Investigation of spring-go phenomenon using finite element method

Materials and Design

Volumn 29, Issue 8, 2008, Pages 1526-1532

  Thipprakmas, Sutasn ^a,b   Rojananan, Surasit ^a  

^a KING MONGKUT'S UNIVERSITY OF TECHNOLOGY THONBURI   (Thailand)

^b NIPPON INSTITUTE OF TECHNOLOGY   (Japan)

Author keywords

Elastic behaviour; Forming; Plastic behaviour

Indexed keywords

COMPUTER SIMULATION; ELASTICITY; FINITE ELEMENT METHOD; METAL FORMING; PLASTICITY; SHEET METAL; STRESS CONCENTRATION;

SPRING-BACK PHENOMENON; SPRING-GO PHENOMENON;

BENDING (FORMING);

BENDING (FORMING); COMPUTER SIMULATION; ELASTICITY; FINITE ELEMENT METHOD; METAL FORMING; PLASTICITY; SHEET METAL; STRESS CONCENTRATION;

EID: 42749088395     PISSN: 02613069     EISSN: 18734197     Source Type: Journal    
DOI: 10.1016/j.matdes.2008.02.002     Document Type: Article

References (10)

1. Schuler Metal forming handbook 1998 Springer-Verlag Berlin, Heidelberg, New York p. 366–73
2. K. Lange Handbook of metal forming 1985 McGraw-Hill Inc. New York p. 19.1–35
3. V. Esat H. Darendeliler M.I. Gokler Finite element analysis of springback in bending of aluminium sheets J Mater Des 23 2002 223 229
4. L. Papeleux J.P. Ponthot Finite element simulation of springback in sheet metal forming J Mater Process Technol 125–126 2002 785 791
5. Y.E. Ling H.P. Lee B.T. Cheok Finite element analysis of springback in L-bending of sheet metal J Mater Process Technol 168 2005 296 302
6. O. Tekaslan U. Seker A. Ozdemir Determining springback amount of steel sheet metal has 0.5 mm thickness in bending dies J Mater Des 27 2006 251 258
7. S.K. Panthi N. Ramakrishnan K.K. Pathak J.S. Chouhan An analysis of springback in sheet metal bending using finite element method (FEM) J Mater Process Technol 186 2007 120 124
8. Jin M, Thipprakmas S, Matsumoto N, Souma S, Murakawa M. Design optimization of die and punch for bending of spring materials. In: Proceedings of the 51st japanese joint conference for the technology of plasticity. 2000. p. 481–2 [in Japanese].
9. S. Thipprakmas S. Rojananan P. Paramaputi An investigation of step taper-shaped punch in piercing process using finite element method J Mater Process Technol 197 2007 132 139
10. M. Murakawa S. Thipprakmas M. Jin Investigation of the relationship between shaved surface and shaving allowance J JSTP 44–513 2003 53 57 [in Japanese]