Heat flux effect on the droplet entrainment and deposition in annular flow dryout

Communications in Nonlinear Science and Numerical Simulation

Volumn 13, Issue 10, 2008, Pages 2223-2235

  Peng, S W ^a  

^a BEIJING NORMAL UNIVERSITY   (China)

Author keywords

Annular flow dryout; Deposition; Entrainment; Heat flux effect

Indexed keywords

DAMPING; DROPS; HEAT FLUX; MASS TRANSFER; SURFACE TENSION; TURBULENCE MODELS;

ANNULAR FLOW DRYOUT; DROPLET DEPOSITION; DROPLET ENTRAINMENT; VAPOR EFFUSION;

ROTATIONAL FLOW;

DAMPING; DROPS; HEAT FLUX; MASS TRANSFER; ROTATIONAL FLOW; SURFACE TENSION; TURBULENCE MODELS;

EID: 43049160894     PISSN: 10075704     EISSN: None     Source Type: Journal    
DOI: 10.1016/j.cnsns.2007.06.008     Document Type: Article

References (35)

1. Bowring RW. A simple but accurate round tube uniform heat flux dryout correlation over the pressure range 0.7-17 MN/m2. AEEW-R789, 1972.
2. Katto Y. Prediction of critical heat flux for annular flow in tubes taking into account the critical liquid film thickness concept. Int J Heat Mass Transfer 27 (1984) 883-891
3. Groeneveld D.C., Leung L.K.H., Kirillov P.L., Bobov V.P., Smogalev I.P., Vinogradov V.N., et al. The 1995 look-up table for critical heat flux in tubes. Nucl Eng Des 163 (1996) 1-23
4. Whalley P.B., Hutchinson P., and Hewitt G.F. The calculation of critical heat flux in forced convection boiling. Heat transfer 1974, Tokyo, Japan 4 (1974) 290-294
5. Hewitt G.F., and Govan A.H. Phenomenological modeling of non-equilibrium flows with phase change. Int J Heat Mass Transfer 33 (1990) 229-242
6. Okawa T., Kotani A., Kataoka I., and Naitoh M. Prediction of the critical heat flux in annular regime in various vertical channels. Nucl Eng Des 229 (2004) 223-236
7. Saito T., Hughes E.D., and Carbon M.W. Multifluid modeling of annular two-phase flow. Nucl Eng Des 50 (1978) 225-271
8. Sugawara S. Droplet deposition and entrainment modeling based on the three-fluid model. Nucl Eng Des 122 (1990) 67-84
9. Sugawara S. Analytical prediction of CHF by FIDAS code on three-fluid and film dryout model. J Nucl Sci Technol 27 (1990) 12-29
10. Kataoka I., Kodama S., Tomiyama A., and Serizawa A. Study on analytical prediction of forced convective CHF based on multi-fluid model. Nucl Eng Des 175 (1997) 107-117
11. Andreussi P. Droplet transfer in two-phase annular flow. Int J Multiphase Flow 9 (1983) 697-713
12. Whalley P.B., and Jepson D.M. Entrainment and deposition in annular gas-liquid flow: the effect of fluid physical properties. Heat transfer 1994, Brighton, UK 6 (1994) 289-294
13. Azzopardi B.J. Drops in annular two-phase flow. Int J Multiphase Flow 23 Suppl. (1997) 1-53
14. Doroshchuk V.E., Lantsman F.P., and Levitan L.L. A peculiar type of burnout in evaporator tubes. Heat transfer 1970 (1970), Elsevier Pub. Co., Amsterdam, Netherlands [Paper B6.1]
15. Hewitt G.F., and Hall-Taylor N.S. Annular two-phase flow (1970), Pergamon Press, Oxford, UK
16. Hinze J.O. Turbulence (1959), McGraw-Hill Book Co., New York
17. Davies J.T. Turbulence phenomenon (1972), Academic Press, New York
18. Banerjee S. Modelling considerations for turbulent multiphase flows. In: Rodi W, Ganic EN, editors. Engineering turbulence modelling and experiments, Dubrovnik, Yugoslavia; 1990. p. 831-66.
19. Ishii M., and Grolmes M.A. Inception criteria for droplet entrainment in two-phase concurrent film flow. AIChE J 21 (1975) 308-318
20. Ueda T., Inoue M., and Nagatome S. Critical heat flux and droplet entrainment in boiling of falling liquid films. Int J Heat Mass Transfer 24 (1981) 1257-1266
21. Olsen R.N., and Eckert E.R.G. Experimental studies of turbulent flow in a porous circular tube with uniform fluid injection through the tube wall. Trans ASME, J Appl Mech 33 (1966) 7-17
22. Peng SW, Groeneveld DC, Cheng SC. Flow boiling CHF and limiting quality phenomenon in tubes. In: Chinese Society of Engineering Thermophysics, editors. Proc of annual conf of multiphase flow of China, Shanghai, China; 2004. p. 35-40 [in Chinese].
23. Okawa T., Kitahara T., Yoshida K., Matsumoto T., and Kataoka I. New entrainment rate correlation in annular two-phase flow applicable to wide range of flow condition. Int J Heat Mass Transfer 45 (2002) 87-98
24. Wallis G.B. One-dimensional two-phase flow (1969), McGraw-Hill, New York
25. Friedlander S.K., and Johnstone H.F. Deposition of suspended particles from turbulent gas stream. Ind Eng Chem 49 (1957) 1151-1156
26. Soo S.L. Fluid dynamics of multiphase system (1967), Blaisdell Publishing Co., USA
27. James PW, Hewitt GF, Whalley PB. Droplet motion in two-phase flow. In: ANS/ASME/NRC, Proc int topical meeting on nuclear reactor thermal-hydraulics, vol. 2; 1980. p. 1484-1503.
28. Papavergos P.G., and Hedley A.B. Particle deposition behavior from turbulent flow. Chem Eng Res Des 62 (1984) 275-295
29. Scriven L.E. Penetration theory modeling. Chem Eng Educat 3 (1969) 94-102
30. Weisman J., and Pei B.S. Prediction of critical heat flux in flow boiling at low qualities. Int J Heat Mass Transfer 26 (1983) 1463-1477
31. Laufer J. The structure of turbulence in fully developed pipe flow, NACA technical note no. 2954, 1953.
32. Whalley P.B. Boiling, condensation, and gas-liquid flow (1987), Clarendon Press, Oxford, UK
33. Katto Y. A study on limiting exit quality of CHF of forced convection boiling in uniformly heated vertical channels. Trans ASME, J Heat Transfer 104 (1982) 40-47
34. Kitto Jr. J.B. Critical heat flux and the limiting quality phenomenon. AIChE Symp Series, Heat Transfer - Orlando 76 199 (1980) 57-78
35. Tatterson D.F., Dallman J.C., and Hanratty T.J. Drop sizes in annular gas-liquid flow. AIChE J 23 (1977) 68-76