Powder injection molding: A comparison of two debinding procedures based on solvent extraction

Materials Science Forum

Volumn 299-300, Issue , 1999, Pages 448-456

  Justino, J G ^a   De Resende, L M ^a   Fredel, M C ^a   Wendhausen, P A P ^a   Da Cunha Neto, J A B ^a   Ristow Jr , K W ^b   Klein, A N ^a  

^a FEDERAL UNIVERSITY OF SANTA CATARINA   (Brazil)

^b Steelinject SA   (Brazil)

Author keywords

Debinding; Powder Injection Molding; Sintered Materials

Indexed keywords

EID: 33750847964     PISSN: 02555476     EISSN: 16629752     Source Type: Book Series    
DOI: None     Document Type: Article

References (7)

1. P. U. Gummeson, The Metal Injection Molding Opportunity-A Critical View. Int. J. Powder Metal. 25, 3 (1989)
2. R. M. German, R. G. Cornwall, PMI, 33, 4 (1997) p. 23-27.
3. S. T. Lin, R. M. German, Powder Metal. Int. 21, 5 (1989).
4. K. S. Hwang, Y. M. Hsieh, Metal. and Mat. Trans. 27 A, (1996) p. 245-253.
5. J. Ebenhoch, P. Trübenbach, D. Weinand, Process Parameters for a Fast Catalytic Debinding System. In: Powder Injection Molding Symposium. Metal Powder Industries. 1992. p. 385-392.
6. M-Jeng Yang et al. Advances in Powder Metallurgy & Particulate Materials. Ed. by T. M. Cadle and K. S. Narasimhan. Vol. 5. 1996. Cap. 19. p. 225-232.
7. F. Thümmller, R. Oberacker, Introduction to Powder Metallurgy. Ed. by I. Jenkins and J.V. Wood. 1993.