Sintering behavior of 0.8 mol%-CuO-doped 3Y-TZP ceramics

Journal of the American Ceramic Society

Volumn 89, Issue 1, 2006, Pages 151-155

  Ran, Shen ^a   Winnubst, Louis ^a   Wiratha, Wika ^a   Blank, Dave H ^a  

^a UNIVERSITY OF TWENTE   (Netherlands)

Author keywords

[No Author keywords available]

Indexed keywords

MATHEMATICAL MODELS; PLASTICITY; POLYCRYSTALS; SINTERING; TRIBOLOGY; X RAY DIFFRACTION; ZIRCONIA;

3Y-TZP; SINTERING MODEL; YTTRIA-STABILIZED TETRAGONAL ZIRCONIA POLYCRYSTALS (3Y-TZP);

CERAMIC MATERIALS;

EID: 33645147344     PISSN: 00027820     EISSN: 15512916     Source Type: Journal    
DOI: 10.1111/j.1551-2916.2005.00679.x     Document Type: Conference Paper

References (23)

1. R. C. Garvie, R. H. J. Hannink, and R. T. Pascoe, "Ceramic Steel," Nature, 258, 703-4 (1975).
2. 3 Ceramics," J. Am. Ceram. Soc., 69 [8] 638-40 (1986).
3. 2 Polycrystals"; pp. 382-90 in Advances in Ceramics, Vol. 12, Science and Technology of Zirconia II, Edited by N. Claussen, M. Ruhle, and A. H. Heuer. The American Ceramic Society, Columbus, OH, 1984.
4. 2-Bearing Materials"; pp. 465-79 in Advances in Ceramics, Vol. 12, Science and Technology of Zirconia II, Edited by N. Claussen, M. Ruhle, and A. H. Heuer. The American Ceramic Society, Columbus, OH, 1984.
5. 3 Polycrystals," Adv. Ceram. Mater., 1, 259-63 (1986).
6. M. M. R. Boutz, A. J. A. Winnubst, F. Hartgers, and A. J. Burggraaf, "Effect of Additives on Densification and Deformation of Tetragonal Zirconia," J. Mater. Sci., 29, 5374-82 (1994).
7. 3-TZP by Low-Temperature Sintering"; pp. 183-91 in Advances in Ceramics, Vol. 24, Science and Technology of Zirconia III, Edited by S. Somiya, N. Yamamoto, and H. Yanagida. The American Ceramic Society, Columbus, OH, 1988.
8. S. Lawson, C. Gill, and G. P. Dransfield, "The Effects of Copper and Iron Oxide Additions on the Sintering and Properties of Y-TZP," J. Mater. Sci., 30 [12] 3057-60 (1995).
9. 3-Stabilized Tetragonal Zirconia Polycrystals," J. Am. Ceram. Soc., 73 [6] 1626-32 (1990).
10. 2 Composites," Wear, 256, 182-9 (2004).
11. H. R. Pasaribu, J. W. Sloetjes, and D. J. Schipper, "Friction Reduction by Adding Copper Oxide into Alumina and Zirconia Ceramics," Wear, 255 [1-6] 699-707 (2003).
12. J. R. Seidensticker and M. J. Mayo, "Thermal Analysis of 3-mol%-Yttria-Stabilized Tetragonal Zirconia Powder Doped with Copper Oxide," J. Am. Ceram. Soc., 79 [2] 401-6 (1996).
13. M. J. Mayo, J. R. Seidensticker, D. C. Hauge, and A. H. Carim, "Surface Chemistry Effects on the Processing and Superplastic Properties of Nanocrystalline Oxide Ceramics," Nanostruct. Mater., 11 [2] 271-82 (1999).
14. 2 System by X-Ray Diffraction," J. Am. Ceram. Soc., 67 [6] C119-21 (1984).
15. M. I. Mendelson, "Average Grain Size in Polycrystalline Ceramics," J. Am. Ceram. Soc., 52, 443-6 (1969).
16. L. Lemaire, S. M. Scholz, P. Bowen, J. Dutta, H. Hofmeister, and H. Hofmann, "Effect of CuO Additives on the Reversibility of Zirconia Crystalline Phase Transitions," J. Mater. Sci., 34, 2207-15 (1999).
17. 5 Dopants," Mater. Sci. Forum, 304-306, 465-70 (1999).
18. T. P. Raming, A. J. A. Winnubst, W. E. van Zyl, and H. Verweij, "Densification of Zireonia-Hematite Nanopowders," J. Eur. Ceram. Soc., 23 [7] 1053-60 (2003).
19. G. S. A. M. Theunissen, A. J. A. Winnubst, and A. J. Burggraaf, "Sintering Kinetics and Microstructure Development of Nanoscale Y-TZP Ceramics," J. Eur. Ceram. Soc., 11 [4] 315-24 (1993).
20. W. D. Kingery and B. Francois, "The Sintering of Crystalline Oxides, I. Interactions Between Grain Boundaries and Pores"; pp. 471-98 in Sintering and Related Phenomena, Edited by G. C. Kuczynski, N. A. Hooton, and C. F. Gibbon, Gordon Breach, New York, 1967.
21. 2O System in Air," J. Mater. Res., 6, 450-4 (1991).
22. 3 Ceramic System," J. Mater. Sci. Lett., 8 [1] 55-7 (1989).
23. A. J. Burggraaf, M. van Hemert, D. Scholten, and A. J. A. Winnubst, "Chemical Composition of Oxidic Interfaces in Relation with Electric and Electrochemical Properties"; pp. 797-802 in Reactivity of Solid, Edited by P. Barret and L. C. Dufour. Elsevier, Amsterdam, 1985.