Development of a non-contact tool setting system for precision diamond turning

Materials Science Forum

Volumn 505-507, Issue PART 1, 2006, Pages 367-372

  Chao, C L ^a   Cheng, T A ^b   Lou, D C ^b   Chao, C W ^c  

^a TAMKANG UNIVERSITY   (Taiwan)

^b NATIONAL DEFENSE UNIVERSITY   (Taiwan)

^c HSING WU UNIVERSITY   (Taiwan)

Author keywords

Edge detection; Precision diamond turning; Tool setting

Indexed keywords

EDGE DETECTION; ERROR ANALYSIS; OPTICAL RESOLVING POWER; TURNING;

PRECISION DIAMOND TURNING; TOOL-SETTING;

DIAMOND CUTTING TOOLS;

EID: 35348845797     PISSN: 02555476     EISSN: 16629752     Source Type: Book Series    
DOI: 10.4028/0-87849-990-3.367     Document Type: Conference Paper

References (7)

1. T. Sugan et al., (1987) 'Diamond turning of an aluminium alloy mirror,' Annals of CIRP 36, 17-20
2. S. To, et al., (2000) 'Ultra precision diamond turning of aluminium single crystals,' J of Mater. Process. Technol 99, 129-134.
3. W.B. Lee, et al., (2000) 'An investigation of residual form error compensation in the ultra-precision machining of aspheric surface,' J. Mater. Process. Technol. 99, 129-134.
4. G. O'Donnell, et al., (2001) 'Towards The Improvement Of Tool Condition Monitoring System In The Manufacturing Environment,' J of Materials Processing Technology, 133-139.
5. M. Suchomel et al., (1995) 'Tool's Sharp and Position Direct Measurement by CCD Camera,' 8th Int. Precision Engineering Seminar (8-IPES), May, 549-552.
6. H. Schwenke (2002) 'Optical Sensor For 2D And 3D Measurement Of Small Structure On Coordinate Measuring Machines,' Annals Of CIRP, 51/1.
7. M.H. Chowdhury, et al., (1995) 'Image Threshold Techniques,' IEEE Communications, Computers, and Signal Processing, 585-589.Table 1. The summary of the grain size (μm) measured after laser irradiation of a-Si films using various irradiation parameters.