The characteristics of cutting pipe mechanism with multi-electrodes in EDM

Journal of Materials Processing Technology

Volumn 203, Issue 1-3, 2008, Pages 461-464

  Chen, S L ^a   Lin, M H ^a   Hsieh, S F ^a   Chiou, S Y ^a  

^a NATIONAL KAOHSIUNG UNIVERSITY OF APPLIED SCIENCES   (Taiwan)

Author keywords

Cutting pipe mechanism; Electrical discharge machining; Material removal rate; Relative electrode wear rate

Indexed keywords

ELECTRIC DISCHARGES; MACHINING; MATERIALS HANDLING; REMOVAL; WEAR OF MATERIALS;

CUTTING PIPE MECHANISM; ELECTRICAL DISCHARGE MACHINING; MATERIAL REMOVAL RATE; RELATIVE ELECTRODE WEAR RATE;

ELECTRODES;

EID: 43849105225     PISSN: 09240136     EISSN: None     Source Type: Journal    
DOI: 10.1016/j.jmatprotec.2007.10.059     Document Type: Article

References (13)

1. Bozkurt B., Gadalla A.M., and Eubank P.T. Simulation of erosion in a single discharge EDM process. Mater. Manuf. Process. 11 4 (1996) 555-563
2. Chen S.L., Huang F.Y., Suzuki Y., and Yan B.H. Improvement of material removal rate of Ti-6Al-4V alloy by electrical discharge machining with multiple ultrasonic vibration. J. Light Met. 4 4 (1997) 220-225
3. Erden A. Effect of materials on the mechanism of electrical discharge machining. Trans. ASME 105 (1983) 132-138
4. 2 composite. J. Mater. Sci. Eng. 188 (1994) 91-96
5. Imai Y., Satake A., Taneda A., and Kobayashi K. Improvement of EDM speed by using frequency response actuator. Int. Elec. Mach. 1 (1996) 21-26
6. Kong W., and Panten U. Electrical discharge cutting of electrically conductive ceramic. Res. Technol. Dev. Nontraditional Mach. 34 (1988) 105-116
7. Kunieda M., Furuoya S., and Taniguchi N. Improvement of EDM efficiency by supplying oxygen gas into gap. Ann. CIRP 40 (1991) 215-218
8. 2-SiC. J. Eng. Mater. Technol. 13 (1991) 437-442
9. Ruszaj A. Investigation of the electrical discharge machining process for various electrode kinematics. Precis. Eng. 4 2 (1992)
10. Soni J.S., and Chakraverti G. Machining characteristic of titanium with rotary electro-discharge machining. Wear 171 (1994) 51-58
11. Valentincic J., Brissaud D., and Junkar M. EDM process adaptation system in toolmaking industry. J. Mater. Process. Technol. 172 2 (2006) 291-298
12. Xia H., Kunieda M., and Nishiwaki N. Removal amount difference between anode and cathode in EDM process. Int. Electro-Discharge Mach. 1 (1996) 45-52
13. Yu Z., Jun T., and Masanori K. Dry electrical discharge machining of cemented carbide. J. Mater. Process. Technol. 149 1-3 (2004) 353-357