Application of the inverse method to the estimation of heat flux and temperature on the external surface in laminar pipe flow

Applied Thermal Engineering

Volumn 26, Issue 14-15, 2006, Pages 1714-1724

  Chen, Cha'o Kuang ^a   Wu, Li Wen ^a   Yang, Yue Tzu ^a  

^a NATIONAL CHENG KUNG UNIVERSITY   (Taiwan)

Author keywords

Conduction; Convection; Heat transfer; Inverse method; Laminar pipe flow; Numerical method

Indexed keywords

INVERSE PROBLEMS; LAMINAR FLOW; MATRIX ALGEBRA; PIPE FLOW; THERMAL EFFECTS;

INVERSE METHOD; LAMINAR PIPE FLOW; NUMERICAL METHOD; TEMPERATURE MEASUREMENTS;

HEAT FLUX;

EID: 33646348986     PISSN: 13594311     EISSN: None     Source Type: Journal    
DOI: 10.1016/j.applthermaleng.2005.11.006     Document Type: Article

References (20)

1. E.K. Zariffeh, H.M. Soliman, A.C. Trupp, The combined effects of wall and fluid axial conduction on laminar heat transfer in circular tubes, in: Proc. 7th Int. Heat Transfer Conf., vol. 4, 1982, pp. 131-136.
2. Mori S., Sakakibara M., and Tanimoto A. Steady heat transfer to laminar flow in circular tube with conduction in the tube wall. Heat Transfer Jpn. Res. 3 2 (1974) 37-46
3. Faghri M., and Sparrow E.M. Simultaneous wall and fluid axial conduction in laminar pipe-flow heat transfer. ASME J. Heat Transfer 102 (1980) 58-63
4. Campo A., and Schuler C. Heat transfer in laminar flow through circular tubes accounting for two-dimensional wall conduction. Int. J. Heat Mass Transfer 31 (1988) 2251-2259
5. Chen H.T., Lin S.Y., and Fang L.C. Estimation of surface temperature in two-dimensional inverse heat conduction problems. Int. J. Heat Mass Transfer 44 (2001) 1455-1463
6. Maillet D., Degiovanni A., and Pasquetti R. Inverse heat conduction applied to the measurement of heat transfer coefficient on a cylinder: comparison between an analytical and a boundary element technique. ASME J. Heat Transfer 113 (1991) 549-557
7. Martin T.J., and Dulikavich G.S. Inverse determination of steady heat convection coefficient distributions. ASME J. Heat Transfer 120 (1998) 328-334
8. Lin J.H., Chen C.K., and Yang Y.T. An inverse method for simultaneous estimation of the center and surface thermal behavior of a heated cylinder normal to a turbulent air stream. ASME J. Heat Transfer 124 (2002) 601-608
9. Kim S.K., and Lee W.I. An inverse method for estimating thermophysical properties of fluid flowing in a circular duct. Int. Comm. Heat Mass Transfer 29 8 (2002) 1029-1036
10. Sawaf B., Özisik M.N., and Jarny Y. An inverse analysis to estimate linearly temperature dependent thermal conductivity components and heat capacity of an orthotropic. Int. J. Heat Mass Transfer 38 16 (1995) 3005-3010
11. Su J., and Lopes A.B. Estimation of unknown wall heat flux in turbulent circular pipe flow. Int. Comm. Heat Mass Transfer 27 7 (2000) 945-954
12. Park H.M., and Lee J.H. A method of solving inverse convection problem by means of mode reduction. Chem. Eng. Sci. 53 9 (1998) 1731-1744
13. Bokar J.C., and Özisik M.N. An inverse analysis for estimating the time-varying inlet temperature in laminar flow inside a parallel plate duct. Int. J. Heat Mass Transfer 38 1 (1995) 39-45
14. Li H.-Y., and Yan W.-M. Identification of wall heat flux for turbulent forced convection by inverse analysis. Int. J. Heat Mass Transfer 46 (2003) 1041-1048
15. Kalman R.E. A new approach to linear filtering and prediction problems. Trans. ASME 82D (1990) 35-45
16. Pfahl Jr. R.C. Nonlinear least-squares: a method for simultaneous thermal property determination in ablating polymeric materials. J. Appl. Polym. Sci. 10 8 (1966) 1111-1119
17. Sorenson H.W. Parameter Estimation: Principles and Problems (1980), Marcel Dekker, New York
18. Yang C.Y. Noniterative solution of inverse heat conduction problems in one dimension. Commun. Numer. Meth. Eng. 13 6 (1997) 419-427
19. Beck J.V., Blackwell B., and St. Clair C.R. Inverse Heat Conduction-ill-posed Problem (1985), Wiley, New York
20. Tikhnov A.N., and Arsenin V.Y. Solution of Ill-posed Problems (1997), Winston and Sons, Washington, DC