Towards a complete population balance model for fluidized-bed spray agglomeration

Drying Technology

Volumn 25, Issue 7-8, 2007, Pages 1321-1329

  Peglow, M ^a   Kumar, J ^a   Hampel, R ^a   Tsotsas, E ^a   Heinrich, S ^a  

^a OTTO VON GUERICKE UNIVERSITY   (Germany)

Author keywords

Agglomeration; Drying; Fluidized bed; Population balance

Indexed keywords

COMPUTER SIMULATION; DISPERSIONS; DRYING; HEAT TRANSFER; MASS TRANSFER; MOISTURE; PARTICLE SIZE;

PARTICLE PHASE; POPULATION BALANCE;

AGGLOMERATION;

AGGLOMERATION; COMPUTER SIMULATION; DISPERSIONS; DRYING; HEAT TRANSFER; MASS TRANSFER; MOISTURE; PARTICLE SIZE;

EID: 34547670401     PISSN: 07373937     EISSN: 15322300     Source Type: Journal    
DOI: 10.1080/07373930701438899     Document Type: Article

References (20)

1. Watano, S., Fukushima, T. and Miyanami, K. (1996) Heat transfer and rate of granule growth in fluidized bed granulation. Chemical & Pharmaceutical Bulletin, 44, pp. 572-576.
2. Schaafsma, S. (2000) Down-Scaling of a Fluidised Bed Agglomeration Process, University of Groningen
3. Adetayo, A.A., Litster, J.D., Pratsinis, S.E. and Ennis, B.J. (1995) Population balance modelling of drum granulation of materials with wide size distribution. Powder Technology, 82, pp. 37-50.
4. Wang, F.Y. and Cameron, I.T.
5. Bramley, A.S., Hounslow, M.J. and Ryall, R.L. (1996) Aggregation during precipitation from solution: A method for extracting rates from experimental data. Journal of Colloid and Interface Science, 183, pp. 155-165.
6. Ding, A., Biggs, C.A. and Hounslow, M.J. (2006) Population balance model selection for activated sludge flocculation modelling. Chemical Engineering Science, 61, pp. 63-74.
7. Hounslow, M.J., Pearson, J.M.K. and Instone, T. (2001) Tracer studies of high shear granulation: II. Population balance modeling. AIChE Journal, 47, pp. 1984-1999.
8. Tan, H.S., Salman, A.D. and Hounslow, M.J. (2004) Kinetics of fluidised bed melt granulation, Part III: Tracer studies. Chemical Engineering Science, 144, pp. 65-83.
9. Tan, H.S., Salman, A.D. and Hounslow, M.J. (2005) Kinetics of fluidised bed melt granulation, Part IV: Selecting the breakage model. Powder Technology, 143, pp. 65-83.
10. Tan, H.S., Salman, A.D. and Hounslow, M.J. (2005) Kinetics of fluidised bed melt granulation, Part V: Simultaneous modelling of aggregation and breakage. Chemical Engineering Science, 60, pp. 3847-3866.
11. Saleh, M., Steinmetz, M. and Hemati, M. (2003) Experimental study and modeling of fluidized bed coating and agglomeration. Powder Technology, 130, pp. 116-123.
12. Hounslow, M.J., Ryall, R.L. and Marshall, V.R. (1988) A discretized population balance for nucleation, growth and aggregation. AIChE Journal, 38, pp. 1821-1832.
13. Peglow, M., Kumar, J., Warnecke, G., Heinrich, S., Tsotsas, E., Mörl, L. and Hounslow, M.J. (2006) Improved discretized tracer mass distribution of Hounslow et al. AIChE Journal, 52, pp. 1326-1332.
14. Heinrich, S. (2000) Modellierung des Wärme- und Stoffüberganges sowie der Partikelpopulation bei der Wirbelschicht-Sprühgranulation, Universität Magdeburg
15. Burgschweiger, J. (2000) Modellierung des statischen und dynamischen Verhaltens von kontinuierlich betriebenen Wirbelschichttrocknern, Universität Magdeburg
16. Groenewold, H. and Tsotsas, E. (1997) A new model for fluid bed drying. Drying Technology, 15, pp. 1687-1698.
17. Groenewold, H. and Tsotsas, E. (1999) Predicting Sherwood numbers in fluidized beds. Drying Technology, 17, pp. 1557-1570.
18. Tsotsas, E. (1994) From single particle to fluid bed drying kinetics. Drying Technology, 12, pp. 1401-1426.
19. Peglow, M. (2005) Beitrag zur Modellbildung eigenschaftsverteilter Feststoffsysteme am Beispiel der Wirbelschicht-Sprühagglomeration, Universität Magdeburg
20. Peglow, M., Kumar, J., Warnecke, G., Heinrich, S. and Mörl, L. (2006) A new technique to determine rate constants for growth and agglomeration with size and time dependent nuclei formation. Chemical Engineering Science, 61, pp. 282-292.