Physical cutting model of polyamide composites (PA66 GF30)

Materials Science Forum

Volumn 514-516, Issue PART 1, 2006, Pages 643-647

  Mata, Francisco ^a   Reis, Pedro ^a   Davim, J Paulo ^b  

^a UNIVERSITY OF AVEIRO   (Portugal)

^b NONE

Author keywords

Composite material; Merchant model; Orthogonal cutting; Turning

Indexed keywords

COMPOSITE MATERIALS; DEFORMATION; GLASS FIBERS; POLYAMIDES; POLYCRYSTALLINE MATERIALS; STIFFNESS; TURNING;

CUTTING PARAMETERS; FRICTION ANGLE; MERCHANT MODEL; ORTHOGONAL CUTTING;

CUTTING TOOLS;

EID: 37849031463     PISSN: 02555476     EISSN: 16629752     Source Type: Book Series    
DOI: 10.4028/www.scientific.net/msf.514-516.643     Document Type: Conference Paper

References (9)

1. J.P. Davim, P. Reis, Vitor Lapa and C. Conceição António, Machinability Study on Polyetheretherketone (PEEK) Unreinforced and Reinforced (GF 30) for Applications in Structural Components, Composite Structures, Elsevier Sc., Vol. 62(1), (2003) p. 67-73
2. J.P. Davim, P. Reis, Machinability study on composite (polyetheretherketone reinforced with 30% glass fibre-PEEK GF30) using polycrystalline diamond (PCD) and cemented carbide (K20) tool, Int. J. Adv. Manuf. Technol., Vol. 23 (2004), p. 412-418
3. J.P. Davim, F. Mata, Influence of cutting parameters on surface roughness in turning glass-fibre-reinforced plastics using statistical analysis, Industrial Lubrication and Tribology 56 (5) (2004), p. 270-274
4. El-Sonbaty, U.A. Khashaba, T. Machaly, Factors affecting the machinability of GFR/epoxy composite", Composite structures, Vol. 63 (2004), p. 329-338
5. X.M. Wang, L.C. Zhang, An experimental investigation into the orthogonal cutting of unidirectional fibre reinforced plastics, International Journal of Machine Tools and Manufacture, Vol 43 82003), p. 1045-1022
6. M. P. Groover, Fundamentals of Modern Manufacturing Materials, Process and Systems, Prentice Hall International Editions (1996), p.543-563
7. H. Ernst and M.E. Merchant, Chip Formation, Friction and High Quality Machined Surfaces, Trans. Am. Soc. Met. Vol. 29 (1941), p. 299-378
8. G. Boothroy, W. Knight, Fundamentals of Machining and Machine Tools, Marcel Dekker, New York (1989), p.61-91
9. M.C. Shaw, Metal Cutting Principles, Oxford Science Publications, New York (1984), pp. 18-46