Interactive feature modeling for reverse engineering

Journal of Computing and Information Science in Engineering

Volumn 6, Issue 4, 2006, Pages 422-424

  Schreve, K ^a   Goussard, C L ^a   Basson, A H ^a   Dimitrov, D ^a  

^a STELLENBOSCH UNIVERSITY   (South Africa)

Author keywords

Draft angle; Edge detection; Feature extraction; Reverse engineering

Indexed keywords

ANGLE MEASUREMENT; EDGE DETECTION; FEATURE EXTRACTION; INTERACTIVE COMPUTER SYSTEMS; MATHEMATICAL MODELS;

DRAFT ANGLE; MODELING TOOLS; POINT DATA;

REVERSE ENGINEERING;

EID: 33845682904     PISSN: 15309827     EISSN: None     Source Type: Journal    
DOI: 10.1115/1.2364205     Document Type: Article

References (7)

1. Thompson, W. B., Owen, J. C., De St. Germain, H. J., Stark, S. R., and Henderson, T. C., 1999, "Feature-Based Reverse Engineering of Mechanical Parts, IEEE Trans. Rob. Autom., 15(1), pp. 57-66.
2. Schreve, K., 2001, "Edge Scanning and Swept Surface Approximation in Reverse Engineering," Ph.D. thesis, University of Stellenbosch, Stellenbosch, South Africa.
3. Goussard, C. L., 2001, "Semi-Automatic Extraction of Primitive Geometric Entities From Point Clouds," Masters thesis, University of Stellenbosch, Stellenbosch, South Africa.
4. Schreve, K., 2005, "Fitting B-Splines With Draft Angle to Scanned Data," 2nd International Conference on Advanced Research in Virtual and Rapid Proto-typing, September 28-October 1, Leiria, Portugal, pp. 269-275.
5. Vörös, J., 2000, "A Strategy for Repetitive Neighbour Finding in Octree Representations," Interface (USA), 18, pp. 1085-1091.
6. Langerak, T. R., Vergeest, J. S. M., and Song, Y., 2005, "Recognising and Editing Styling Lines in Free Form Shapes," The 6th International Conference on Computer-Aided Industrial Design & Conceptual Design, May 29-June 1, Delft, The Netherlands, pp. 739-743.
7. Ueng, W.-D., Lai, J.-Y., and Doong, J.-L., 1998, "Sweep-Surface Reconstruction From Three-Dimensional Measured Data," J. Am. Chem. Soc., 20(10), pp. 791-805.