Non - Laminar flow in hydrodynainic lubrication

Tribology Series

Volumn 31, Issue , 1996, Pages 319-333

  Frene J ^a   Constantinescu, V N ^a  

^a UNIVERSITÉ DE POITIERS   (France)

Author keywords

[No Author keywords available]

Indexed keywords

EID: 33751356918     PISSN: 01678922     EISSN: None     Source Type: Book Series    
DOI: 10.1016/s0167-8922(08)70794-6     Document Type: Article

References (46)

1. Buckholtz, R. H. (1987). The Effects of Lubricant Inertia Near the Leading Edge of a Plane Slider, Trans, of the ASME, Journ. of Tribology, 109, 60-64.
2. Capitao, J. W. (1974). Influence of Turbulence on Performance Characteristics of the Tilting-Pad Thrust Bearings, Trans. ASME, Journ. of Lubrication Technology, 96, 110-117.
3. Childs, D. (1993). Turbouiachinery Rotor Dynamics, John Wiley, New York.
4. Constantinescu, V. N. (1958). Influence of Turbulence on the Motion in the Lubricating Film (in Romanian), St. Cere. Mec. Api, 9, 103-137.
5. Constantinescu, V. N. (1959). On Turbulent Lubrication, Proc. Inst. Mech. Engs. London 173, 881-900.
6. Constantinescu, V. N. (1962). On High Speed Flow of Gases in thin Layers (in Romanian), St. Cere. Mec. Apl., 13, 383-400.
7. Constantinescu, V. N. (1967). On the Pressure Equation for Turbulent Lubrication, Proc. of the Conference on Lubrication and Wear, I. Mech. Engs, London, 132-134.
8. Constantinescu, V. N. (1968). Lubrication in Turbulent Regime, AEC-tr-6959, U.S. Atomic Energy Commission/Division of Technical Information, National Bureau of Standards, U.S. Department of Commerce, Springfield, Virginia 22151.
9. Constantinescu, V. N. (1969). Gas Lubrication, ASME Publications, New York.
10. Constantinescu, V. N. (1970). On the Influence of Inertia Forces in Turbulent and Laminar SelfActing Films, Trans. ASME, Journ. of Lubrication Technology, 92, 473-481.
11. Constantinescu, V. N., Pan, C. H. T. and Hsing, F. C. (1971). A Procedure for the Analysis of Bearings Operating in the Transition Range Between Laminar and Fully Developed Turbulent Flow, Rev. Roum. Sci. Techn. - Mec. Appl., 16, 945 -982.
12. Constantinescu, V. N. and Galetuse, S. (1974). On the Possibilities of Improving the Accuracy of the Evaluation of Inertia Forces in Laminar and Turbulent Films, Trans. ASME, Journ. of Lubrication Technology, 96, 69-79.
13. Constantinescu, V. N., Galetuse, S. and Kennedy, F. E. (1975). On the Comparison between Lubrication Theory Including Turbulence and Inertia Forces and some Existing Experimental Data, Trans. ASME, Journ. of Lubrication Technology, 97, 439-449.
14. Constantinescu, V. N. and Galetuse, S. (1976). Pressure Drop due to Inertia Forces in a Step Bearing, Trans. ASME, Journ. of Lubrication Technology, 98, 167-174.
15. Constantinescu, V. N., Nica, A., Pascovici, M. D., Ccptureanu, G. and Nedelcu, S. (1985). Sliding Bearings, Allerton Press, New York.
16. Constantinescu, V. N. (1987). Influence of Inertia Forces in Externally-Pressurized Journal Bearings Operating at Large Reynolds Numbers , Rev. Raum. Sci. Techn. - Serie Mec. Appl, Bucharest, 32, 625-638.
17. Constantinescu, V. N. (1988). On Entrance Conditions in Lubricating Films at Large Reynolds Numbers (in Romanian), St. Cere. Mec. Apl., 47, 369-376.
18. Constantinescu, V. N. (1995). Laminar Viscous Flow, Springer, New York.
19. Coustcix, J. (1988). Aerodynamics of Viscous Fluids; Turbulence and Boundary Layers (in French), ENSAE, France.
20. Danaila, S. (1995). A Turbulence k - s Model for Boundary Layer Flow (in Romanian), A. Cere. Mec. Apl., 54 (under press).
21. DiPrima, R. C. and Stuart, J. T. (1974). Development and Effects of Supercritical TaylorVortex Flow in a Lightly Loaded Journal Bearing, Trans. ASME, Journal of Lubrication Technology, 87,28-35.
22. EIrod, H. G. and Ng. C. W. (1967). A Theory for Turbulent Fluid Films and its Application to Bearings, Trans. ASME, Journ. of Lubrication Technology, 89, 346-362.
23. Frêne, J. (1970). Contract Report No. HC.061.E.750, Electricité de France.
24. Frêne, J. (1974). Non Laminar Flow Regimes in Thin Layers. Application to Sliding Bearings (in French), Ph. D. Thesis, Claude Bernard University, Lyon, France
25. Frêne, J. (1975) General Discussion on Thrust Bearings, Proc. Leed-Lyon Symposium on Superlaminar Flow in Bearings, 1. Mech. I., London, 166 - 167.
26. Frêne, J. and Constantinescu, V. N. (1975). Operating Characteristics of Journal Bearings in the Transition Regime, Leeds-Lyon Symp. on Superlaminar Flow in Bearings, I. Mech. E. Pub I., London, 121 -124.
27. Frêne, J., Nicolas, D., Deguerce, B., Berthe, D. and Godet, M. (1990), Hydrodynamic Lubrication (in French), Eyrolles, Paris.
28. Hirs, G. G. (1974). A Systematic Study of Turbulent Film Flow, Trans. ASME, Journ. of Lubrication Technology, 96, 118-126.
29. Ho, M. K. and Vohr, J. H. (1974). Application of the Energy Model of Turbulence to Calculation of Lubricant Flow, Trans. ASME, Journ. of Lubrication Technology, 96, 95-102.
30. Jones, W. P. and Launder, B. E. (1973). The Calculation of Low Reynolds Number Phenomena \vilh a Two-Equation Model of Turbulence, Intern. Journ. of Heat Transfer, 16, 1119-1130.
31. Kennedy, F. E., Constanlinescu, V. N. and Galetuse, S. (1975). A Numerical Method for Studying Inertia Effects in thin Film Lubrication, Proc. Leeds-Lyon Symp. on Superlaminar Flow in Bearings, I. Mech. Engs. Publ., London, 174-182.
32. King, K. F. and Taylor, C. M. (1975). Laminar and Turbulent Lubrication of the Finite Width Plane Inclined Slider Bearing Including a Consideration of Mean Convective Inertia Effects, Proc. LeedsLyon Symp. on Superlaminar Flow in Bearings, I. Mech. Engs. Publ., London, 144-149.
33. Ku, C. P. and Tichy, J. A. (1987). Application of the k - s Turbulence Model to Squeeze Film Dampers, Trans. ASME, Journ. ofTribology, 109, 164-168.
34. Launder, B. E. and Leschziner, M. A. (1975). An Efficient Numerical Scheme for the Prediction of Turbulent Flow in Thrust Bearings, Proc. LeedsLyon Symp. on Superlaminar Flow in Bearings, I. Mech. Engs. Publ., London, 137-143.
35. Lucas, V., Danaila, S., Bonncau, O. and Frêne, J. (1994). Roughness Influence on Turbulent Flow through Annular Seals, Trans. ASME, Journ. of Tribology, 116, 321-329.
36. Ng, C. W. and Pan, C. H. T. (1965). A Linearized Turbulent Lubrication Theory, Trans. ASME, Journ. of Basic Engineering, 87, 675-681.
37. Pan, C. H. T. (1974). Calculation of Pressure, Shear, and Flow in Lubricating Films for High Speed Bearings, Trans. ASME, Journal of Lubrication Technology, 96, 80 - 94.
38. Patel, V. C., Rodi, W. and Scheuerer, G. (1985). Turbulence Models for Near-Wall and Low Reynolds Numbers Flows, AIAA Journal, 23, 13081319.
39. Reynolds, 0. (1886). On the Theory of Lubrication and its Application to Mr. Beauchamp Tower's Experimental Determination of the Viscosity of Olive Oil, Phil. Trans. Roy. Soc. London, 177, part, 157-234.
40. Smith, M. I. and Fuller, D. D. (1956). Journal Bearing Operation at Superlaminar Speeds, Trans. ASME, 78, 469-474.
41. Spalart, P. R. (1988). Direct Simulation of a Turbulent Boundary Layer up to Re 1410, Journ. of Fluid Mechanics, 187, 61-98.
42. Taylor, G. I. (1923). Stability of a Viscous Liquid Contained Between Two Rotating Cylinders, Phil. Trans. Roy. Soc. London, A223, 289 - 343.
43. Tipei, N. (1982) Flow and Pressure Head at the Inlet of a Narrow Passage without Upstream Free Surface, Trans. ASME, Journ. of Lubrication Technology, 104, 196-202.
44. Vohr, J. H. (1968). Experimental Study of Taylor Vortices and Turbulence in Flow Between Eccentric Rotating Cylinders, Trans. ASME, Journal of Lubrication Technology, 90, 285 - 296.
45. Wilcock, D. F. (1950). Turbulence in HighSpeed Journal Bearings, Trans. ASME, 72, 825-834.
46. Wilcox, D. C. (1993). Comparison of TwoEquation Turbulence Models for Boundary Layers wuh Pressure Gradient, AIAA Journal, 31, 14141421.