Comparison of magnetic Barkhausen noise and ultrasonic velocity measurements for microstructure evaluation of SAE 1040 and SAE 4140 steels

Materials Characterization

Volumn 58, Issue 5, 2007, Pages 447-454

  Gür, C Hakan ^a   Çam, Ibrahim ^a  

^a MIDDLE EAST TECHNICAL UNIVERSITY   (Turkey)

Author keywords

Magnetic Barkhausen noise; Microstructure; Sound velocity; Steel

Indexed keywords

ACOUSTIC WAVE VELOCITY; MARTENSITE; MICROSTRUCTURAL EVOLUTION; MICROSTRUCTURE; SCANNING ELECTRON MICROSCOPY; ULTRASONIC VELOCITY MEASUREMENT;

MAGNETIC BARKHAUSEN NOISE; PULSE-ECHO TECHNIQUES;

STEEL;

EID: 33947700335     PISSN: 10445803     EISSN: None     Source Type: Journal    
DOI: 10.1016/j.matchar.2006.06.008     Document Type: Article

References (26)

1. Gaunt P. Magnetic coercivity. Can J Phys 65 (1987) 1194-1199
2. Williams H.J., Bozorth R.M., and Shockley W. Magnetic domain patterns on single crystal of silicon iron. Phys Rev 75 (1949) 155-163
3. Parakka A.P., Jiles D.C., Gupta H., and Zang M. Barkhausen effect in steels and its dependence on surface condition. J Appl Phys 81 (1997) 5085-5086
4. Gatelier-Rothea C., Chicois J., Fougeres R., and Fleischmann P. Characterization of pure iron and (130 p.p.m.) carbon-iron binary alloy by Barkhausen noise measurements: study of the influence of stress and microstructure. Acta Mater 46 (1998) 4873-4882
5. Anglada-Rivera J., Padovese L.R., and Capo-Sanchez J. Magnetic Barkhausen noise and hysteresis loop in commercial carbon steel: influence of applied tensile stress and grain size. JMMM 231 (2001) 299-306
6. Yamaura S., Furuya Y., and Watanabe T. The effect of grain boundary microstructure on Barkhausen noise in ferromagnetic materials. Acta Mater 49 (2001) 3019-3027
7. Clapham L., Jagadish C., and Atherton D.L. The influence of pearlite on Barkhausen noise generation in plain carbon steels. Acta Metall Mater 39 (1991) 1555-1562
8. Koo K.M., Yau M.Y., Dickon H.L.Ng., and Lo C.C.H. Characterization of pearlite grains in plain carbon steel by Barkhausen emission. Mater Sci Eng A A351 (2003) 310-315
9. Mitra A., Govindaraju M.R., and Jiles D.C. Ferromagnetic properties of deformation-induced martensite transformation in AISI 304 stainless steel. IEEE Trans Magn 31 (1995) 4053-4055
10. Moorthy V., Vaidyanathan S., Raj B., Jayakumar T., and Kashyap B.P. Insight into the microstructural characterization of ferritic steels using micromagnetic parameters. Metall Mater Trans A 31A (2000) 1053-1065
11. Saquet O., Chicois J., and Vincent A. BN from plain carbon steel: influence of the microstructure. Mater Sci Eng A A269 (1999) 73-82
12. Moorthy V., Shaw B.A., and Evans J.T. Evaluation of tempering induced changes in the hardness profile of case-carburised EN36 steel using magnetic Barkhausen noise analysis. NDT E Int 36 (2003) 43-49
13. Kleber X., Hug A., Merlin J., and Soler M. Ferrite-martensite steels characterization using magnetic Barkhausen noise measurements. ISIJ Int 44 (2004) 1033-1039
14. Gupta H., Zhang M., and Parakka A.P. Barkhausen effect in ground steels. Acta Mater 45 (1997) 1917-1921
15. Yoshino M, Tanabe H, Sakamoto T, Suzuki N, Yaji Y. Nondestructive measurement of grain size in steel plates by using magnetic coercive force. Mater Sci Forum, 1996, 210-213, 45-54.
16. Dhar A., and Atherton D.L. Influence of magnetizing parameters on the magnetic Barkhausen noise. IEEE Trans Magn 28 (1992) 3363-3366
17. Meszaros I, Kaldor M, Hidasi B. Barkhausen noise energy measurement method for characterizing the ferromagnetic ratio of alloys. Mater Sci Forum 1996; 210-213:31-38.
18. Papadakis E.P. Ultrasonic attenuation and velocity in AISI/SAE 52100 steel quenched from various temperatures. Metall Trans 1 (1970) 1053-1057
19. Murav'ev V.V. Interrelationship of the velocity of an ultrasonic wave in steels and their heat treat cycles (1989), Plenum Publishing Corp. 135-137
20. Prasad R., and Kumar S. An investigation into the ultrasonic behavior of cast and heat-treated structures in steel. Insight-Br J NDT 33 (1991) 506-508
21. Gür C.H., and Kele° Y. Ultrasonic characterization of hot-rolled and heat-treated plain carbon steels. Insight-Br J NDT 45 (2003) 615-620
22. Bouda B.A., Benchaala A., and Alem K. Ultrasonic characterization of material hardness. Ultrasonics 38 (2000) 224-227
23. Gür C.H., and Tuncer B.O. Characterization of microstructural phases of steels by sound velocity measurement. Mater Charact 55 (2005) 160-166
24. Hetherington M.G., Jacubovics J.P., Szpunar J., and Tanner B.K. High-voltage Lorentz electron-microscopy studies of domain-structures and magnetization processes in pearlitic steels. Phila Mag B56 (1987) 561-577
25. Prasad R., and Kumar S. Study of the influence of deformation and thermal treatment on the ultrasonic behavior of steel. J Mater Process Technol 42 (1994) 51-59
26. Palanichamy P., Vasudevan M., Jayakumar T., Venugopal S., and Raj B. Ultrasonic velocity measurements for characterizing the annealing behaviour of cold worked austenitic stainless steel. NDT E Int 33 (2000) 253-259