Evaluation of high-speed end-milling dynamic stability through audio signal measurements

Journal of Materials Processing Technology

Volumn 179, Issue 1-3, 2006, Pages 133-138

  Weingaertner, Walter Lindolfo ^a   Schroeter, Rolf Bertrand ^a   Polli, Milton Luiz ^b   de Oliveira Gomes, Jefferson ^c  

^a FEDERAL UNIVERSITY OF SANTA CATARINA   (Brazil)

^b UNIVERSIDADE TECNOLÓGICA FEDERAL DO PARANÁ   (Brazil)

^c INSTITUTO TECNOLÓGICO DE AERONÁUTICA   (Brazil)

Author keywords

Chatter; High speed machining; Milling

Indexed keywords

COMPUTER SIMULATION; CUTTING; FAILURE ANALYSIS; MECHANICAL VARIABLES MEASUREMENT; NATURAL FREQUENCIES; VIBRATIONS (MECHANICAL);

CHATTER FREQUENCIES; HIGH-SPEED MACHINING; SIGNAL MEASUREMENTS; STABILITY EVALUATION;

MILLING (MACHINING);

EID: 33748605046     PISSN: 09240136     EISSN: None     Source Type: Journal    
DOI: 10.1016/j.jmatprotec.2006.03.075     Document Type: Article

References (9)

1. Crede C.E., and Harris C.M. Shock and Vibration Handbook. fourth ed. (1995), Mc Graw-Hill, New York p. 1456
2. Smith S., and Tlusty J. An overview of modeling and simulation of the milling process. J. Eng. Ind. Trans. ASME 113 (1991) 169-175
3. Altintas Y., and Budak E. Analytical prediction of stability lobes in milling. Ann. CIRP 44 1 (1995) 357-362
4. P.V. Bayly, T.L. Schmitz, G. Stepan, B.P. Mann, D.A. Peters, T. Insperger, Effects of radial immersion and cutting direction on chatter instability in end-milling, ASME International Mechanical Engineering Conference and Exhibition, New Orleans, Proceedings of IMECE 2002, New Orleans: ASME, 2002.
5. Jensen S.A., and Shin Y.C. Stability analysis in face milling operations. Part 2: experimental validation and influencing factors. J. Manuf. Sci. Eng. Trans. ASME 121 (1999) 606-614
6. Minis I., et al. Analysis of linear and nonlinear chatter in milling. Ann. CIRP 39 1 (1990) 459-462
7. Tlusty J., and Ismail F. Basic non-linearity in machining chatter. Ann. CIRP 30 1 (1981) 299-304
8. Delio T., Tlusty J., and Smith S. Use of audio signals for chatter detection and control. ASME J. Eng. Ind. 114 (1992) 146-157
9. Schmitz T., and Ziegert J. Examination of surface location error due to phasing of cutter vibrations. Precision Eng. 23 1 (1999) 51-62