Enhanced pool boiling CHF in FC-72 from a modulated porous layer coating

Journal of Enhanced Heat Transfer

Volumn 13, Issue 2, 2006, Pages 175-184

  Ferjančic, Klemen ^a   Rajselj D ^a   Golobic I ^b  

^a MIKROIKS doo   (Slovenia)

^b UNIVERSITY OF LJUBLJANA   (Slovenia)

Author keywords

Coating; Critical heat flux; Enhancement; Experimental; Pool boiling

Indexed keywords

CRITICAL HEAT FLUX; ENHANCEMENT; EXPERIMENTAL; POOL BOILING;

COATINGS; COPPER; HEAT FLUX; SATURATION (MATERIALS COMPOSITION);

POROUS MATERIALS;

EID: 33749480509     PISSN: 10655131     EISSN: None     Source Type: Journal    
DOI: 10.1615/JEnhHeatTransf.v13.i2.60     Document Type: Conference Paper

References (16)

1. Arik, M. and Bar-Cohen, A. (2003) Effusivity-Based Correlation of Surface Property Effects in Pool Boiling CHF of Dielectric Liquids, Int. J. Heat Mass Transfer, Vol. 46, pp. 3755-3764.
2. Auracher, H. and Marquardt, W. (2004) Heat Transfer Characteristics and Mechanisms along Entire Boiling Curves under Steady-State and Transient Conditions, Int. J. Heat Fluid Flow, Vol. 25, pp. 223-242.
3. Chang, J. Y. and You, S. M. (1996) Heater Orientation Effects on Pool Boiling of Micro-Porous-Enhanced Surfaces in Saturated FC-72, ASME J. Heat Transfer, Vol. 118, pp. 937-943.
4. Chang, J. Y. and You, S. M. (1997) Enhanced Boiling Heat Transfer from Micro-Porous Surfaces: Effects of Coating Composition and Method, Int. J. Heat Mass Transfer, Vol. 40, pp. 4449-4460.
5. El-Genk, M. S. and Bostanci, H. (2003) Saturation Boiling of HFE-7100 from a Copper Surface, Simulating a Microelectronic Chip, Int. J. Heat Mass Transfer, Vol. 46, pp. 1841-1854.
6. Ferjancic, K. and Golobic, I. (2002) Surface Effects on Pool Boiling CHF, Exp. Thermal Fluid Sci., Vol. 25, pp. 565-571.
7. Golobic, I. and Bergles, A. E. (1997) Effects of Heater Side Factors on the Saturated Pool Boiling Critical Heat Flux, Exp. Thermal Fluid Sci., Vol. 15, pp. 43-51.
8. Honda, H. and Wei, J. J. (2004) Enhanced Boiling Heat Transfer from Electronic Components by Use of Surface Microstructures, Exp. Thermal Fluid Sei., Vol. 28, pp. 159-169.
9. Lienhard, J. H. and Dhir, V. K. (1973) Extended Hydrodynamic Theory of the Peek and Minimum Pool Boiling Heat Fluxes, NASA CR-2270.
10. Liter, S. G. and Kaviany, M. (2001) Pool-Boiling CHF Enhancement by Modulated Porous Layer Coating: Theory and Experiment, Int. J. Heat Mass Transfer, Vol. 44, pp. 4287-4311.
11. Rainey, K. N., You, S. M., and Lee, S. (2001) Effect of Heater Size and Orientation on Pool Boiling Heat Transfer from Microporous Coated Surface, Int. J. Heat Mass Transfer, Vol. 44, pp. 2589-2599.
12. Rainey, K. N., You, S. M., and Lee, S. (2003) Effect of Pressure, Subcooling, and Dissolved Gas on Pool Boiling Heat Transfer from Microporous, Square Pin-Finned Surfaces in FC-72, Int. J. Heat Mass Transfer, Vol. 46, pp. 23-35.
13. Thome, J. R. (1990) Enhanced Boiling Heat Transfer, Hemisphere Publishing, Washington.
14. Webb, L. R. (1994) Principles of Enhanced Heat Transfer, John Wiley & Sons, New York.
15. Wei, J. J. and Honda, H. (2003) Effects of Fin Geometry on Boiling Heat Transfer from Silicon Chips with Micro-Pin-Fins Immersed in FC-72, Int. J. Heat Mass Transfer, Vol. 46, pp. 4059-4070.
16. Zuber, N. (1959) Hydrodynamic Aspects of Boiling Heat Transfer, AEC Report no. AECU-4439, Physics and Mathematics.