An estimation of friction from the indentation of metals by acute-angled conical indenters

Tribology International

Volumn 40, Issue 10-12 SPEC. ISS., 2007, Pages 1479-1483

  Kojima, Yasushi ^a   Shima, Masayuki ^a   Motoda, Tomohiro ^a   Jibiki, Tatsuhiro ^a   Sugawara, Takashi ^a  

^a TOKYO UNIVERSITY OF MARINE SCIENCE AND TECHNOLOGY   (Japan)

Author keywords

Acute angled indenter; Estimation of coefficient of friction; Indentation; Projected area

Indexed keywords

ANGLE MEASUREMENT; HARDNESS TESTING; INDENTATION; SURFACE PHENOMENA;

ACUTE ANGLED INDENTERS; FRICTION TESTERS; SLIDING SURFACES;

FRICTION;

EID: 34548150615     PISSN: 0301679X     EISSN: None     Source Type: Journal    
DOI: 10.1016/j.triboint.2007.01.013     Document Type: Article

References (8)

1. Tabor D. The hardness of metals (1951), Clarendon Press, Oxford 42pp
2. Johonson K.L. Contact mechanics (1985), Cambridge University Press, Cambridge p. 171-9
3. Motoda T, Shima M, Sasaki S. Development of a new system for measuring elastic modulus of wear resistant film based on contact deformation of coated flat and spherical indenter. Allerton Press, Inc. Jpn J Tribol 2003; 48(3): 321-32.
4. Motoda T, Jibiki T, Shima M. Effect of surface roughness on Hertzian contact deformation. Allerton Press, Inc. Jpn J Tribol 2004; 49(2): 163-75.
5. Shima M, Motoda T, Jibiki T, Sugawara T. New apparatus for measuring elastic modulus based on elastic contact deformation of sphere and flat. Allerton Press, Inc. Jpn J Tribol 2002; 47(4): 349-59.
6. Shima M, Motoda T, Jibiki T, Sasaki S, Miyake K. Measuring yield strength of metals using the identation method. Allerton Press, Inc. Jpn J Tribol 2005; 50(2): 299-309.
7. Kojima Y., Shima M., Motoda T., Jibiki T., and Sasaki S. Measurements of adhesion between sharp diamond indenters and metals under engineering conditions. J Jpn Soc Tribologists 51 2 (2006) 172-179
8. Hankins G.A. Proc Inst Mech Engrs 1 (1925) 611