Fabrication and some properties of textured alumina-related compounds by colloidal processing in high-magnetic field and sintering

Journal of the European Ceramic Society

Volumn 28, Issue 5, 2008, Pages 935-942

  Sakka, Yoshio ^a   Suzuki, Tohru S ^a   Uchikoshi, Tetsuo ^a  

^a NATIONAL INSTITUTE FOR MATERIALS SCIENCE   (Japan)

Author keywords

Alumina; EPD; Magnetic field; Slip casting; Textured ceramics

Indexed keywords

ANISOTROPY; CASTING; ELECTROPHORESIS; MAGNETIC FIELD EFFECTS; MAGNETIC SUSCEPTIBILITY; SINTERING;

ELECTROPHORETIC DEPOSITION; REACTION SINTERING; SLIP CASTING;

ALUMINA;

ALUMINA; ANISOTROPY; CASTING; ELECTROPHORESIS; MAGNETIC FIELD EFFECTS; MAGNETIC SUSCEPTIBILITY; SINTERING;

EID: 38149066671     PISSN: 09552219     EISSN: None     Source Type: Journal    
DOI: 10.1016/j.jeurceramsoc.2007.09.039     Document Type: Article

References (42)

1. Messing G.L., Trolier-McKinstry S., Sabolsky E.M., Duran C., Kwon S., Brahmaroutu B., et al. Templated grain growth of textured piezoelectric ceramics. Crit. Rev. Solid State Mater. Sci. 29 (2004) 45-96
2. Hirao K., Ohashi M., Brito M.E., and Kanzaki S. Processing strategy of producing highly anisotropic silicon nitride. J. Am. Ceram. Soc. 78 (1995) 1687-1690
3. 12 ceramics. Jpn. J. Appl. Phys. 19 (1980) 31-39
4. Yoshizawa Y., Toriyama M., and Kanzaki S. Fabrication of textured alumina by high-temperature deformation. J. Am. Ceram. Soc. 84 (2001) 1392
5. Suzuki T.S., Sakka Y., and Kitazawa T. Orientation amplification of alumina by colloidal filtration in a strong magnetic field and sintering. Adv. Eng. Mater. 3 (2001) 490-492
6. Sakka Y., and Suzuki T.S. Textured development of feeble magnetic ceramics by colloidal processing under high-magnetic field. J. Ceram. Soc. Jpn. 113 (2005) 26-36
7. Uyeda C. Rotational motion of inorganic diamagnetic crystals induced in the magnetic field. Jpn. J. Appl. Phys. Part 2 32 (1993) L268-L270
8. Uyeda C., Abe T., and Takashinia R. Magnetic anisotropy of ordinary crystals without spontaneous magnetic moments detected by rotational oscillations induced by a field of a horseshoe magnet. Jpn. J. Appl. Phys. Part 2 45 (2006) L268-L271
9. Sakka Y. Fabrication of highly microstructure controlled ceramics by novel colloidal processing. J. Ceram. Soc. Jpn. 114 (2006) 371-376
10. Inoue K., Sassa K., Yokogawa Y., Sakka Y., Okida M., and Asai S. Control of crystal orientation of hydroxyapatite by imposition of a high-magnetic field. Mater. Trans. 44 (2003) 1133-1137
11. Makiya A., Kusano D., Tanaka S., Uchida N., Uematsu K., Kimura T., et al. Particle oriented bismuth titanate ceramics made in high-magnetic field. J. Ceram. Soc. Jpn. 111 (2003) 702
12. 3 ceramics by slip casting in a high-magnetic field and sintering. Scripta Mater. 52 (2005) 583-586
13. Wu C.Y., Li S.Q., Sassa K., Sakka Y., Suzuki S.T., and Asai S. The crystal orientation taking account of gravity force under high-magnetic field. ISIJ Int. 45 (2005) 997-1000
14. Iwai K., Akiyama J., Sun M.G., and Asai S. Application of a strong magnetic field on materials fabrication and experimental simulation. Sci. Technol. Adv. Mater. 7 (2006) 365-368
15. 4 ceramics by magnetic field alignment during slip casting. J. Ceram. Soc. Jpn. 114 (2006) 979-987
16. Tabara K., Makiya A., Tanak S., Uematsu K., and Doshida Y. Particle oriented strontium bismuth titanate ceramics prepared by using high-magnetic field and subsequent reaction sintering. J. Ceram. Soc. Jpn. 115 (2007) 237-240
17. l0.02O by a high-magnetic-field via gelcasting and its thermoelectric properties. J. Ceram. Soc. Jpn. 114 (2006) 1085-1088
18. Sakka Y., Takahashi K., Suzuki T.S., Ito S., and Matsuda N. Texture development of hydroxyapatite ceramics by colloidal processing in a high-magnetic field followed by sintering. Mater. Sci. Eng. A 475 (2008) 27-33
19. Yamauchi Y., Sawada M., Sugiyama A., Osaka T., Sakka Y., and Kuroda K. Magnetically induced orientation of mesochannels in 2D-hexagonal mesoporous silica films. J. Mater. Chem. 16 (2006) 3693-3700
20. Guilmean E., Chateigner D., Suzuki T.S., Sakka Y., and Henrist C. Rietveld texture analysis of alumina ceramics by neutron diffraction. Chem. Mater. 17 (2005) 102-106
21. Suzuki T.S., Uchikoshi T., and Sakka Y. Control of texture in alumina by colloidal processing in a strong magnetic field. Sci. Technol. Adv. Mater. 7 (2006) 356-364
22. 15 ceramics fabricated by slip casting in high-magnetic field. J. Am. Ceram. Soc. 90 (2007) 1463-1466
23. 3 ceramics by slip casting in a high-magnetic field. J. Ceram. Soc. Jpn. 109 (2001) 886-890
24. Suzuki T.S., Uchikoshi T., and Sakka Y. Texture development in alumina composites by slip casting in a strong magnetic field. J. Ceram. Soc. Jpn. 114 (2006) 59-62
25. Hirata Y., Lee S.Y., Shimada K., and Ishihara Y. Electrical properties of MgO-doped beta alumina ceramics prepared from the metal alkoxides Nippon Seramikkusu Kyokai Gakujutsu Ronbunshi. J. Ceram. Soc. Jpn. 100 (1992) 877-881
26. Fielder W.L., Kautz H.E., Ford J.S., and Singer J. Conductivity of boules of single-crystal sodium beta-alumina. J. Electrochem. Soc. 122 (1975) 528-530
27. Dogotsi G.A. Fracture toughness of ceramics and ceramic composites. Ceram. Int. 29 (2003) 777-784
28. Yoshizawa Y., Hirao K., and Kanzaki S. Fabrication of low cost fine-grained alumina powders by seeding for high performance sintered bodies. J. Eur. Ceram. Soc. 24 (2004) 325-330
29. Osendi M.I., and Baudin C. Mechanical properties of mullite materials. J. Eur. Ceram. Soc. 16 (1996) 217-224
30. Ohira H.M.M., Ismail G., Yamamoto U., Akiba Y., and Somiya T.S. Mechanical properties of high-purity mullite at elevated temperatures. J. Eur. Ceram. Soc. 16 (1996) 225-229
31. Sakka Y., Bidinger D.D., and Aksay I.A. Processing of silicon carbide-mullite-alumina nanocomposite. J. Am. Ceram. Soc. 78 (1995) 479-486
32. 2O-containing alumina compact. J. Mater. Res. 6 (1991) 585-591
33. Sakka Y., Honda A., Suzuki T.S., and Moriyosh Y. Fabrication of oriented β-alumina from porous bodies by slip casting in a high-magnetic field. Solid State Ionics 172 (2004) 341-347
34. Tang F.Q., Fudouzi H., Uchikoshi T., and Sakka Y. Preparation of porous materials with controlled pore size and porosity. J. Eur. Ceram. Soc. 24 (2004) 341-344
35. Sakka Y., Tang F.Q., Fudouzi H., and Uchikoshi T. Fabrication of porous ceramics with controlled pore size by colloidal processing. Sci. Technol. Adv. Mater. 6 (2005) 915-920
36. Suzuki T.S., Sakka Y., Nakano K., and Hiraga K. Effect of ultrasonication on the microstructure and tensile elongation of zirconia-dispersed alumina ceramics prepared by colloidal process. J. Am. Ceram. Soc. 84 (2001) 2132-2134
37. Inkyo M., and Tahira T. Dispersion of agglomerated nanoparticles by fine beads mill. J. Soc. Powder Powder Technol. Jpn. 41 (2004) 578-585 [in Japanese]
38. Uchikoshi T., Ozawa K., Hatton B.D., and Sakka Y. Dense, bubble-free ceramic deposits from aqueous suspensions by electrophoretic deposition. J. Mater. Res. 16 (2001) 321-324
39. Uchikoshi T., Suzuki T.S., Okuyama H., and Sakka Y. Electrophoretic deposition of alpha-alumina particles in a strong magnetic field. J. Mater. Res. 18 (2003) 254-256
40. Uchikoshi T., Suzuki T.S., Okuyama H., and Sakka Y. Control of crystalline texture in polycrystalline alumina ceramics by electrophoretic deposition in a strong magnetic field. J. Mater. Res. 19 (2004) 1487-1491
41. Okamoto T., Horii S., Uchikoshi T., Suzuki T.S., Sakka Y., Funahashi R., et al. Fabrication of multilayered oxide thermoelectric modules by electrophoretic deposition under high-magnetic fields. Appl. Phys. Lett. 89 (2006) [Art. No. 081912]
42. Horii S., Kumagai T., Uchikoshi T., Suzuki T.S., Sakka Y., Shimoyama J.I., et al. Improvement of thermoelectric performance in magnetically c-axis-oriented bismuth-based vobaltite. Scripta Mater. 57 (2007) 333-336