHYABAMA UNIVERSITY   (India)

^b UNIVERSITY OF CASTILLA LA MANCHA   (Spain)

^c UNIVERSITY OF AVEIRO   (Portugal)

Author keywords

Empirical model; Fibre reinforced plastics; Surface roughness parameters; Turning

Indexed keywords

CORROSION RESISTANCE; GLASS FIBERS; MACHINING; STIFFNESS; SURFACE ROUGHNESS;

CUTTING PARAMETERS; MACHINING PARAMETERS; THREE-DIMENSIONAL SURFACE PLOTS;

FIBER REINFORCED PLASTICS;

EID: 44649111900     PISSN: 09240136     EISSN: None     Source Type: Journal    
DOI: 10.1016/j.jmatprotec.2007.12.088     Document Type: Article

References (12)

1. Bhatnagar N., Ramakrishnan N., Naik N.K., and Komanduri R. On the machining of fiber reinforced plastic (FRP) composite laminates. Int. J. Mach. Tools Manuf. 35 (1995) 701-716
2. Davim J.P., and Mata F. Influence of cutting parameters on surface roughness in turning glass-fiber-reinforced-plastics using statistical analysis. Ind. Lubr. Tribol. 56/5 (2004) 270-274
3. Davim J.P., and Mata F. Optimisation of surface roughness on turning fiber reinforced plastics (FRPs) with diamond cutting tool. Int. J. Adv. Manuf. Technol. 26 (2005) 319-323
4. Davim J.P., and Mata F. A new machinability index in turning fiber-reinforced plastics. J. Mater. Process. Technol. 170 (2005) 436-440
5. Davim J.P., and Reis P. Dimensional precision and surface roughness on turning tubes in fibre reinforced plastics based on the design experiments. Int. J. Mater. Prod. Technol. 20 (2004) 268-279
6. El-Sonbaty I., Khashaba U.A., and Machaly T. Factors affecting the machinability of GFR/epoxy composites. Compos. Struct. 63 (2004) 329-338
7. Jahanmir S., Ramulu M., and Koshy P. Machining of Ceramics and Composites (1998), Marcel Dekker Inc., New York pp. 238-243
8. Konig W., Wulf C., Grab C., and Willerscheid H. Machining of fibre reinforced plastics. Ann. CIRP 34 2 (1985) 537-547
9. Montgomery D.C. Design and Analysis of Experiments (1991), John Wiley and Sons, New York
10. Ramulu M., Wern C.W., and Garbini J.L. Effect of the direction on surface roughness measurements of machined graphite/epoxy composite. Compos. Manuf. 4 1 (1993) 39-51
11. Sakuma K., and Seto M. Tool wear in cutting glass-fiber-reinforced plastics. The relation between fiber orientation and tool wear. Bull. JSME 26 (1983) 1420-1427
12. Wang X.M., and Zhang L.C. An experimental investigation into the orthogonal cutting of unidirectional fiber reinforced plastics. Int. J. Mach. Tools Manuf. 43 (2003) 1015-1022