Evaluation of wall slip effects in the lubricating grease/air two-phase flow along pipelines

Journal of Non-Newtonian Fluid Mechanics

Volumn 139, Issue 3, 2006, Pages 190-196

  Ruiz Viera, M J ^a   Delgado, M A ^a   Franco, J M ^a   Gallegos, C ^a  

^a UNIVERSITY OF HUELVA   (Spain)

Author keywords

Lubricating grease; Non Newtonian fluid; Relative roughness; Two phase flow; Wall slip

Indexed keywords

NON NEWTONIAN LIQUIDS; PIPELINES; PRESSURE DROP; SHEAR FLOW; SURFACE ROUGHNESS; TWO PHASE FLOW;

RELATIVE ROUGHNESS; WALL SLIP;

LUBRICATING GREASES;

LUBRICATING GREASES; NON NEWTONIAN LIQUIDS; PIPELINES; PRESSURE DROP; SHEAR FLOW; SURFACE ROUGHNESS; TWO PHASE FLOW;

EID: 33751160838     PISSN: 03770257     EISSN: None     Source Type: Journal    
DOI: 10.1016/j.jnnfm.2006.08.007     Document Type: Article

References (22)

1. NLGI, National Lubricating Grease Institute, Lubricating Greases Guide, Kansas, 1994.
2. Pawlow W.P., Winogradow G.W., Sinizyn W.W., and Deinega J.F. Viskose eigenschaften von plastisch dispersen systemen. Rheol. Acta 1 (1961) 470-490
3. Pawlow W.P., and Winogradow G.W. Generalized characteristics of rheological properties of greases. Lubr. Eng. 21 (1965) 479
4. Delgado M.A., Franco J.M., Partal P., and Gallegos C. Experimental study of grease flow in pipelines: wall slip and air entrainment effects. Chem. Eng. Process. 44 (2005) 805-817
5. Mas R., and Magnin A. Rheology of colloidal suspensions: case of lubricating greases. J. Rheol. 38 (1994) 889-908
6. Balan C., and Franco J.M. Influence of the geometry on the transient and steady flow of lubricating greases. Tribol. Trans. 44 (2001) 53-58
7. Barnes H.A. A review of the slip (wall depletion) of polymer solutions, emulsions and particle suspensions in viscometers: its cause, character and cure. J. Non-Newtonian Fluid Mech. 56 (1995) 221-241
8. Britton M.M., and Callaghan P.T. Nuclear magnetic resonance visualization of anomalous flow cone-and-plate rheometry. J. Rheol. 41 (1997) 1365-1386
9. Mooney M. Explicit formulations for slip and fluidity. J. Rheol. 2 (1931) 210-223
10. Oldroyd J.G. The interpretation of observed pressure gradients in laminar flow of non-Newtonian liquids through tubes. J. Colloid Interf. Sci. 4 (1949) 333-342
11. Jastrzebski Z.D. Entrance effects and wall effects in an extrusion rheometer during the flow of concentrated suspensions. Ind. Eng. Chem. Fund. 6 (1967) 445-454
12. Yoshimura A., and Prud'homme R.K. Wall-slip corrections for couette and parallel disk viscometers. J. Rheol. 32 (1988) 53-67
13. Sánchez M.C., Valencia C., Franco J.M., and Gallegos C. Wall slip phenomena in oil-in-water emulsions: effect of some structural parameters. J. Colloid Interf. Sci. 241 (2001) 226-232
14. Nickerson C., and Kornfield J. A novel 'cleat' geometry for suppressing wall slip. J. Rheol. 49 (2005) 865-874
15. Kalyon D.M. Comments on the use of rheometers with rough surfaces or surfaces with protrusions. J. Rheol. 49 (2005) 1153-1155
16. Buscall R., McGowan J.I., and Morton-Jones A.J. The rheology of concentrated dispersions of weakly attracting colloidal particles with and without wall slip. J. Rheol. 37 (1993) 621-641
17. Ruiz-Viera M.J., Delgado M.A., Franco J.M., Sánchez M.C., and Gallegos C. On the drag reduction for the two-phase horizontal pipe flow of highly viscous non-Newtonian liquid/air mixtures: case of lubricating grease. Int. J. Multiphase Flow 32 (2006) 232-247
18. Chisholm D., and Laird A.D.K. Two-phase flow in rough tubes. Trans. ASME 80 (1958) 276-286
19. Holland F.A., and Bragg R. Fluid Flow for Chemical Engineers (1995), Edward Arnold, London
20. Heywood N.I., and Richardson J.F. Head loss by gas injection for highly shear-thinning suspensions in horizontal pipe flow. Proceedings of the Fifth International Conference on the Hydraulic Transport of Solids in Pipes (1978) (Paper C1)
21. Yilmazer U., and Kalyon D.M. Slip effects in capillary and parallel disk torsional flows of highly filled suspensions. J. Rheol. 33 (1989) 1197-1212
22. Kokini J.L., and Dervisoglu M. Wall effects in the laminar pipe flow of four semi-solid foods. J. Food Eng. 11 (1990) 29-42