Dynamic response of an alternative tissue simulant, physically associating gels (PAG)

Proceedings of the 2006 SEM Annual Conference and Exposition on Experimental and Applied Mechanics 2006

Volumn 1, Issue , 2006, Pages 304-310

  Moy, Paul ^a   Weerasooriya, Tusit ^a   Juliano, Thomas F ^a   VanLandingham, Mark R ^a   Chen, Wayne ^b  

^a U S ARMY RESEARCH LABORATORY   (United States)

^b PURDUE UNIVERSITY   (United States)

Author keywords

[No Author keywords available]

Indexed keywords

BALLISTIC GELATIN; ENVIRONMENTAL STABILITY; PHYSICALLY ASSOCIATING GELS (PAG); VISCOELASTIC PROPERTIES;

BALLISTICS; FAILURE ANALYSIS; GELATION; GUNS (ARMAMENT); STRAIN RATE; STRESSES; VISCOELASTICITY;

GELS;

EID: 33750364797     PISSN: None     EISSN: None     Source Type: Conference Proceeding    
DOI: None     Document Type: Conference Paper

References (18)

1. Nicolas, N. C. and Welsch, J. R. Ballistic Gelatin, Institute for Non-Lethal Defense Technologies Report, The Pennsylvania State University Applied Research Laboratory. 2004.
2. MacPherson, D. Bullet Penetration: Modeling the Dynamics and the Incapacitation Resulting from Wound Trauma. Ballistic Publications. 1994.
3. Kolsky, H. An Investigation of the Mechanical Properties of Materials at Very High Rates of Loading. Proc. Roy. Soc. London, B62, pp. 676-700. 1949.
4. Weerasooriya, T. Deformation Behavior of 93W-5Ni-2Fe at Different Rates of Compression Loading and Temperatures. Army Research Laboratory Technical Report. ARL-TR-1719. 1998.
5. Green, J., and Moy, P. Large Strain Compression of Two Tungsten Alloys at Various Strain Rates. Materials Technology Technical Report. MTL-TR-92-66. 1992.
6. 4 in/in/sec. Transactions of ASME, Journal of Applied Mechanics, pp. 496-504. 1966.
7. Chou, S. C., Robertson, K. D., Rainey, J. H. The Effect of Strain Rate and Heat Developed During Deformation on the Stress-Strain Curve of Plastics. Experimental Mechanics, Vol. 13, pp. 422-432. 1973.
8. Briscoe, B. J., Nosker, R. W. The Flow Stress of High Density Polyethylene at High Rates of Strain. Polymer Communications, 26, pp. 307-308. 1985.
9. Moy, P., Weerasooriya, T., Chen, W., and Hsieh, A. Dynamic Stress-Strain Response and Failure Behavior of PMMA. Proc. 2003 ASME IMECE. 2003.
10. Moy, P., Weerasooriya, T., Chen, W., and Hsieh, A. Strain Rate Response of Polycarbonate under Uniaxial Compression. Proc. 2003 SEM Annual Conference. 2003.
11. Chen, W., Zhang, B., Forrestal, M. J. A Split Hopkinson Bar Technique for Low-Impedance Materials. Experimental Mechanics, 39, pp. 81-85. 1999.
12. Chen, W., Lu, F., Cheng, M. Tension and Compression Tests of Two Polymers under Quasi-Static and Dynamic Loading. Polymer Testing, 21, pp. 113-121. 2002.
13. Meyers, M. A. Dynamic Behavior of Materials. J. Wiley. 1994.
14. Gray, G. T. Classic Split-Hopkinson Pressure Bar Testing: In Mechanical Testing and Evaluation. American Society for Metals, Metals Handbook, Vol. 8, pp. 462-476. 2000.
15. Chen, W., Lu, F., Zhou, B. A Quartz-Crystal Embedded Split Hopkinson Pressure Bar for Soft Materials. Experimental Mechanics, 40, pp. 1-6. 2000.
16. Casem, D., Weerasooriya, T., and Moy, P. Acceleration Compensation of Quartz Transducers Embedded in a Split Hopkinson Pressure Bar. Proc. 2003 SEM Annual Conference. 2003.
17. Casem, D., Weerasooriya, T., and Moy, P. Inertial Effects of Quartz Force Transducers Embedded in a Split Hopkinson Pressure Bar. Journal of Experimental Mechanics. 2005.
18. Chen, W., Ge, Y., Song, B., and Weerasooriya, T. Characterization of Extra-Soft Materials under Dynamic Compression. Submitted to the Journal of Mechanics and Physics of Solids. 2006.