Saturated flow boiling heat transfer of refrigerant R-410A in a horizontal annular finned duct

International Journal of Heat and Mass Transfer

Volumn 50, Issue 7-8, 2007, Pages 1442-1454

  Hsieh, Y Y ^a   Lie, Y M ^b   Lin, T F ^b  

^a NAN KAI UNIVERSITY OF TECHNOLOGY   (Taiwan)

^b NATIONAL CHIAO TUNG UNIVERSITY   (Taiwan)

Author keywords

[No Author keywords available]

Indexed keywords

BUBBLES (IN FLUIDS); CHANNEL FLOW; FLOW VISUALIZATION; HEAT TRANSFER COEFFICIENTS; NUCLEATE BOILING; REFRIGERANTS;

BOILING HYSTERESIS; FLOW PHOTOS; SATURATED FLOW;

HEAT TRANSFER;

BUBBLES (IN FLUIDS); CHANNEL FLOW; FLOW VISUALIZATION; HEAT TRANSFER; HEAT TRANSFER COEFFICIENTS; NUCLEATE BOILING; REFRIGERANTS;

EID: 33846936242     PISSN: 00179310     EISSN: None     Source Type: Journal    
DOI: 10.1016/j.ijheatmasstransfer.2006.09.009     Document Type: Article

References (18)

1. Thome J.R. Boiling of new refrigerants: a state-of-the art review. Int. J. Refrig. 19 (1996) 435-457
2. Sami S.M., and Poirier B. Comparative study of heat transfer characteristics of new alternatives to R-22. ASHRAE Trans. 120 (1997) 824-829
3. Sami S.M., and Poirier B. Two phase flow heat transfer of binary mixtures inside enhanced surface tubing. Int. Common. Heat Mass Transfer 25 (1998) 763-773
4. Wang C.C., Shieh W.Y., and Chang Y.J. Nucleate boiling performance of R-22, R-123, R-134a, R-410A and R407C on smooth enhanced tubes. ASHRAE Trans. 121 (1998) 1314-1321
5. Wang C.C., Yu J.G., Shieh P.L., and Lu D.C. An experimental study of convective boiling of refrigerants R-22 and R-410A. ASHRAE Trans. 121 (1998) 1144-1150
6. Ebisu T., and Torikoshi K. Heat transfer characteristics and correlations for R-410A flowing inside a horizontal smooth tube. ASHRAE Trans. 121 (1998) 556-561
7. Wijaya H., and Spatz M.W. Two-phase flow heat transfer and pressure drop characteristics of R-22 and R-32/R125. ASHRAE Trans. 118 (1995) 1020-1027
8. Shen J., Spindler K., and Hahne E. Pool boiling heat transfer of refrigerant mixtures R-32/125. Int. Comm. Heat Mass Transfer 26 (1999) 1091-1102
9. Chang Y.J., Chiang S.K., Chung T.W., and Wang C.C. Two-phase frictional characteristics of R-410A and air-water in a 5 mm smooth tube. ASHRAE Trans. 123 (2000) 792-797
10. Chitti M.S., and Anand N.K. Condensation heat transfer inside smooth horizontal tube for R-22 and R-32/R-125 mixture. HVAC&R Res. 2 (1996) 79-103
11. Hsieh Y.Y., and Lin T.F. Saturated flow boiling heat transfer and pressure drop of refrigerant R-410A in a vertical plate heat exchanger. Int. J. Heat Mass Transfer 45 (2002) 1033-1044
12. Chen J.C. A correlation for boiling heat transfer to saturated fluids in convective flow. Ind. Eng. Chem. Proc. Des. Dev. 5 (1966) 322-329
13. Gungor K.E., and Winterton R.H.S. A general correlation for flow boiling in tubes and annuli. Int. J. Heat Mass Transfer 29 (1986) 351-358
14. Kandlikar S.G. A general correlation for saturated two-phase flow boiling heat transfer inside horizontal and vertical tubes. ASME J. Heat Transfer 112 (1990) 219-228
15. Liu Z., and Winterton R.H.S. A general correlation for saturated and subcooled flow boiling in tubes and annuli, based on a nucleate pool boiling equation. Int. J. Heat Mass Transfer 34 (1991) 2759-2766
16. Yin C.P., Yan Y.Y., Lin T.F., and Yang B.C. Subcooled flow boiling heat transfer of R-134a and bubble characteristics in a horizontal annular duct. Int. J. Heat Mass Transfer 43 (2000) 1885-1896
17. Kline S.J., and McClintock F.A. Describing uncertainties in single-sample experiments. Mech. Eng. 75 1 (1953) 3-12
18. C.H. Chen, Experimental of flow boiling and evaporation heat transfer of R-410A and bubble characteristics in horizontal annular duct, MS. thesis, National Chaio Tung university, Hsinchu, Taiwan, ROC, 2001.