Investigations on thermal fatigue of aluminum- and magnesium-alloy based composites

International Journal of Fatigue

Volumn 28, Issue 10 SPEC. ISS., 2006, Pages 1399-1405

  Huang, Y D ^a   Hort, N ^a   Dieringa, H ^a   Maier, P ^a   Kainer, K U ^a  

^a INSTITUTE OF MATERIALS RESEARCH   (Germany)

Author keywords

Heat treatment; Metal matrix composite; Microstructure; Thermal cycling; Thermal fatigue

Indexed keywords

ALUMINUM ALLOYS; COMPOSITE MATERIALS; DIMENSIONAL STABILITY; HARDNESS; HEAT TREATMENT; MAGNESIUM ALLOYS; MICROSTRUCTURE; THERMAL CYCLING; THERMAL EFFECTS;

ENGINE COMPONENTS; METAL MATRIX COMPOSITES; SERVICE CONDITIONS; THERMAL FATIGUE;

FATIGUE OF MATERIALS;

EID: 33745939468     PISSN: 01421123     EISSN: None     Source Type: Journal    
DOI: 10.1016/j.ijfatigue.2006.02.038     Document Type: Article

References (22)

1. Clyne T.W., and Withers P.J. An introduction to metal matrix composite (1993), Cambridge University Press, Cambridge
2. Kainer K.U. Metallische verbundwerkstoffe (2003), Wiley-VCH, Weinheim
3. Huang Y.D., Hort N., and Kainer K.U. Thermal behavior of short fiber reinforced AlSi12CuMgNi piston alloys. Composites Part A 35 2 (2004) 249-263
4. Patterson WG, Taya MA. Thermal cycling damage of SiC whisker/2124 aluminum. In: Harrigan Jr WC, Dhingra A., editors. Proceedings of the international conference on composite materials, vol. 5. San Diego; 1985. p. 53-66.
5. Bär J., Gudladt H.-J., Illy J., and Lendvai J. Influence of fiber reinforcement on the ageing behavior of an AlSi12CuMgNi alloy. Mater Sci Eng A248 (1998) 181-186
6. Vogelsang M., Arsenault R.J., and Fisher R.M. An in situ HVEM study of dislocation generation at Al/SiC interfaces in metal matrix composites. Metall Trans 17A 3 (1986) 379-389
7. Christman T., Needleman A., Nutt S., and Suresh S. On microstructural evolution and micromechanical modeling of deformation of a whisker-reinforced metal matrix composite. Mater Sci Eng A107 (1989) 49-61
8. Dutta I. Role of interfacial and matrix creep during thermal cycling of continuous fiber reinforced metal matrix composites. Acta Mater 48 (2000) 1055-1074
9. Chmelik F., Lukàc P., Kiehn J., Mordike B.L., Kainer K.U., and Langdon T.G. Characteristics of thermal cycling in a magnesium alloy composite. Mater Sci Eng A325 (2002) 320-323
10. 3(f) composites during thermal cycling. J Phys IV 6 C8 (1996) 735-738
11. Kiehn J., Kohler C., and Kainer K.U. Deformation of short-fiber-reinforced Mg alloys caused by thermally-induced stresses. Key Eng Mater 97-98 (1994) 37-41
12. Huang Y.D., Hort N., Dieringa H., and Kainer K.U. Analysis of instantaneous thermal expansion coefficient curve during thermal cycling in short fiber reinforced AlSi12CuMgNi composites. Compos Sci Technol 65 (2004) 137-147
13. Neite G., and Mielke S. Thermal expansion and dimensional stability of aluminum fiber reinforced aluminum alloys. Mater Sci Eng A148 (1991) 85-92
14. Henning W., Nette G., and Schmid E. Influence of heat-treatment on the fiber stability in reinforced Al-Si light-metal piston alloys. Metall 48 6 (1994) 451-454
15. Goni J., Munoz A., Viviente J.L., and Liceaga J.F. Fracture-analysis of the transition zone between unreinforced alloy and composite. Composites 24 7 (1993) 581-586
16. Dieringa H., Hort N., and Kainer K.U. Compression creep of short fiber reinforced magnesium alloy AE42. Kompozyty/Composites 3 7 (2003) 275-278
17. Powell B.R., Rezhets V., Balogh M.P., and Waldo R.A. Microstructure and creep behavior in AE42 magnesium die-casting alloy. JOM 54 8 (2002) 34-38
18. Sklenicka V., Svoboda M., Pahutova M., Kucharova K., and Langdon T.G. Microstructural processes in creep of an AZ 91 magnesium-based composite and its matrix alloy. Mater Sci Eng A 319 (2001) 741-745
19. 3-Mg metal matrix composites. Mater Sci Eng A 129 1 (1990) 135-145
20. Hort N, Huang YD, Kainer KU. Schädigungen in kurzfaserverstärken AlSi12CuMgNi hervorgerufen durch thermisches Zyklieren. In: Degischer HP, editors. 14th symposium Verbundwerkstoffe und Werkstoffverbunde. Wien, Östereich; July 2-4, 2003. p. 242-7.
21. Mitra S., Dutta I., and Hansen R.C. Thermal cycling studies of a cross-plied P100 graphite fiber-reinforced 6061 aluminum composite laminate. J Mater Sci 26 (1991) 6223-6230
22. w/Al composite. Scripta Mater 25 4 (1991) 805-810